GE WBSE3120, WWSE5200, WCSE4160, S4200, WSSE5210 User Manual 2

Washers

www.GEAppliances.com

Safety Instructions . . . . . . .	. . . .2
Operating Instructions
Control Panels . . . . . . . . . .	. .3, 4
Control Settings . . . . . . . . .	. .5, 6
Features . . . . . . . . . . . . . . . .	. .7, 8
Loading and Using
the Washer . . . . . . . . . . . . .	. . 8, 9
Troubleshooting Tips . . . . .	10–12

Consumer Support

Consumer Support . . .Back Cover

Product Registration . . . . . .13, 14

Warranty . . . . . . . . . . . . . . . . . .15

Write the model and serial numbers here:

Model # __________________

Serial # __________________

You can find them in the upper right corner on the back of your washer.

Owner’s Manual

S4200

WASE5210

WBSE3120

WCSE4160

WJSE4150

WSSE5210

WWSE5200

WLE4000

175D1807P393 49-90130 03-02 JR

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life.

WATER HEATER SAFETY

Under certain conditions hydrogen gas may be produced in a water heater that has not been used for two weeks or more. Hydrogen gas can be explosive under these circumstances.

If the hot water has not been used for two weeks or more, prevent the possibility of damage or injury by turning on all hot water faucets and allowing them to run for several minutes. Do this before using any electrical appliance which is connected to the hot water system. This simple procedure will allow any built-up hydrogen gas to escape. Since the gas is flammable, do not smoke or use an open flame or appliance during this process.

PROPER INSTALLATION

This washer must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions sheet, you can receive one by visiting

GEAppliances.com, or by calling 800.GE.CARES (800.432.2737).

■ Install or store where it will not be exposed to	■ Properly ground washer to conform with all
temperatures below freezing or exposed to	governing codes and ordinances. Follow details
the weather.	in Installation Instructions.

YOUR LAUNDRY AREA

■ Keep the area underneath and around your	■ Close supervision is necessary if this appliance is
appliances free of combustible materials such as	used by or near children. Do not allow children
lint, paper, rags, chemicals, etc.	to play on, with, or inside this or any other
	appliance.
WHEN USING THE WASHER

Use this appliance only for its intended purpose as described in this Owner’s Manual.

■Never reach into washer while it is moving. Wait until the machine has completely stopped before opening the lid.

■Do not mix chlorine bleach with ammonia or acids such as vinegar and/or rust remover. Mixing different chemicals can produce

a toxic gas which may cause death.

■Do not wash or dry articles that have been cleaned in, washed in, soaked in or spotted with combustible or explosive substances (such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.) which may ignite or explode. Do not add these substances to the wash water. Do not use or place these substances around your washer or dryer during operation.

■The laundry process can reduce the flame retardancy of fabrics. To avoid such a result, carefully follow the garment manufacturer’s wash and care instructions.

■To minimize the possibility of electric shock, unplug this appliance from the power supply or disconnect the washer at the building’s distribution panel by removing the fuse or switching off the circuit breaker before attempting any maintenance or cleaning. NOTE: Turning the Cycle Selector Knob to an off position, or pressing PAUSE does NOT

disconnect the appliance from the power supply.

■Never attempt to operate this appliance if it is damaged, malfunctioning, partially disassembled, or has missing or broken parts, including a damaged cord or plug.

WHEN NOT IN USE

■Turn off water faucets to relieve pressure on hoses and valves and to minimize leakage if a break or rupture should occur. Check the condition of the fill hoses; they should be replaced every 5 years.

■Before discarding a washer, or removing it from service, remove the washer lid to prevent children from hiding inside.

■Do not attempt to repair or replace any part of this appliance unless specifically recommended in this Owner’s Manual, or in published user-repair instructions that you understand and have the skills to carry out.

■Do not tamper with controls.

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

2 SAVE THESE INSTRUCTIONS

About the washer control panel.		GEAppliances.com

•Add detergent

•Add diluted fabric softener (on models with a fabric softener dispenser)

			• Select load size and
	• Add clothes
			other wash options
			• Select wash cycle

Quick Start Guide

•Close lid

•Push START

NOTE: When making a selection with any knob, simply point the knob anywhere within the shaded range for that setting.

Model WBSE3120

Model WCSE4160

Model WJSE4150

3

Instructions Safety

Instructions Operating

Tips Troubleshooting

Support Consumer

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

About the washer control panel.

Model WWSE5200

Model S4200

Model WASE5210

Model WSSE5210

4

About the control settings.

GEAppliances.com

Model WLE4000

Color Logic (on some models)

Select the correct TEMPERATURE setting. Match the particular color below the words with the same color on the WASH/SPIN SPEED setting. Next, match the color again with the same color on the Cycle Selector knob.

Example: Washing a load of medium-soiled cotton towels and sheets.

		Choose the LOAD SIZE.
	1
		Choose the TEMPERATURE setting—for this load it would be the HOT COLD (which is a particular color).
	2
		On some models, choose the WASH/SPIN SPEED setting that matches that color—for this load it would
	3
		be the NORMAL FAST.
		Turn the Cycle Selector knob to the area that has the same color as the TEMPERATURE and WASH/SPIN
	4
		SPEED settings you have chosen—for this load it would be the COTTONS area. Turn the knob to the

MEDIUM setting.

Load Size

Loosely load clothes no higher than the top row of holes in the washer tub. The water level should just cover the clothes. Adjust the load size accordingly.

Custom Care Wash/Spin Speeds

The agitator moves clothes around for a cleaner wash; the basket spins later in the cycle to release water from the load. On some models, the Wash/Spin Speed dial sets the speed of both the agitator and the basket. On some models, the Wash/Spin speed settings are located on the

Cycle Selector knob.

Wash Speeds

With Normal Speed, the agitator will move at a high speed for the first few minutes, then it slows down to a moderate speed. This gets your clothes clean while reducing wear on your clothing. Use for cottons, denims and play clothes.

With Gentle Speed, the agitator moves slower. Use for delicate and knit items.

With Casuals, the agitator will agitate and then pause to soak your clothes. It provides a gentler way to wash your wrinkle-free and permanent press items and knits.

Spin Speeds

The Fast spin speed is for normal items. Use it to remove more water from your clothes to allow them to dry faster in the dryer.

The Slow spin speed is for delicate items like sweaters and lingerie. When using Slow spin speed, clothes will be less dry than when using Fast spin speed.

5

Instructions Safety

Instructions Operating

Tips Troubleshooting

Support Consumer