JBL P-Kit, P-432, P-9632, P-9633, P-332 User Manual

...
0 (0)

Automotive Loudspeakers

P-432, P-532, P-632, P-9632, P-9633,

P-332, P-6432, P-7532, P-23t & P-Kit Owner’s Manual

GENUINE JBL

Thank you for purchasing JBL's Power Series™ automotive loudspeakers. In order that we may better serve you should you require warranty service on your new speakers, please retain your original purchase receipt and return the enclosed warranty registration card.

Important: Installation of automotive stereo components can require extensive experience performing a variety of mechanical and electrical procedures. Although these instructions explain in a general sense how to install Power Series loudspeakers, they may not show the exact installation methods for your particular vehicle. If you feel you lack the tools or necessary experience, ask your authorized JBL car-audio dealer about professional installation options.

Installation Warnings and Tips

Always wear protective eyewear when using tools.

Turn off all audio systems and other electrical devices before you start. Disconnect the negative (–) lead from your vehicle’s battery.

Keep speakers in their package until final installation. When moving a speaker, always rest it with the cone or dome facing up. Never use force to install any speaker.

Check clearances on both sides of a planned mounting surface before drilling any holes or installing any screws. Remember that the screws can extend behind the surface.

At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas.

Caution: In some cars, fuel tanks may be located directly beneath the rear deck. Check for adequate speaker-basket clearance before considering use of

this location!

Before drilling for the speakers or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit or saw.

For door installations, check the clearance with the windows in both closed and open positions and verify that a mounted speaker will not interfere with the window crank or power-window mechanism.

If mounting speakers near rear-deck torsion bars, glove box or other structural elements, check for clearance first.

Do not mount speakers where they will get wet.

Warning: Playing loud music in an automobile can permanently damage your hearing as well as hinder your ability to hear traffic. We recommend listening at low levels while in your car. JBL accepts no liability for hearing loss, bodily injury or property damage resulting from use or misuse of this product.

02

JBL P-Kit, P-432, P-9632, P-9633, P-332 User Manual

Installation of the P-332, P-6432 and P-7532, as shown in Figure 1.

Figure 1.

Installation of the P-432, P-532, P-9632 and P-9633, as shown in Figures 2 and 3.

Figure 2.

Figure 3.

Note: The P-332, P-6432 and P-7532 are designed as direct replacements for original-equipment speakers

mounted behind factory grilles.

Note: If you are mounting the P-532, P-9632 or P-9633 behind factory grilles, omit the grille and grille tray in Figure 2.

Note: Some installations may require some or all of the mounting ears to be removed from the P-432. Remove your original speakers first to determine whether any mounting ears must be removed.

03

Loading...
+ 5 hidden pages