Honeywell HZ-614C, HZ-614, HZ-615, HZ-817, HZ-617C User Manual

...
0 (0)

www.sylvane.com (800) 934-9194

IMPORTANT SAFETY INSTRUCTIONS

IF YOU DO NOT UNDERSTAND THESE INSTRUCTIONS OR PRODUCT LABELS DO NOT USE THIS PRODUCT AND CALL US AT (800) 477-0457 FOR AN EXPLANATION.

YOUR RESPONSIBILITIES

These instructions are intended to provide you with the information you need to use the product and to avoid such hazards. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1.Read all instructions before using this heater.

2.This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If, provided, use handle when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.

3.Extreme caution is necessary when any heater is used by or near children or invalids, and whenever the heater is left operating and unattended.

4.Always unplug heater when not in use.

5.Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner.

Quick Heat® Heaters

MODEL HZ-614 SERIES AND HZ-614C SERIES MODEL HZ-615 SERIES

MODEL HZ-617 SERIES AND HZ-617C SERIES MODEL HZ-817 SERIES

Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.

6.Do not use outdoors.

7.This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.

8.Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area where it will not be tripped over.

9.To disconnect the heater, first turn off the product, then grip the plug and pull it from the wall outlet. Never pull by the cord.

10.Warning - Connect to properly grounded outlets only. This heater is for use on 120 volts. This appliance has a grounded plug as shown in Fig. 1. An adapter is available at retail (not included) for connecting three-blade groundingtype plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.

11.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.

12.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, or where openings may become blocked.

13.A heater has hot and arcing or sparking parts inside Do not use it in the areas where gasoline, paint or flammable liquids are

used or stored.

14.Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.

The Honeywell trademark is used by Kaz, Inc. under license from Honeywell International Inc.

Honeywell HZ-614C, HZ-614, HZ-615, HZ-817, HZ-617C User Manual

15.Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. The extension cord shall be a three wire cord with a grounding-type cord and plug connector.

16.This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.

17.It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause

overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlets.

18. Never tamper with this product or attempt to fix it. Any tampering with, or modification of this product can result in serious injury, death, fire or risk of electric shock. Do not open, no user serviceable parts inside.

19. Do not remove product labels that contain warnings or safety instruction.

20. The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.

21. SAVE

THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT

Fig. 1

HZ-614, HZ-615, & HZ-617 SERIES OPERATION

• Place the heater on a firm, level surface away from any

Fig. 2

combustible material.

 

With Power knob in the OFF position, plug the heater into a grounded outlet.

Turn the thermostat knob fully clockwise to the high setting.

To turn the heater on, turn the Power knob clockwise to the ON position. (Fig. 2).

If you want to use the Quick Heat® feature, turn the Power knob to the Quick Heat® Setting.

When the room reaches a comfortable temperature, slowly turn the thermostat control counterclockwise until the heater goes off. This is the point at which the thermostat setting equals the room temperature. If left at this setting, the thermostat will automatically turn the heater on and off to maintain the selected temperature.

www.sylvane.com (800) 934-9194

HZ-817 SERIES OPERATION

Place the heater on a firm, level, open surface free from

 

 

Fig. 3

 

 

obstructions and at least 3 feet (0.9 m) away from any

 

 

Control

Quick

 

combustible materials.

Knob

 

Heat

Never leave an operating unit unattended.

 

 

 

Plug the heater into an electrical wall outlet.

 

 

Touch the power button to turn the heater on.

 

 

 

The power indicator light will illuminate. (Fig. 3)

 

 

To save up to 35% in energy bills, turn the Energy Smart™

 

 

 

knob to your desired temperature. There are four distinct

 

 

 

settings of 65°F/18°C, 70°F/ 21°C, 75°F/23°C, and

 

 

 

80°F/26°C. The Energy Smart™ heater will automatically

Power

 

 

select the appropriate power level to best accommodate

Button

 

 

your desired temperature. As the air temperature in

 

 

 

the room approaches the set temp, the heater will

Power Indicator Light

 

 

automatically lower the power consumption and provide

 

 

 

consistent warmth without wasting energy.

 

 

 

 

 

The illuminated LED lights will indicate what the current room temperature is.

This heater is equipped with a “frost watch” which automatically turns the unit on if the temperature drops below 55°F/12°C degrees

To override the Energy Smart™ feature and produce maximum heat, turn the knob fully clockwise to “High”. This will produce 1500W of heat at all times.

QUICK HEAT® FEATURE

Quick Heat® will propel a steady blast of warm air out of your baseboard. This can help heat your room more quickly. You will hear a fan operating in this mode. You can also turn the Quick Heat® setting off and the heater will operate silently.

SAFETY FEATURES

This heater is equipped with several devices and features for added protection.

A high temperature safety control prevents overheating

(Hi Limit).

A back-up thermal circuit breaker that will permanently shut down the heater should it operate at higher than normal temperatures (HZ-614, HZ-615, HZ-617 and HZ-817 only).

A SafeGuardAlert Heat Indicator Badge that indicates the grille is hot and should not be touched - turns from black to red (HZ-614C, HZ-617, HZ-617C and HZ-817 only).

Tip-over switch feature - The HZ-817 SERIES ONLY is equipped with a tip-over switch that disables the heater if it is tipped over. To restore power to the heater, stand the heater up properly and press the power button.

A three-prong grounded plug.

This heater was created using a high quality safety plastic.

Fig. 4

 

Heat Indicator

 

 

Badge

Do not touch the grille until the unit has been turned off and the SafeGuardAlert Badge has turned back to black.

TROUBLESHOOTING

If your heater shuts off unexpectedly or fails to operate, one of your heater’s safety features may have been activated to prevent overheating.

Be sure the power cord is plugged into a working electrical outlet.

Check for any obstructions. If you find one, turn the heater OFF and unplug it.

Wait at least 10 minutes to allow the heater to cool completely before removing any obstruction. When done, plug in the heater and follow the OPERATION instructions.

CONSUMER RELATIONS

Mail questions or comments to:

Call us toll-free at: 1-800-477-0457

Kaz, Incorporated

E-mail: consumerrelations@kaz.com

Consumer Relations Dept.

Or visit our website at: www.kaz.com

250 Turnpike Road

Please be sure to specify a model number.

Southborough, MA 01772

NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE YOUR WARRANTY. DO NOT RETURN THE HEATER TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.

CLEANING AND STORAGE

We recommend that the heater be cleaned at least once a month and before off-season storage.

Turn the heater OFF and unplug it. Allow it to cool.

Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAX, POLISH

OR ANY CHEMICAL SOLUTION.

Clean your heater using the above-mentioned steps, then pack the heater in its original container and store it in a cool dry place.

This heater does not disassemble.

ELECTRICAL RATINGS

This product is rated 12.5 amps (1500W) at 120V, 60 Hz.

3 YEAR LIMITED WARRANTY

You should first read all instructions before attempting to use this product.

A. This 3 year limited warranty applies to repair or replacement of product found to be defective in material or workmanship. This warranty does not apply to damage resulting from commercial, abusive, unreasonable use or supplemental damage. Defects that are the result of normal wear and tear will not be considered manufacturing defects under this warranty. KAZ IS NOT LIABLE FOR

INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights which vary from jurisdiction to jurisdiction. This warranty applies only to the original purchaser of this product from the original date of purchase.

B.At its option, Kaz will repair or replace this product if it is found to be defective in material or workmanship.

C.This warranty does not cover damage resulting from any unauthorized attempts to repair

or from any use not in accordance with the instruction manual.

D.Return defective product to Kaz, Incorporated with a brief description of the problem. Include proof of purchase and a $10 US/$15.50 CAN check or money order for handling, return packing and shipping charges. Please include your name, address and a daytime phone number.

You must prepay shipping charges.

We suggest having tracking or delivery confirmation.

Send to:

In U.S.:

Kaz, Incorporated

Attn: Returns Department

4755 Southpoint Drive

Memphis, TN 38118

USA

In Canada:

Kaz Canada, Inc.

Attn: Returns Department

510 Bronte Street South

Milton, ON L9T 2X6

Canada

Please go to www.kaz.com <http://www.kaz.com> and register your product under the Customer Care Center and receive product information updates and new promotional offers.

© 2009 Kaz, Incorporated. All Rights Reserved.

P/N: 31IM0817190

www.sylvane.com (800) 934-9194

Loading...
+ 5 hidden pages