BarkLimiter Deluxe
BarkLimiter
™
Series
Owner’s Manual
May 2013 190-01554-00_0C Printed in Taiwan
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the
right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such
changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product.
Garmin
®
and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. BarkLimiter™ and Bark
Odometer™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.
Introduction
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Device Overviews
BarkLimiter Device
À
Contact points
Á
Mode and intensity dial
Â
Status LED
BarkLimiter Deluxe Device
À
Contact points
Á
Mode and intensity dial
Â
Status LED
Ã
Charging clip contacts (BarkLimiter Deluxe model only)
Attaching the Dog Collar Device to the Collar
Strap
1
With the buckle
À
facing outward, insert the end of the collar
strap through the slot
Á
on the collar device.
2
Pull approximately two-thirds of the collar strap through the
slot.
3
Insert the end of the collar strap through the slot
Â
on the
opposite side of the device.
4
Pull the strap until it is tight across the front of the device.
Charging the BarkLimiter Deluxe Device
NOTICE
To prevent corrosion, thoroughly dry the contacts on the collar
and the surrounding area before connecting the charging clip.
Before you put the collar on the dog, remove the charging clip. If
you do not remove the clip, it may become detached from the
collar and become lost.
You should fully charge the battery before you use the device
for the first time. Charging a fully depleted battery takes about
two hours. The device will not charge when outside the
temperature range of 32° to 104°F (0° to 40°C).
1
Snap the charging clip
À
onto the device.
2
Plug the small end of the power cable into the mini-USB port
Á
on the charging clip.
3
Plug the other end of the power cable into a power source.
The status LED is solid red when the collar is charging.
4
After the status LED turns solid green, remove the charging
clip from the collar.
Turning On the Dog Collar Device
Rotate the dial away from N.
There is a 30-second delay before the device becomes active.
The status LED indicates the battery charge level for five
seconds and turns off. After an additional 25 seconds, the unit is
active. The status LED flashes occasionally to indicate that the
unit is detecting sound, motion, or vibration.
Turning Off the Dog Collar Device
Rotate the dial to N.
Rotating the Dial
NOTICE
Do not over-rotate the dial. The dial does not rotate past 7.
The dial is intentionally difficult to rotate. This helps to prevent
accidental rotation while the device is in use on the dog.
Insert a coin or similar object into the slot to rotate the dial.
Bark Correction
When the device is active and properly fitted on the dog, it
detects and corrects barks automatically. You can adjust the
method and intensity of the corrections.
The status LED flashes briefly when the device detects motion
or corrects a bark.
Short flash Motion was detected, and no correction was applied.
Long flash A bark was detected, and a correction was applied.
Introduction 1
Loading...