Honeywell Hwm255, Hwm270, Hwm260, Hwm250 Owner's Manual

5 (1)

45%

MODE

WARM MOISTURE HUMIDIFIER

HWM-250, HWM-255, HWM-260,

HWM-270 Series

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS HUMIDIFIER

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1.Always place this humidifier on a firm, flat and level surface. This humidifier may not work properly on an uneven surface.

2.CAUTION: To reduce the risk of burns, place

this humidifier in an area where it is not accessible to children.

3.Do not place the humidifier near any heat sources such as stoves, radiators, and heaters.

4.Before using the humidifier, check the power cord for any signs of damage. If the cord is found to be damaged, DO NOT USE and return the humidifier to the manufacturer under the warranty agreement for repair.

5.This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a

qualified electrician. DO NOT attempt to defeat this safety feature.

6.To disconnect the humidifier, first turn controls to the OFF position, then grip the plug and pull it from the wall outlet. Never pull by the cord.

7.A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.

8.The humidifier should always be unplugged and emptied when not in operation or while being serviced or cleaned.

9.Never tilt or attempt to move the humidifier while it is operating or filled with water. UNPLUG the humidifier before moving.

10.This humidifier requires regular cleaning. Refer to the CLEANING instructions provided. Never clean the humidifier in any manner other than as instructed in this manual.

11.Turn the humidifier OFF if you notice moisture on the inside of your windows. For proper humidity reading use a hygrometer, which is available in many hardware and department stores or by ordering one from the manufacturer (see ACCESSORIES).

12.DO NOT touch the steam vapor. Steam can cause burns.

13.DO NOT block the mist Grill. This will damage the humidifier.

1

Honeywell Hwm255, Hwm270, Hwm260, Hwm250 Owner's Manual

YOUR HUMIDIFIER:

Tank

Medicine

Cup

Cap

45%

 

Power Unit

 

Water Tray

Base

SET-UP:

Note: We recommend that the humidifier be disinfected prior to first use. Please see WEEKLY CLEANING instructions.

Select a firm, level and flat location. For proper air flow, locate the unit at least six inches (15 cm) from any wall. Place the humidifier on a water resistant surface, as

water can damage furniture and some flooring.

Honeywell will not accept responsibility for property damage caused by water spillage.

FILLING:

Remove the Tank from the Power Unit.

Turn the Tank over and unscrew the Cap.

Fill the Tank with cool water.

Reinstall the Cap. Do not overtighten.

Install the Tank back onto the Power Unit.

OPERATION:

POWER

Continuous Run

High Power

Low Power

Press the Power button once to start the humidifier on High Power, Continuous Run.

Press the Power button a second time to change to Low Power, Continuous Run.

Press the Power button a third time to turn the humidifier OFF.

MODE: SET HUMIDITY

Set Humidity

Press the Mode button until the Set Humidity icon blinks. The desired Humidity Level will be displayed.

Use the Up and Down arrow buttons to set a desired humidity level between 40% to 85%.

After the desired humidity level is set, the Humidity Level icon will stop blinking and the current room humidity will appear.

The humidifier will turn off shortly after the desired humidity level is reached and the Power light above the display will blink.

The humidifier will turn back on when the humidity level drops below the desired humidity level. The Power light will stop blinking and remain lit.

2

MODE: TIMER SET

MODE: BACK-LIT

Timer Function

Press the Mode button until the Timer icon blinks. The Hour display will appear

Use the Up and Down arrow buttons to set the humidifier operation time between 1 and 10 hours.

The humidifier will turn-off when time runs out.

The Back-Lit feature provides light to the humidifier display panel and functions in any Power or Mode setting.

Press the Back-Lit button to toggle this feature on and off.

MODE: RESET

Refill Symbol

When the humidifier runs out of water, the Refill symbol will blink.

Remove the water tank. Refill it as described in

FILLING.

Press the Reset button to restart the humidifier.

REMOTE CONTROL OPERATION

Two (2) AAA batteries required.

Models HWM-260, HWM-270 Series

Remote Control included when originally purchased.

Model HWM-255 Series

Remote Control may be purchased at www.honeywellconsumerproducts.com.

The remote control works the same as the corresponding buttons on the Control Panel. The Control Panel display on the humidifier will show the appropriate icons when the various functions are activated.

3

Loading...
+ 4 hidden pages