Hughes HN 7000 User Manual
HX 200/220 Ku-band broadband satellite Router
HN 7000 Ku-band broadband satellite Router
Hughes and the iNetVu® 7000 Series Controller
1-877-iNetVu6
www.c-comsat.com
Revision 2.4
September 19, 2014
INETVU® MOBILE SYSTEM QUICK START – HUGHES KU
This page is intentionally left blank.
C-COM Satellite Systems Inc Page 2
INETVU® MOBILE SYSTEM QUICK START – HUGHES KU
1.1 Safety and Warning Information
For your safety and protection the following important safety information should be reviewed before
installation, configuration and use of the iNetVu Satellite Platform System and Modem equipment. It is
also recommended to read the manual in its entirety prior to setup and operation.
Warning: The following general safety precautions must be observed during all phases of setup and
operation of this equipment. Failure to comply with these precautions or with specific warnings
elsewhere in this documentation violates safety standards of design, manufacture and intended use of
the equipment. C-COM Satellites Systems Inc. assumes no liability for the customer’s failure to comply
with these requirements.
This situation or practice might result in property or
equipment damage. Ensure Sensor and Motor cables are
connected prior to powering on 7000 Series Controller. Do not
connect or disconnect cables once controller has been
powered on. It is recommended that controller is properly
grounded at all times.
C-COM Satellite Systems Inc Page 3
INETVU® MOBILE SYSTEM QUICK START – HUGHES KU
1.2 System Overview
The iNetVu
system for a foldable two-way satellite antenna. It has been designed to automatically find and acquire
the satellite beam and the position based on both a GPS position reading as well as other positioning
parameters. It is targeted for mobile users that require high speed Internet access in remote locations
where cable and DSL do not exist. It provides two-way, high-speed data communications over satellite.
iNetVu™ empowers mobile users with the ability to stop anywhere there is Satellite coverage and
access Internet at broadband speeds. The iNetVu™ Mobile application consists of the iNetVu™ Mobile
software 7000 software (for the 7000 Series Controller)
iNetVu™ Mobile Application
Key Features:
• Automatic re-peak on satellite upon signal loss.
• Automatic dish stow if Mobile Platform moves
• If the vehicle is moved before the dish is stowed, the dish will sense movement and will
• The dish will not transmit unless it is pointed adequately to meet cross-polarization
• The system will automatically find any satellite from any point on the Earth within its coverage
• Displays comprehensive information about the satellite, dish, motors, GPS, compass, control
• Finds the satellite, peaks the signal strength and selects the optimal path to perform the selected
• Simple to install, configure and operate.
™
Mobile Satellite Internet system is an automatic scanner, polarizer and beam positioning
automatically begin stowing itself.
specifications.
area.
box, and modem.
satellite, allowing the customer’s computer to be online as soon as possible
C-COM Satellite Systems Inc Page 4
INETVU® MOBILE SYSTEM QUICK START – HUGHES KU
Service
Type
Modem Type
Modem F/W
Minimum
F/W – S/W
Recommended
F/W – S/W
Interface
HNS
DW 4020
4.2.2.10+
7.1.6.0+
7.5.5.0+
HTTP
DW 6000
5.0.1.2+
7.1.6.0+
7.5.5.0+
HTTP
DW/HN
0/7740S
5.6.0.19+
7.1.6.0+
7.5.5.0+
HTTP
HX200/220
6.2.0.13+
7.1.9.0+
7.5.5.0+
HTTP
1.3 Pre-Configuration Check Li st
The following items should be completed/known prior to configuring the iNetVu® Mobile System.
Contact the Network Operation Center (NOC) if any of the following items are unknown or if you are
unfamiliar with them.
Prior to installing IMS and configuring your system, verify that you are using the minimum
requirements listed below. C-COM always recommends using the latest version as many fixes
and improvements have been made.
Note: Please contact C-COM if you require more information about modem compatibility as these
may change without further notice.
7000/7700/774
Note: Installed Software and Controller Firmware versions MUST be identical for normal operation
Target Satellite Longitude
IP Address, Freq, Symbol Rate and Hemisphere of Satellite Modem
Transmit and Receive Polarization (Horizontal/Vertical)
DVB Carrier if DVB search method is to be used
C-COM Satellite Systems Inc Page 5
INETVU® MOBILE SYSTEM QUICK START – HUGHES KU
GPS
Antenna
Motor
Sensor
Cable
90 - 264 VAC
Motor Control Cable
Power Ca ble
SAT IN
Straight/
DW6000/7000/7700/HN7000/7700
USB Cable
*Ground
24 VDC
IP: A.B.C.D+2
GW: A.B.C.D
IP: A.B.C.D
IP: A.B.C.D+1
GW: A.B.C.D
1.4 System Wiring with Hughes Net Service
Note: The following diagrams are a general reference only. An external splitter can be used in all
scenarios. Please consult with your NOC or Service provider
1.5 USB Interface Connection – System Wiring
Input
(option)
protection
SUB: 255.X.Y.Z
X-Over
Network
Cable
USB Interface System Wiring Diagram for DW6000/7000/7700 / HN7000/7700
Sensor Cable
RG6 Coaxial Cable
USB Cable
!
SUB: 255.X.Y.Z
SUB: 255.X.Y.Z
C-COM Satellite Systems Inc Page 6
Loading...