Jenn Air Ja480, Ja480p, Ja480n Owner's Manual

0 (0)
Jenn Air Ja480, Ja480p, Ja480n Owner's Manual

USER’S/ASSEMBLY MANUAL

for Model JA480 Gas Barbecue Grill

Use this manual in addition to manuals for Models J460/JA580. Some parts may look different; however, assembly is the same. For Step 9, follow instructions packed with the Side Burner kit.

50001741 02/03 Rev.0 En

Operation

Lighting the Rotisserie Burner (Model JA480)

The Rotisserie burner provides the steady, even heat required to cook poultry and roasts to self-basted perfection.

To start the Rotisserie burner:

1.Always open the Hood completely before attempting to light the Grill.

WARNING: Never stand with your head directly over the Grill when preparing to light the Rotisserie burner, to prevent possible bodily injury.

2.Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.

3.Turn on the propane gas supply valve at the tank (1 to 2 turns), or turn on the main natural gas supply valve.

4.Turn the Rotisserie Burner Control Knob to the HI position, by pushing down on the knob and turning it counterclockwise.

5.Immediately push the Igniter Button. The Rotisserie burner should light within four seconds.

WARNING: IF THE ROTISSERIE BURNER DOES NOT

LIGHT, to prevent gas buildup, immediately turn the burner control knob to the OFF position. Wait five (5) minutes for the gas to clear, then repeat steps 1 through 5 above. If the burner will not light when using the Igniter, follow the match lighting instructions below.

6. Confirm that the burner is properly lit and that the flame pattern is proper. For proper flame patterns, refer to Fig. 9a, Fig. 9b and Fig. 9c in the JA460/JA580 User Manual. If the flame pattern is other than normal, consult the Troubleshooting Guide for corrective action.

7. Always preheat the Grill before starting to cook on the rotisserie.

Rotisserie

Lighting Hole

Fig. 1

Page 2

Loading...
+ 4 hidden pages