User Manual
DEALER: These instructions MUST be given to the user of the
product.
USER:
future reference.
BEFORE using this product, read this manual and save for
Leveler Instructions
for Armoire/Wardrobes
1 General
1.1 Symbols
Signal words are used in this manual and apply to hazards or unsafe practices which could result in
personal injury or property damage. See the information below for definitions of the signal words.
WARNING
Warning indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION
Caution indicates a potentially hazardous situation which, if not avoided, may result in
property damage or minor injury or both.
Gives useful tips, recommendations and information for efficient, trouble-free use.
The wardrobe MUST be level for proper door alignment.
2 Usage
2.1 Leveler Instructions for Concord, Somerset, Camden, Hamilton, Glendale,
and Torrington Collections
Removing Skid Runners (If applicable)
Skid runners are attached to the bottom of the armoire/wardrobe for shipping.
1. Tilt the unit back or lay unit down on its back.
2. Remove the screws that attach the runners to the side panels and discard the skid runners.
3. Position unit in upright position.
Armoire/Wardrobe With Two Drawers
For this procedure, refer to FIGURE 1 on page 2.
1. Pull the bottom drawer out to full extension.
2. Depress the metal lock brackets at the ends of the cabinet drawer slides.
Part No 1171786 1 Leveler Instructions
3. Remove the drawer.
Bottom Shelf
Leveler
Adjustment
Hole
Leveler
Adjustment
Hole
Leveler
Leveler
Leveler adjustment holes are located at each side of the bottom shelf.
4. Insert a flathead screwdriver to make contact with the leveler head.
When performing step 5, ensure that both levelers are raised/lowered to the same
height to ensure the door will open and close properly.
5. Perform one of the following:
• Turn leveler screws clockwise to raise unit.
• Turn leveler screws counter clockwise to lower unit.
6. Reinstall drawer.
FIGURE 1 Usage
Armoire/Wardrobe With No Drawers
For this procedure, refer to FIGURE 1.
1. Open the door(s) and locate two plastic plugs at each side of the bottom shelf.
2. Pry out the plugs with a flat screwdriver.
3. Insert the flat screwdriver into the holes to make contact with the leveler head.
When performing step 4, ensure that both levelers are raised/lowered to the same
height to ensure the door will open and close properly.
4. Perform one of the following:
• Turn levelator screws clockwise to raise unit.
• Turn levelator screws counter clockwise to lower unit.
5. Replace plastic plugs.
Leveler Instructions 2 Part No 1171786