Non-Removable Device
Assembly, Installation and Operating Instructions
Model No. 1820
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe installation of the non-removable device, these instructions
MUST be followed:
WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings, cautions and
instructions, contact a healthcare professional, dealer or technical personnel
if applicable, before attempting to install this equipment - otherwise, injury or
damage may occur.
Invacare products are specifically designed and manufactured for use in
conjunction with Invacare accessories. Accessories designed by other
manufacturers have not been tested by Invacare and are not recommended
for use with Invacare products.
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching component parts are secure.
Installing Non-Removable Device
NOTE: For this procedure, refer to FIGURE 1 on page 3.
1. Install front rigging onto the wheelchair.
CAUTION
It may be necessary to widen the opening of the clamp to prevent scratching
the wheelchair frame.
NOTE: There is a right clamp and a left clamp. Ensure that the clamp tab is at the bottom
of the clamp before installing.
2. Follow one of the following instructions:
• Footrest - Position the clamp between the two hinge plates of the footrest
(Detail “A”).
• Elevating Legrest - Position the clamp above the upper hinge plate of the
elevating legrest (Detail “B”).
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Part No 1076733 1 Non-Removable Device
3. Follow one of the following instructions:
• Footrest - Position the clamp tab over the lower hinge pin of the footrest
(Detail “A”).
• Elevating Legrest - Position the clamp tab over the upper hinge pin of the
elevating legrest (Detail “B”).
4. Squeeze the clamp together with pliers to secure around front frame tube.
NOTE: The clamp MUST be positioned on the front frame tube to allow the swingaway
front rigging to operate properly.
5. Install the lug bolt through the clamp from the inside of the wheelchair frame.
6. Install the locknut onto the lug bolt. Securely tighten.
7. Repeat STEPS 1 - 6 for the opposite side.
Non-Removable Device 2 Part No 1076733
DETAIL “A” - FOOTREST
Locknut
Clamp Tab
Lug Bolt
Lug Bolt
Clamp
Inside of
Wheelchair
Frame
Front Frame
Lower
Hinge Pin
Lower
Hinge Plate
DETAIL “B” - ELEVATING LEGREST
Inside of
Wheelchair
Frame
Front Frame
Tube
Tube
Upper
Hinge Plate
Swingaway
Front Rigging
Locknut
Clamp Tab
Clamp
Upper
Hinge Pin
Upper
Hinge Plate
FIGURE 1 Installing Non-Removable Device
Swingaway
Front Rigging
Part No 1076733 3 Non-Removable Device
Invacare Corporation
USA
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
www.invacare.com
Canada
570 Matheson Blvd. E Unit 8
Mississauga Ontario
L4Z 4G4 Canada
800-668-5324
Invacare, the Medallion Design, and
Yes, you can. are registered
trademarks of Invacare Corporation.
©2006 Invacare Corporation
Part No 1076733
MADE IN MEXICO
Rev C - 2/8/06
Loading...