Hobart WS-80, WS-40 User Manual

5 (1)
SERVICE MANUAL
WS-40/80 Hobart Compact Water Softener Installation Instructions
WS-40 WS-80
- NOTICE -
This Manual is prepared for the use of trained Hobart Service Technicians and should not be used by those not properly qualified.
This manual is not intended to be all encompassing. If you have not attended a Hobart Service School for this product, you should read, in its entirety, the repair procedure you wish to perform to determine if you have the necessary tools, instruments and skills required to perform the procedure. Procedures for which you do not have the necessary tools, instruments and skills should be performed by a trained Hobart Service Technician.
The reproduction, transfer, sale or other use of this Manual, without the express written consent of Hobart, is prohibited.
This manual has been provided to you by ITW Food Equipment Group LLC ("ITW FEG") without charge and remains the property of ITW FEG, and by accepting this manual you agree that you will return it to ITW FEG promptly upon its request for such return at any time in the future.
A product of Hobart Service 701 S. Ridge Ave Troy, OH 45374
F25404 Rev. A (0413)
WS-40/80 Hobart Compact Water Softener Installation Instructions
TABLE OF CONTENTS
INSTALLATION ............................................................................................ 3
INSTALLATION WS-40/80 .............................................................................. 3
DISC REPLACEMENT ...................................................................................... 8
DISC REPLACEMENT WS-40/80 ....................................................................... 8
DISC SELECTION ........................................................................................ 10
DISC SELECTION WS-40/80 .......................................................................... 10
© HOBART SERVICE 2013
F25404 Rev. A (0413) Page 2 of 10
WS-40/80 Hobart Compact Water Softener Installation Instructions - INSTALLATION
INSTALLATION
INSTALLATION WS-40/80
SAVE THESE INSTRUCTIONS
Disconnect the
electrical power to the machine and follow lockout / tagout procedures.
1. Locate water supply line and appropriate drains for softener installation.
2. Install by-pass valving.
5. Install wheel kit on WS-80.
NOTE: Wheel kit for WS-40, already installed.
6. Locate brass in/out adapters, 4 O-rings, and silicone seal lube.
Fig. 3
7. Locate connector hoses and apply 2 to 3 wraps of Teflon tape to the male threads.
Fig. 1
3. Install high temperature prefilter if needed.
Fig. 2
4. Remove all items from shipping package.
Fig. 4
8. Thread the brass in/out adapters tightly onto the threaded ends of the connector hoses.
Page 3 of 10 F25404 Rev. A (0413)
Loading...
+ 7 hidden pages