• A cellular telephone should not be used for any purpose while
driving so full attention may be given to vehicle operation.
• Always wear your seat belt.
• Supplemental air bags do not replace proper seat belt usage.
• Children 12 and under should always ride in the rear seat
properly secured in child restraints or seat belts according to
their age and weight.
• Do not drink and drive.
For more information, refer to the “Safety –– Seats, seat belts and
supplemental restraint system (section 1)”, “Monitor, climate,
audio, phone and voice recognition systems (section 4)” and the
“Starting and driving (section 5)” of your Owner’s Manual.
Additional information about your vehicle is also available
in your Owner’s Manual, Navigation System Owner’s Manual
and at www.InfinitiUSA.com.
To view detailed
instructional videos, go to
www.infinitiownersinfo.mobi/2014/q60
or snap this barcode with an
appropriate barcode reader.
essential information
Tire Pressure Monitoring System (TPMS)
A CHECK TIRE PRESSURE warning message will
appear in the vehicle information display
the low tire pressure warning light
02
when one or more tires are low on pressure and air
is needed.
• The tire pressures should be checked when
the tires are cold. The tires are considered cold
after the vehicle has been parked for 3 hours
or more or driven less than 1 mi (1.6 km) at
moderate speeds.
After tire pressures are adjusted, drive the vehicle
at speeds above 16 MPH (25 km/h). The CHECK TIRE PRESSURE warning message and low tire
pressure warning light will disappear.
When the low tire pressure warning light flashes for 1 minute and then remains on, the TPMS
is not functioning properly. Have the system checked by an INFINITI retailer.
Tire pressure rises and falls depending on the heat caused by the vehicle’s operation and the
outside temperature. Low outside temperature can lower the temperature of the air inside
the tire, which can cause a lower tire inflation pressure. This may cause the low tire pressure
warning light to illuminate. If the warning light illuminates, check the tire pressure in your tires.
• Check the tire pressure (including the spare tire) often and always prior to long distance trips.
The Tire and Loading Information label contains valuable information. Please refer to section
9, “Technical and consumer information”, in your Owner’s Manual for the location of the Tire
and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and
the“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
and
01
will illuminate
01
02
01
Loose Fuel Cap
A LOOSE FUEL CAP warning message will appear in
the vehicle information display
cap is not tightened correctly.
To tighten, turn the cap clockwise until a single click
is heard.
The warning message will disappear when the vehicle
detects the fuel-filler cap is properly tightened and the
reset button
If the cap is not properly tightened, the Malfunction
Indicator Light
For more information, refer to the “Instruments and controls (section 2)” and
the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
02
is pressed for about 1 second.
may illuminate.
2
01
when the fuel-filler
01
02
Fuel-Filler Door
The fuel-filler door is located on the passenger’s side of
the vehicle.
Unlock the fuel-filler door using one of the following
operations, then push and release the left side of the
door to open.
• Push the door handle request switch while
carrying the INFINITI Intelligent Key with you.
• Press the UNLOCK button on the Intelligent Key.
• Push the power door lock switch to the UNLOCK position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Automatic Power Windows
Your power windows have an automatic adjusting
function to ensure windows close completely to help
seal against wind noise and weather leaks.
When the front doors are being opened, the windows
automatically lower slightly to avoid contact between
the windows and the side roof panels.
If your vehicle’s battery is discharged or
disconnected, your power window automatic
function will not operate.
Refer to your Owner’s Manual for information to
initialize your power window system.
If the power window functions do not operate
properly after initializing the system, have your
vehicle checked by an INFINITI retailer.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
Accessing the Front Cup Holders
To open the cup holders, push the lid
and release.
The flap
02
will fold down when inserting a
large container.
For more information, refer to the “Instruments and controls (section 2)” of
your Owner’s Manual.
01
down
01
02
3
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock or
unlock the vehicle, open the trunk and start the engine.
It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
The operating range of the Intelligent Key is within
31.5 in (80 cm) from each request switch.
To lock the vehicle, push either door handle request
01
switch
To unlock the vehicle, perform one of the following procedures:
once or press the
• Push either door handle request switch
button
02
on the key fob.
01
once; the
corresponding door will unlock. Push the door handle
01
request switch
again within 1 minute; all other doors
will unlock, or
• Press the
button
side door. Press the
To release the trunk lid, press the
1 second. Lift the trunk lid to access the trunk.
To retract the hard top (Convertible models), push and hold the
door handle request switch
The Intelligent Key can also be used to activate the panic alarm by pressing and holding the
button
05
for more than 1 second. Once activated, the panic alarm and headlights will
on the key fob to unlock the driver’s
button again; all other doors will unlock.
04
button
HOLD
01
until the hard top is fully open.
for more than
03
stay on for a period of time.
INFINITI INTELLIGENT KEY BATTERY DISCHARGE
If the battery in the Intelligent Key is almost
discharged, the guide light
06
of the Intelligent
Key port blinks and the Intelligent Key battery
07
discharge indicator
is displayed in the vehicle
information display.
To start the engine under these circumstances, insert
the Intelligent Key into the key port with the buttons
facing upward and the key ring end toward you until
it latches into place. Then push the ignition switch to
start the engine.
To remove the Intelligent Key from the port, push the
07
ignition switch to turn the engine off and then pull the
Intelligent Key out of the port.
The Intelligent Key port does not charge the Intelligent Key battery. If you see the low battery
indicator
Do not insert the mechanical key or any other objects into the key port because it will
07
, replace the battery in the Intelligent Key.
damage the key port.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
4
01
02
03
04
05
06
Trunk Lid Release
Use one of the following methods to open the trunk:
Push the trunk open request switch
than one second while carrying the INFINITI
Intelligent Key with you.
Press the trunk button
more than one second.
Push down on the trunk lid release switch
located on the instrument panel to the left of the
on the Intelligent Key for
HOLD
steering wheel.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
01
for more
02
01
02
Seat Adjustments
To slide the seat forward or backward, push the
control switch
To recline the seatback, push the switch
01
forward or backward.
SEAT LIFTER
To adjust the angle of the front seat cushion or height
of the seat, push the front or rear end of the switch
01
up or down.
POWER LUMBAR SUPPORT (driver’s seat)
To adjust the seat lumbar support, push the front or back end of the switch
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
forward or backward.
02
0102
03
03
.
5
first drive features
Automatic Drive Positioner (if so equipped)
Two positions for the driver’s seat, steering column
and outside mirrors can be stored in the automatic
drive positioner memory.
Follow these procedures to set the memory positions:
• Confirm the shift lever is in the P (PARK) position
(automatic transmissions) or the parking brake is applied (manual transmissions).
• Push the ignition switch to the ON position.
• Adjust the driver’s seat, steering column and outside mirrors to the desired positions using
the adjusting switches for each feature.
• Push the SET switch and within 5 seconds, push the memory switch (1 or 2) for at least 1 second.
• The indicator light on the memory switch you select will illuminate for approximately 5 seconds.
• The driver’s seat, steering column and outside mirror positions are now set to your preference.
These memorized positions can also be linked to your INFINITI Intelligent Key.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Seat Belt Guide (Convertible models)
Unsnap the seat belt guide
passengers easier access.
Before fastening the seat belt, ensure the seat belt is
inserted into the seat belt guide and the snaps are
securely fastened.
When using the seat belt guide, do not allow the seat
belt to twist so that it will retract correctly.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your Owner’s Manual.
to allow rear seat
01
01
Passenger Rear Seat Entry/Exit
For ease in entering and exiting the rear passenger
02
01
areas of the vehicle, perform the following steps:
1. Release the front seatbelt guide and seat belt.
(Convertible models)
2. Pull the seatback lever
01
upward to fold the
front seatback forward. Make sure that the front
seatback is completely folded.
Convertible
02
01
3. To slide the front seat forward, firmly push
the seatback button
02
. The front seat will
Coupe
move forward.
To stop the front seat from sliding, press the seatback button
To return the front seat to its original position:
02
again.
1. Push or pull the seatback backward until it locks in place.
02
2. Press the seatback button
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
to slide the front seat backward.
6
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.