JENN-AIR JMC1150WS, AMC6158BAW, AMC6158BAS, AMC6158BAB, UCTK30WT Installation Instructions

MICROWAVE OVEN BUILT-IN TRIM KIT

INSTALLATION INSTRUCTIONS

Built-In Trim Kit Models UCTK27, UCTK30

UL listed for use over built-in electric ovens: 27 (68.6 cm): MEW5527, MEW6527

30 (76.2 cm): MEW5530, MEW6530, AEW3530, AEW4530, JJW8130DD, JJW8330DD, JJW9130DD, JJW9330DD

Table of Contents

MICROWAVE OVEN SAFETY ..................................................	1	Electrical Requirements ..........................................................	2
INSTALLATION INSTRUCTIONS.............................................	1	Microwave Oven Preparation .................................................	3
Tools and Parts ......................................................................	1	Bottom Duct Assembly...........................................................	3
Location Requirements ..........................................................	2	Microwave Oven Installation...................................................	4
Trim Kit Frame .......................................................................	2	Install Top and Bottom Brackets ............................................	4
Minimum Cutout Dimensions.................................................	2	Install Trim Kit Frame ..............................................................	4

MICROWAVE OVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean:

DANGER

WARNING

You can be killed or seriously injured if you don't immediately follow instructions.

You can be killed or seriously injured if you don't follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

INSTALLATION INSTRUCTIONS

Tools and Parts

Tools Needed

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

■	Measuring tape	■	Drill
■	Pencil	■	7/64" drill bit
■	Phillips screwdriver	■	Tape

Parts Supplied

Duct base		Bottom duct	Rear duct bracket
Aluminum tape		Rear duct	Upper duct
1	2
Templates 1 and 2		Top bracket	Bottom bracket
		13/16" screws	9/16" screws	1/2" screws
Trim kit frame		(2)	(16)	(4 - painted)

W10308504A

Location Requirements

The microwave oven may be installed over a built-in oven. If installing over a built-in oven, make sure there is a minimum of 3" (7.6 cm) between the top of the oven cutout and the microwave oven cutout floor.

The microwave oven may also be installed in a cabinet by itself (without a built-in oven below). For best usability, we recommend a minimum distance of 36" (91.4 cm) from the floor to the cutout floor.

Make sure the surrounding cabinetry has clearance to open and close freely. Allow a clearance of at least 1" (2.5 cm) below the cutout floor (3" [7.6 cm] for installation above a built-in oven), and a clearance of at least 2" (5.1 cm) above the cutout opening.

		A
	2"	2"
	(5.1 cm)	(5.1 cm)
	B	B
	1"	3"
	(2.5 cm)
		(7.6 cm)
		C
	D	36"
		(91.4 cm)
	E

A. Upper cabinet	D. Lower cabinets
B. Microwave oven cutout	E. Floor
C. Lower oven cutout

Trim Kit Frame Dimensions

	26		⁄"		(68.3		cm)*
	29	³⁄"
				(75.6
						cm)**

19¹⁄"

(48.6 cm)

24"	(61.0	cm)

1 ⁄" (3.7 cm)* 2⁄" (7.3 cm)**

⁄" (2.2 cm)

3" (7.6 cm)

*27" (68.6 cm) trim kit **30" (76.2 cm) trim kit

Minimum Cutout Dimensions

23³⁄"

(60.3 cm)

1⁄" (4.0 cm)

25" (63.5 cm)	A
16⁄"
(42.9 cm)

	¹¹⁄"
3"	(1.8 cm)
(7.6 cm)
	B

A.Trim kit frame overhang

B.Cutout for lower oven

NOTES:

■Height, width and depth measurements have ±1/16" (2 mm) tolerance.

■3" (7.6 cm) minimum dimension is from lower oven cutout ceiling to microwave oven cutout floor.

■Trim kit frame extends 11/16" (1.8 cm) below, and 1⁄" (4.0 cm) above the cutout opening.

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Observe all governing codes and ordinances.

Required:

■A 120 Volt, 60 Hz, AC only, 15or 20-amp electrical supply with a fuse or circuit breaker.

Recommended:

■A time-delay fuse or time-delay circuit breaker.

■A separate circuit serving only this microwave oven.

GROUNDING INSTRUCTIONS

■For all cord connected appliances:

The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.

SAVE THESE INSTRUCTIONS

Microwave Oven Preparation

1.Unplug microwave oven before proceeding with installation.

2.Remove any loose items inside microwave oven.

2