Qty. |
|
Item No. |
FT-800 SERIES
DISHWASHER
FOOD EQUIPMENT
FT-800 SERIES DISHWASHER WITH ELECTROMECHANICAL CONTROLS
OUTSTANDING STANDARD FEATURES
•Energy saving low water
consumption design—5.7 GPM Hot Water (180°F); 3.9 GPM Low Temp (140°F).
•Stainless steel construction including frame, legs, feet, drain piping, wash arms.
•Electro-mechanical controls in top mounted stainless steel control center.
•36" Load/Unload height.
•Energy efficient convertible hot water or low temp/chemical sanitizing.
•Door actuated drain closers.
•Sealed dial type thermometers for wash—power rinse—final rinse—temperature indication.
•Water and energy saving design through reduced water and tank heat usage and automatic pump shut down control through conveyor.
•Common water, drain, electric and steam connections.
•Exclusive load end flush system.
•Built-in integral wiring channel.
•Automatic temperature control and positive low-water heater and pump seal protection.
•Built-in inherent motor overload protection with manual reset.
•Built-in vent ducts—dampers and drip control.
•Improved washability with high pressure prewash—wash and power rinse systems.
•Compct modular design.
•115 volt pilot circuit.
•Lower prewash arm.
•Automatic initial fill.
•Wash arms easily installed and removed without tools.
•All function components (motors, drains, etc.) located on operators side of dishmachine for accessibility and ease of maintenance.
•Built-in integral prewash water replenishment system.
•Final rinse actuator.
•Removable self-flushing stainless steel strainer pans and large deep scrap buckets for each tank.
•Door interlocks on all doors.
•Optional energy saving blowerdryer.
Electric 20 KW—63% energy reduction.
Steam 75 lbs./hr.—56% energy reduction.
•Choice of electric, steam injection or steam coil heat.
Specifications, Details, Dimensions and Connections inside.
FT-800 SERIES
DISHWASHER
FOOD EQUIPMENT
STANDARD DESIGN FEATURES
TOP MOUNTED CONTROL PANEL –
Controls in top-mounted stainless steel control center with master On/Off Power Switch.
WASH ARMS –Computer-designed prewash, wash and power rinse arms. Arms designed so they can be installed only in correct position.
STOP/START PUSH BUTTONS –Recessed, side located waterproof Start/Stop push |
FLUSH |
DOWN – |
buttons and flip-up hinged dishware platform on both ends of dishwasher. |
Exclusive |
load end |
|
flush down system. |
DRAIN CLOSERS – Door operated drain closers . . . front located drains, stainless steel tank overflow tubing to prewash, and final rinse water feed piping.
PUMP – Self-draining Hobart pump motors with inherent motor protection and manual overload reset push buttons on each motor.
Qty. |
Item No. |
FT-800 SERIES
DISHWASHER
FOOD EQUIPMENT
WIRING CHANNEL –Built-in integral wireway above tank water level.
SCRAP PANS – Large one-piece sloped scrap screens and deep removable recessed scrap buckets for prewash, wash and power rinse tanks.
VENT DUCTS – Built-in vent ducts with adjustable dampers and drip shield on each end of dishwasher. 2" x 24" load end and 4" x 24" discharge end (inside dimensions).
POSITIVE LOW WATER PROTECTION –
Solid state positive low water protection for tank heaters.