Limited 90-Day Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred
to as SDI Technologies), warrants this product to be free from defects
in workmanship and materials, under normal use and conditions, for a
period of 90 days from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to
first return it to the store where it was originally purchased. Should this
fail to resolve the matter and service still be required by reason of any
defect or malfunction during the warranty period, SDI Technologies will
repair or, at its discretion, replace this product without charge (except
for a $7.00 charge for handling, packing, return UPS/postage, and
insurance). This decision is subject to verification of the defect or
malfunction upon delivery of this product to the Factory Service Center
listed below. The product must include proof of purchase, including
date of purchase. The fee for service without proof of purchase is
$15.00.
Before returning this product for service, please first replace the batteries
(if applicable) with fresh ones, as exhausted or defective batteries are
the most common cause of problems encountered.
If service is still required:
1. Remove the batteries (if applicable) and pack the unit in a well padded,
heavy corrugated box.
2.
Enclose a photocopy of your sales receipt, credit card statement, or
other proof of the date of purchase, if within the warranty period.
3.
Enclose a check or money order payable to the order of SDI Technologies,
for the sum of $7.00 ($15.00 without proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center
listed below.
Consumer Repair Department
SDI Technologies Inc.
1330 Goodyear Drive
El Paso, TX 79936-6420
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose
for which it was designed. It does not cover (i) products which have
been damaged by negligence or willful actions, misuse or accident, or
which have been modified or repaired by unauthorized persons; (ii)
cracked or broken cabinets, or units damaged by excessive heat; (iii)
damage to digital media players, CD’s or tape cassettes (if applicable);
(iv) the cost of shipping this product to the Factory Service Center and
its return to the owner.
This warranty is valid only in the United States of America and does not
extend to owners of the product other than to the original purchaser.
In no event will SDI Technologies or any of its affiliates, contractors,
resellers, their officers, directors, shareholders, members or agents be
liable to you or any third party for any consequential or incidental
damages, any lost profits, actual, exemplary or punitive damages. (Some
states do not allow limitations on implied warranties or exclusion of
consequential damages, so these restrictions may not apply to you.)
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide
by the above mentioned disclaimer of warranty is contractually binding
to you upon your transfer of currency (money order, cashier's check,
or credit card) for purchase of your SDI Technologies product.
Questions? Visit www.ihomeaudio.com
For any other questions: 1-800-288-2792 Toll Free
©2006 SDI Technologies, Inc. All Rights Reserved.
Printed in China iHM1-101206-1
IMPORTANT
Read before proceeding
If you have any questions regarding the operation or use of this product, please visit
www.ihomeaudio.com to view answers to frequently asked questions.
To learn more about this and other iHome products, please visit us online at www.ihomeaudio.com
Model iHM1
the speaker system
for your iPod nano
SRS® is a registered trademark of SRS Labs, Inc.
TruBass technology is incorporated under
license from SRS Labs, Inc.
MODEL: iHM1 (2nd Generation)
INSTRUCTION MANUAL
SCALE: 1:1
DATE: OCT 13, 2006
™
�
�
Using the iHM1
Thank you for purchasing the iHM1, the speaker system for
your iPod nano. Designed specifically to work with your iPod
nano, this system provides high quality audio and that invites
�
�
other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide
by the above mentioned disclaimer of warranty is contractually binding
to you upon your transfer of currency (money order, cashier's check,
or credit card) for purchase of your SDI Technologies product.
Questions? Visit www.ihomeaudio.com
For any other questions: 1-800-288-2792 Toll Free
©2006 SDI Technologies, Inc. All Rights Reserved.
Printed in China iHM1-101206-1
IMPORTANT
Read before proceeding
If you have any questions regarding the operation or use of this product, please visit
www.ihomeaudio.com to view answers to frequently asked questions.
To learn more about this and other iHome products, please visit us online at www.ihomeaudio.com
SRS® is a registered trademark of SRS Labs, Inc.
TruBass technology is incorporated under
license from SRS Labs, Inc.
MODEL: iHM1 (2nd Generation)
INSTRUCTION MANUAL
SCALE: 1:1
DATE: OCT 13, 2006
New 2g iPod nano
Release Button
Mode Button
Power Indicator
�
�
�
MODEL: iHM1 (2nd Generation)
INSTRUCTION MANUAL
SCALE: 1:1
DATE: OCT 13, 2006
NOTE:
FOR BEST SOUND,
turn Sound Check ON
in your iPod Settings
menu
NOTE: ADJUST iPod
VOLUME TO AVOID
DISTORTION
Using the iHM1
Thank you for purchasing the iHM1, the speaker system for
your iPod nano. Designed specifically to work with your iPod
nano, this system provides high quality audio and that invites
your music to come out and play.
Please read the instructions carefully before operating the
unit and keep for future reference.
Installing/Replacing Batteries
1. Open the battery compartment cover located on the back
of the unit.
2. Insert 3 “AA” (LR6) batteries, checking that the + and –
ends of the batteries match the drawing inside the battery
compartment. We recommend the use of alkaline
batteries for longer life.
3. Close the compartment cover.
Battery information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable batteries.
• Make sure you dispose of batteries properly (see your
local regulations).
iPod nano switch (located on bottom of unit):
• Default setting is for the new 2g iPod nano.
• If you have an original 1g iPod nano, slide the switch to
the left position.
Inserting/Removing iPod nano from the unit
1. Slide your iPod nano into the unit as shown. Please make
sure the iPod nano is fully docked into the unit before
turning on power on the unit.
2. To remove your iPod nano, push the “Release” button
down. The iPod nano will pop up and you can tilt it into
the palm of your hand.
Listening to your iHM1
1. Turn on your iPod nano and set desired volume.
2. Switch the mode button located on the right side of the
unit to On or to SRS TruBass if you want more bass.
3. Because audio tracks are mastered differently, you may
notice discrepancies in volume from song to song.
For best sound, turn Sound Check ON in your nano’s
Settings menu.
4. Remember to turn unit OFF when not in use to save
batteries. To extend battery life, play unit without SRS
TruBass feature.
Maintenance
• Place the unit away from sources of direct sunlight or
excessive heat.
• Protect your furniture when placing your unit on a natural
wood and lacquered finish.
• Clean your unit with a soft cloth moistened only with mild
soap and water. Stronger cleaning agents, such as
Benzine, thinner or similar materials can mar the surface
of the case.
iPod nano switch
NOTE: UNIT DOES NOT CHARGE iPod nano
Battery Installation
�
�
�
Loading...