AC POWER ADAPTER/CHARGER
ADAPTATEUR SECTEUR/CHARGEUR DE BATTERIE ADAPTADOR/CARGADOR DE CA
AA-V50U
INSTRUCTIONS
MANUEL D’INSTRUCTIONS MANUAL DE INSTRUCCIONES
For Customer Use:
Enter below the Model No. and Serial No. which is located on the bottom of cabinet. Retain this information for future reference.
Model No.
Serial No.
ESPAÑOL FRANÇAIS ENGLISH
LYT0388-001A
Thank you for purchasing the JVC AC Power Adapter/ Charger. This unit provides DC power for the JVC Digital Video Camera from a household AC outlet. It can be used to recharge the JVC battery pack for exclusive use with the JVC Digital Video Camera, and is capable of charging two battery packs consecutively. To avoid problems and obtain the best results, please read this instruction booklet carefully before use. Before using as a power adapter, make sure that this unit's model number is the same as that of the power supply unit specified in the instruction manual of the equipment you wish to power.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This unit should be used with AC 120V`, 60 Hz only in the USA and Canada. In other countries, this unit should be used with AC 110 – 240 V`,
50/60 Hz only.
CAUTION:
To prevent electric shocks and fire hazards, do NOT use any other power source.
NOTE:
The rating plate (Serial number plate) is on the bottom of the unit.
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
EN-2
USING HOUSEHOLD AC PLUG ADAPTER
In case of connecting attached Power Cord Plug to AC wall outlet other than American National Standard C73 series type, use an AC plug adapter, so called “Siemens Plug”, as shown below.
For this AC plug adapter, consult your nearest JVC dealer.
CAUTIONS:
•If used near a radio, this unit may interfere with reception.
•Prevent inflammables, water and metallic objects from entering the unit.
•Do not disassemble or modify the unit.
•Do not apply shocks to the unit.
•Do not subject the unit to direct sunlight.
•Avoid using the unit in extremely hot or humid places.
•Avoid using the unit in places subject to vibrations.
A WORD ON THE EXCLUSIVE BATTERY PACKS
The battery packs are lithium-ion.
Give attention to the following to make the most of their characteristics.
For charging: 10°C to 35°C (50°F to 95°F) For operating: 0°C to 40°C (50°F to 104°F) For storing: –10°C to 30°C (14°F to 86°F)
INFORMATION
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Change or modifications not approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
EN-3
CHARGING THE BATTERY PACK
You can charge one battery pack at a time, or two consecutively.
To AC outlet |
Power cord |
|
AC Power Adapter/
Charger AA-V50U
Charger indicator 1
Power lamp
Charger indicator 2
Battery pack
BN-V507U or
BN-V514U
1
DC OUT terminal
EN-4
1
2
3
SUPPLY POWER TO CHARGER
Make sure you unplug the camcorder’s DC cord from the AC Power Adapter/ Charger.
Plug the AC Adapter/Charger’s power cord into an AC outlet. The power lamp comes on.
ATTACH BATTERY/BATTERIES
Attach the battery pack while making sure its terminal side 1 is in contact with the indicator side of the battery pack mount on the AC Power Adapter/Charger.
•The Charger Indicator (1 or 2) begins blinking to indicate charging has started.
CONFIRM STATUS
When the charger indicator stops blinking but stays lit, charging is finished.
•If two batteries are attached to the charger, they will be charged in the order that they were attached.
4 DETACH BATTERY/BATTERIES
Slide the battery or batteries in the opposite direction of the arrow and lift off. Remember to unplug the AC Adapter/ Charger’s power cord from an AC outlet.
NOTE:
Perform charging where the temperature is between 10° and 35°C. (20°–25°C is the ideal temperature range for charging.) If the environment is too cold, charging may be incomplete.
BATTERY PACK CHARGING TIME
Battery pack |
ONE |
TWO |
|
|
|
|
|
BN-V507U |
approx. 1 hr. |
approx. 3 hrs.* |
|
30 min.* |
|||
|
|
||
|
|
|
|
BN-V514U |
approx. 3 hrs.* |
approx. 6 hrs.* |
|
|
|
|
*When charged at temperatures between 20° and 25°C.
•When charging Battery Packs after a long storage period, charging time will be longer than the time indicated above.
EN-5
SUPPLYING POWER
Power cord
To AC outlet 
AC Power |
|
Adapter/Charger |
To DC OUT |
AA-V50U |
|
|
terminal |
|
Core Filter |
|
DC cord |
To battery 
pack mount
Core Filter
You can connect the camcorder to an AC outlet using the AA-V50U AC Power Adapter/ Charger.
1 SUPPLY POWER TO ADAPTER
Plug the AC Adapter/Charger's power cord in to an AC outlet.
2 SUPPLY POWER TO CAMCORDER
Connect the AC Adapter to the camcorder.
NOTE:
The core filter reduces interference.
EN-6
Loading...