Quick Start Guide
DUB-LX1
DUB-LX2
DUB-LX3
•To power on your device, press and hold the power button until the screen turns on.
•To power off your device, press and hold the power button, and then touch .
•To restart your device, press and hold the power button, and then touch .
•Press and hold the power button for 10 or more seconds to forcibly restart your device.
DUB-LX1&LX3
1 |
15 |
|
2 |
14 |
|
3 |
13 |
|
12 |
||
4 |
||
11 |
||
5 |
||
10 |
||
|
||
|
9 |
|
6 |
|
|
7 |
8 |
|
Headset jack |
Secondary microphone |
|
Rear camera |
Flash |
|
Fingerprint scanner |
Speaker |
|
Primary microphone |
Micro-USB port |
|
Front camera |
Power button |
|
Volume button |
Light sensor |
|
elfie Toning Flash |
Status indicator |
|
Earpiece |
|
1
DUB-LX2 |
|
|
1 |
14 |
|
2 |
13 |
|
3 |
12 |
|
11 |
||
4 |
||
10 |
||
|
||
|
9 |
|
|
8 |
|
5 |
|
|
6 |
7 |
|
Headset jack |
Secondary microphone |
|
Rear camera |
Flash |
|
Speaker |
Primary microphone |
|
Micro-USB port |
Front camera |
|
Power button |
Volume button |
|
Light sensor |
elfie Toning Flash |
|
Status indicator |
Earpiece |
2
•Do not insert or remove the SIM card when your device is powered on.
•Ensure that the card is correctly aligned and that the card tray is level when you insert it into your device.
•Be careful not to scratch your device or hurt yourself when using the eject pin.
•Store the eject pin out of the reach of children to prevent accidental swallowing or injury.
•Do not use cut or modified SIM or microSD cards with
your device as these may not be recognized and could damage the card tray (slot).
•If your SIM card does not match your device, please contact your carrier.
Single-SIM:
1 |
2 |
Dual-SIM:
1 |
2 |
3
Your device supports only dual card dual standby single pass, which means you cannot use both SIM cards for calls or data services simultaneously.
•When you are on a call using SIM card 1, SIM card 2 cannot be used to make or answer calls. If someone calls SIM card 2, the caller will hear a voice message similar to "The subscriber you dialed is out of the service area" or "The subscriber you dialed cannot be connected for the moment, please try again later." The actual message will vary by service provider.
•When you are using SIM card 1's data service, SIM card 2's data service will be disabled.
Your device's single pass feature helps reduce power consumption and increase your device's standby time. It is not related to your service provider's network conditions.
You can go to Settings > Wireless & networks > Dual SIM settings, and enable Enable call forwarding between SIMs to avoid the conflicts mentioned above.
4