50-Pair 66 Wiring Block
I N S T A L L A T I O N I N S T R U C T I O N S
Step 1: Mount an 89B mounting bracket onto a plywood wall. Note: Bracket and mounting screws are sold separately.
Step 2: Route the horizontal or backbone cables down inside the 89B mounting bracket and feed the cables out from either side.
Step 3: Snap the 66 wiring block onto the 89B mounting bracket.
Punch Down Tool with 66 cutting blade
Input |
Output |
|
Punch Down Tool |
|
|
|
with 66 cutting blade |
|
Bridging |
|
|
|
|
|
|
|
Clip |
|
Bridging Clip |
|
connects |
|
|
Input to |
|
|
|
|
Output |
Input |
Output |
Input |
Output |
Step 4a: Seat and terminate the input and output conductors using a punch-down tool. Use a bridging clip between the input and output IDCs to establish contact. Refer to chart below for color order.
Cover |
Labels |
Strips |
Step 4b: Bridging clip is not necessary if output conductor is terminated on same IDC as input conductor.
Optional Accessories: Use a snap-on cover to protect terminated wires or use label strips for easy system administration.
888-ASK-4ICC |
csr@icc.com |
icc.com |
© Copyright 2011, ICC. ICC and ICC logo are registered trade name and trademark. All rights reserved. |
MSR-0396-RevD |