FMWHS3
Hand Strap
Installation Instructions
PenCentra 130 and 200
The hand strap can be attached to your PenCentra 130 or PenCentra 200 pen tablet to provide additional support while using the system in a hand-held position.
Installing the Hand Strap
The hand strap can be installed in on of two locations on the pen tablet to accommodate rightor left-handed users. To install the hand strap,
1.Using a sharp object such as a penknife, pry the round, adhesive covers from the back of the system to expose the screw bosses in the location that you want to install the hand strap. See Figure 1 for the screw boss locations.
Serial
Port
Door
|
|
|
Left Handed User |
Removable |
|
Right Handed User |
Battery Pack |
|
|
|
|
|
|
|
Figure 1. Hand Strap Fastening Points
2.Use the screws provided to attach the hand strap in the desired location as shown in Figure 2.
3.The hand strap is now attached to your system.
Using the Hand Strap
4.If you are a right-handed user, install and use the hand strap as shown in Figure 3. The Velcro strip on the hand strap allows you to adjust the strap to the most comfortable position. If you are a left-handed user, install and use the hand strap as shown in Figure 4.
Figure 2. Installing the Hand Strap
.
Figure 3. Using the Hand Strap (Right-handed User)
Figure 4. Using the Hand Strap (Left-handed User)
PenCentra 130 and PenCentra 200 are trademarks of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation
6/00 |
58-0687-00B |
Loading...