Infinity Drain LT5-2 User Manual

LTD 5 Series

LTD 5│Tile Drain Series

- 16 gauge 304 Stainless Steel top with ABS Base

- Indoor or outdoor use

- Residential grade drain body (Cast Iron, PVC or ABS) with 2” throat

- Uses Hot Mop, Lead Pan, PVC Vinyl Liner, Rubber Liner (ChloraloyTM)

Copper Pan or Fiberglass waterproofing

- Grate can be removed completely for cleaning

- Accepts flooring material up to 3/8”

- Requires traditional 4-way floor pitch

- Integral hair strainer

- Flow rate 8 GPM

Finishes:

Satin Stainless

_____

Polished Stainless

_____

Complete Kits:

LTD5-2I SS Clamp Down Drain Cast Iron
LTD5-2I PS Clamp Down Drain Cast Iron
LTD5-2A SS Clamp Down Drain ABS
LTD5-2A PS Clamp Down Drain ABS
LTD5-2P SS Clamp Down Drain PVC
LTD5-2P PS Clamp Down Drain PVC

Components:

LT5-2 SS 5” x 5” Strainer Only
LT5-2 PS 5” x 5” Strainer Only

CDI 22 Clamp Down Drain Cast Iron
CDA 22 Clamp Down Drain ABS
CDP 22 Clamp Down Drain PVC

Installation (TD) Center Drain

Infinity Drain

18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.InfinityDrain.com

Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.

Note: Installer must verify all rough-in

dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.

Page 1 of 2

REV. 08.01.2013

LTD 5 Specifications

LTD5-2I SS

5” x 5” Kit with Cast Iron Drain Body
2” Outlet

(5” L x 5” W x 1” H)
1 - LT5-2 Tile Drain Strainer
1 - CDI 22 Clamp Down Drain

LTD5-2A SS

5” x 5” Kit with ABS Drain Body
2” Outlet

(5” L x 5” W x 1” H)
1 - LT5-2 Tile Drain Strainer
1 - CDA 22 Clamp Down Drain

LTD5-2P SS

5” x 5” Kit with PVC Drain Body
2” Outlet

(5” L x 5” W x 1” H)
1 - LT5-2 Tile Drain Strainer
1 - CDP 22 Clamp Down Drain

Infinity Drain

18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.InfinityDrain.com

Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.

Note: Installer must verify all rough-in

dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.

Page 2 of 2

REV. 08.01.2013