Indesit I6 EVA User Manual [UK]

Operating Instructions

COOKER AND OVEN

			Contents
					GB
			Warning,2
	GB
			Installation, 2-3
	English, 1		Positioning and levelling
			Electrical connection
			Technical data
			Description of the appliance, 4
			Overall view
			Control panel
	I6 EVA/UK		Start-up and use, 5
			Starting the oven
			Using the cooking timer
			Cooking advice, 6-7
			Oven cooking advice table
			Using the electric hob, 8
			Practical advice on using the electric hotplates
			Precautions and tips, 9
			General safety
			Disposal
			Respecting and conserving the environment
			Care and maintenance, 10
			Switching the appliance off
			Cleaning the appliance
			Replacing the oven light bulb
			Assistance
			Removing and fitting the oven door

WARNING

•WARNING: The appliance and its GB accessible parts become hot

during use.

•Care should be taken to avoid touching heating elements.

•Children less than 8 years of age shall be kept away unless continuously supervised.

•This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

•WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire.

•NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.

•Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.

•The internal surfaces of the compartment (where present) may become hot.

•Never use steam cleaners or pressure cleaners on the appliance.

•Remove any liquid from the lid before opening it.

•Do not close the glass cover (if present) when the gas burners or electric hotplates are still hot.

•WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

!When you place the rack inside, make sure that the stop is directed upwards and in the back of the cavity.

Installation

!Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance.

!Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.

!The appliance must be installed by a qualified professional according to the instructions provided.

!Any necessary adjustment or maintenance must be performed after the appliance has been disconnected from the electricity supply.

Positioning and levelling

!It is possible to install the appliance alongside cupboards whose height does not exceed that of the hob surface.

!Make sure that the wall in contact with the back of the appliance is made from a non-flammable, heatresistant material (T 90°C).

To install the appliance correctly:

•Place it in the kitchen, dining room or the bed-sit (not in the bathroom).

•If the top of the hob is higher than the cupboards, the appliance must be installed at least 200 mm away from them.

HOOD

	Min. 600mm.	min. 650 mm. with hood min. 700 mm. without hood
Min. 420mm.	Min. 420mm.

• If the cooker is installed underneath a wall cabinet, there must be a minimum distance of 420 mm between this cabinet and the top of the hob. This distance should be increased to 700 mm if the wall cabinets are flammable (see figure).

•Do not position blinds behind the cooker or less than 200 mm away from its sides.

•Any hoods must be installed according to the instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the appliance, screw the adjustable feet* into the places provided on each corner of the base of the cooker (see figure).

2

The legs* provided with the appliance fit into the slots on the underside of the base of the cooker.

consumer unit to the cooker, via the switched double

pole cooker outlet, must be of an acceptable type GB and current rating as above.

! the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents.

Electrical connection

Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing the back panel of the cooker itself with a screwdriver.

! the following installation procedure must be carried out by a qualified electrician. The electrical installation must comply with the IEE Regulations, Building & local By-Lays.

1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram).

2. Loosen the cable clamp screw and remove it, using a screwdriver as a lever (see figure).

3. Remove the wire contact screws L-N- , then fasten the wires under the screw heads, respecting the colour code: Black/Blue (N), Red/Brown (L) and Bare Wire/Yellow-Green ().

•Once the connections have been made, tighten all the terminal screws fully.

•Fasten the supply cable in place with the clamp and close the cover of the terminal board.

Connecting the supply cable to the mains

WARNINGS: THIS APPLIANCE MUST BE EARTHED.

! The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the

HOT PARTS

Mains frequency and voltage of the electrical section

Model	Electric section
	Voltage	Power (W)
I6 EVA/UK	240V~ 50/60 Hz	9900

Safety Chain

! In order to prevent accidental

tipping of the appliance, for example by a child climbing onto the

oven door, the supplied safety chain MUST be installed!

The cooker is fitted with a safety chain to be fixed by means of a screw (not supplied with the cooker) to the wall behind the appliance, at the same height as the chain is attached to the appliance.

Choose the screw and the screw anchor according to the type of material of the wall behind the appliance. If the head of the screw has a diameter smaller than 9mm, a washer should be used. Concrete wall requires the screw of at least 8mm of diameter, and 60mm of length.

Ensure that the chain is fixed to the rear wall of the cooker and to the wall, as shown in figure, so that after installation it is tensioned and parallel to the

ground level.

3

Description of the appliance

Overall view

GB

		Tray for
		Catching
		Overflows
	Electric	Electric
	plates	plates
	Control panel	GUIDE RAILS
		for the sliding racks
	GRILL rack	position 5
	DRIPPING pan	position 4
		position 3
		position 2
		position 1
	Adjustable foot	Adjustable foot

Control panel

THERMOSTAT	ACTIVE HOTPLATE
indicator light	indicator light

VARIABLE GRILL		SELECTOR		ELECTRIC HOTPLATE
knob		knob		control knobs

4