LAP TRAY
Assembly, Installation, and Operating Instructions
NOTE: Check all parts for shipping damages before using. In case of damage, do NOT use the equipment. Contact the Carrier/ Dealer for further instructions.
SAFETY SUMMARY
WARNING
DO NOT install this equipment without first reading and understanding this instruction sheet. If you are unable to understand these instructions, contact a healthcare professional, dealer or technical personnel if applicable before attempting to install this equipment - otherwise, injury or damage may occur.
INTRODUCTION
The Lap Trays are fully molded and designed to fit most wheelchairs. They feature a continuous lip along three (3) sides to prevent items from sliding off and is designed without comers or crevices which helps prevent the collection of food and dirt.
The Lap Trays are available in two (2) styles - Clear and Black. The clear trays are composed of a Thermal Polyester composition that allows surface scratches to be removed with a heat gun or hair dryer. The Black trays are made of ABS Plastic. Both styles are extremely durable.
The trays are available with or without a torso cutout.
INSTALLATION (FIGURE 1)
1.Remove Lap Tray/tray rails from packaged container.
2.Measure the distance (outside to outside) at the front and rear of armrest pads.
3.Subtract this measurement from the width of the Lap Tray. Refer to the example.
Example:
Width of Lap Tray |
24-inches |
Armrest Measurement |
- 20-inches (minus) |
|
- 4-inches |
4.Take the difference between the two (2) measurements and divide by 2.
Example: |
4-inches = 2 |
|
2 |
5.Measure the distance from the outside edge of the Lap Tray toward the inside of the tray rail using the distance measurement obtained in STEP 4. Perform this procedure for both sides of the Lap Tray.
6.Position tray rails with the mounting holes that are closesttotheoutsideofthetrayrailsattherearofthe tray.
7.Loosely secure the tray rails to the Lap Tray with the screws provided.
Difference between the width of the lap tray and the outside of the armrests divided by two.
The tray mounts firmly to the wheelchair by sliding onto the arm rests. The tray will mount on flat padded (SR - mounting hardware) or tubular (TR - mounting hard ware) arm rests.
NOTE: These mounting holes/ screws must be positioned at the rear of the lap tray.
Standard Rail
(Shown)
Desk Arm Pad
Pin Position
NOTE: These |
|
|
|
|
|
mounting holes/ |
|
|
screws must be |
|
|
positioned at the |
|
|
front of the lap |
|
Full Length Arm |
tray. |
|
|
|
Pad Pin Position |
|
|
|
REAR
Sling T-nuts
Mounting Screws
Sling T-nuts
Tray Rails
FRONT
Install Tray
FIGURE 1 - INSTALLATION
1
Loading...