P10SA
Table of Contents
Important Safety Guidelines………….………. 2
Introduction……………………………………………. 3
Unpacking Instructions & Contents .………. 4
Parts ……………............................................ 5
Display Functions …………………………………… 6
Remote Control Functions ………..…..………. 9
Drain Pipe ………………………….……..…..………. 12
Maintenance & Cleaning………………………... 13
Installation …………………………………………….. 14
Troubleshooting……………………………………..
16
P08S/P10S Owner’s Manual
98081002_02
IMPORTANT
Do not install and use your portable air conditioner unit before carefully reading this instruction guide.
Please retain this manual brochure for product warranty and future reference
IMPORTANT SAFETY GUIDELINES
2
CAUTION
Operate this unit in an ambient of 89°F or less.
The heating function of the unit should be
operated in an indoor ambient temperature
between 44°F and 73°F.
Clean air filter periodically to enjoy the most
efficient cooling.
When the unit is shut off, please wait at least 3.5
minutes before restarting; this is to prevent the
compressor from being damaged.
This unit is for indoor cooling, heating and
dehumidifying.
When turning on the unit, the fan will operate but
the compressor will start up after the cooling
alarm flashes for three minutes.
In heating function, the heating alarm will flash for
3.5 minutes before the compressor and fan start
up.
If you have fuses , they should be of the time delay
type. Before you install or relocate this unit, be sure
that the amperage rating of the circuit breaker or
time delay fuse does not exceed the amp rating
listed in Table 1.
Table 1.
MODEL
CIRCUIT
RATING OR
TIME DELAY
FUSE
REQUIRED
WALL
RECEPTACLE
AMP VOLT
NEMA
NO.
P08S,P10S
15
125
5-15P
INTRODUCTION
Congratulations on your purchase and welcome to Friedrich!
ZoneAire Compact: PORTABLE AIR CONDITIONER
The Air Conditioner has been designed and manufactured to the highest standards of modern
engineering.
Our product not only provides you a remote control to help user operate all the functions easily and
conveniently but also includes the following benefits:
• 3-IN-1 SYSTEM: Offers cooling, dehumidification bonus heat for year-round
conditioning
and comfort.
• Innovative design: One side offers cooling, simply turn the unit around and apply the exclusive
“heat clip“ for bonus heat option.
• Super portability with built in hose storage compartment underneath unit.
• Dual, easy-access antimicrobial nylon filters
• 4-Speed fan with “Auto” setting for ultimate comfort
• 24-hour timer for both cooling and dehumidification
• Unique Sleep Control function – Increases temperature 2 degrees every 4 hours
• LCD remote control
• Moves easily from room to room on easy glide castors.
3
and
UNPACKING INSTRUCTIONS & CONTENTS
UNPACKING INSTRUCTIONS
1. Place the unit in the correct upright position before unpacking.
2. Cut the two packing straps.
3. Slide the carton in an upward motion and it will release from the base.
4. Grip the carry handles located on either sides of the unit and carefully lift until it slides out of
the foam base.
5. Lift and lean the unit slightly to take out exhaust hose from unit’s bottom as picture.
6. Install the exhaust hose on the unit before operating the unit.
CONTENTS
1. Air conditioner unit
2. Exhaust Hose
3. Remote control
4. Batteries
5. Window Kit
6. Heat Clip Connector
4
Exhaust Hose
Heat Clip
Window Kit
PARTS
1. Control panel
2. Remote control receiver
3. Hot air-outlet
4. Evaporator’s filter
5. Cool air-inlet
6. Air-outlet’s joint part
7. Cool air-outlet
8. Condenser’ s filter
9. Hot air-inlet
10. Drain hole
5
DISPLAY FUNCTIONS
KEY
Press to turn unit "ON" or "OFF".
2. MODE
Press this key to select cooling, heating, or dehumidifying.
3. TEMPERATURE REGULATION KEY (UP)
- During cooling function：This key raises the preset temperature by 1°F each time it is pressed
and the maximum limit is 86°F.
- During heating function：This key raises the preset temperature by 1°F each time it is pressed
and the maximum limit is 77°F.
4. TEMPERATURE REGULATION KEY (DOWN)
- During cooling function：This key lowers the preset temperature by 1°F each time it is pressed
and the minimum limit is 63°F.
- During heating function：This key lowers the preset temperature by 1°F each time it is pressed
and the minimum limit is 59°F.
5. L.E.D. DISPLAY
The display indicates the current setting temperature or the timer setting. When the set
temperature or the timer is adjusted, the new setting is shown then the display returns the
current set temperature.
6
※ The display is also used to show error codes should a fault occur, see TROUBLE SHOOTING.
1. ON/OFF
when the unit is not working, hold the function button for 10
seconds to change the temperature
scale /°F.°C
Loading...