Havis-Shields P-MID-1 w, P-MFK-5 User Manual

0 (0)
INSTALL INSTRUCTIONS P-MID-1 w/P-MFK-5
MIDDLE PARTITION w/MOUNTING FILLER PANEL KIT
1997-2008 CHEVROLET/GMC FULL SIZE PASSENGER VANS
TOOLS REQUIRED:
Power drill Drill bit set
HARDWARE: QTY DESCRIPTION PART #
5 ¼” x 1 ½” Hex head Lag Bolt GSM33062 6 ¼” x 1” Hex head Lag Bolt GSM33060 20 ¼-20 x ¾” Carriage Bolt GSM32000 12 ¼-20 Serrated Nut GSM30023 8 ¼-20 Nylock Nut GSM30016 1 5/16-18 Nylock Nut GSM30017 1 5/16-18 x 2” Hex Head Bolt GSM33015 2 5/16 Flat Washer GSM31006 8 ¼” x 1” Fender Washer GSM31014
Passenger Side
Mounting Bracket
Upper Center Steel
Filler Panel
Passenger Side Steel
Door Filler Panel
Main Partition
Frame
Driver Side Upper Lexan Filler Panel
(2-Piece) Driver Side
“B” Pillar Mounting
Driver Side Lower
Steel Filler Panel
Bracket
SUB ASSEMBLY:
1. Remove “C” pillar trim panel. This is necessary for driver side mounting bracket.
2. Position upper center filler to partition and mark mounting holes.
3. Drill 5/16” holes on marks.
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit
INSTALLATION:
1. ATTACH PARTITION TO FLOOR:
Place partition carefully into vehicle behind the first row bench.
Move bottom of partition forward to the back of seat base on first row bench.
Note: Driver side mounting leg on partition will be forward of seat belt hold down on floor of van.
Pre-drill the (3) driver side mounting leg holes with 3/16” drill bit. Be sure to check for obstructions.
Attach partition to van floor at driver side mounting leg using (3) ¼” x 1 ½” Hex head lag bolts.
Proceed to partitions passenger side mounting leg. Be sure to check that partition is square with the bench seat.
Pre-drill the (2) passenger side mounting leg holes with 3/16” drill bit. Be sure to check for obstructions.
Attach partition to van floor at passenger side mounting
leg using (2) ¼” x 1 ½” Hex head lag bolts. Partition is now self-supporting.
2. ATTACH (2- PIECE) DRIVER SIDE “B” PILLAR MOUNTING BRACKET:
Hold 2-piece driver side mounting bracket to partition and “C-pillar” of van.
Determine proper location to mount 2-piece bracket to partition.
Drill (2) 5/16” holes where mounting bracket and partition meet.
Attach bracket to partition using ¼-20 x ¾” Carriage bolts and
¼” x 1 ½” Hex Head Lag Bolts
P-MID-1^MFK-5_INST_9-07
Loading...
+ 2 hidden pages