Invacare top end pro 2 all sport Assembly Instructions Manual

Assembly Instructions

Invacare® Top End® Pro™-2 All Sport

Wheelchair

Part #: 1181409

Rev: A

Be sure to record your serial number and read the owners manual.

What you will receive

Box includes:

 Complete wheel assemblies
 Base frame
 Seat frame(assembled w/ side

guards, upholstery, cushion,
and frame protector)

 Footrest

 Axles
 Adjustable anti-tip assembly
 Positioning strap
 All attaching hardware.

Seat frame

Base Frame

Footrest

Hardware

Tools you will need:

 Adjustable wrench
 5mm allen wrench
 4mm allen wrench
 Two 10 mm combination wrenches or socket

 7/16 and ¾ inch wrench

 An assistant may also be helpful to hold frame in place while installing seat frame
 Entire assembly should take about 30-45 minutes

Step one – Adjusting and installing wheels

A. Adjust the nut on the axle receiver.

 The axle receiver nut will be loosely installed on the axle receiver bolt, this nut will need to be

tightened down with the adjustable wrench.

B. Adjust the nut on the actual axle so that the ball bearing locks into place when

put through the wheels and inserted into axle receiver.

A

B

Step two – Installing anti-tip

 Install adjustable anti-tip wheel.

A. Release and loosen the quick release lever attached to the anti-tip clamp
B. Insert adjustable anti-tip into base frame, with wheel facing down.
C. With rear wheels still on tighten quick release lever with anti-tip at level desired

(should be about a fingers width off the ground)

 Wheels can be taken off after this is done, which will prevent the chair from rolling around while

installing the other parts.

A

B

C