Fisher & Paykel APEX RH900 User Manual

Size:
605.28 Kb
Download

I N S T A L L A T I O N

I N S T R U C T I O N

 

 

APEX MODEL RH900 CQ SS

 

NZ/AUS Code

87947

 

UK Code

88793

 

EU Code

88955

 

APEX MODEL RH900 CM SM

 

NZ/AUS Code

87948

 

UK Code

88794

 

EU Code

88956

 

PLEASE READ THE ENTIRE INSTRUCTION BEFORE INSTALLING THE CANOPY

 

 

P R O D U C T

D I M E N S I O N S

 

 

 

 

 

 

 

 

 

 

290

 

 

 

 

 

330

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

780 min 1064 max

21

115

488

897

528

All Dimensions in mm

C A N O P Y O P E R A T I O N

Thank you for purchasing a quality stainless steel or iridium canopy rangehood. We have a high standard of quality control and each rangehood is tested and approved before it leaves the factory.

IMPORTANT: Please read prior to installation or operation

• Always switch power off prior to installing, servicing or cleaning the appliance.

Never use the appliance without filters.

Please read the notes on general cleaning, especially the filters.

Exhaust air must not be discharged into a heating flue or wall cavity, unless the cavity is designed for that purpose.

Areas where the rangehood is installed that also have gas, oil or coal fired heaters, must be well ventilated to prevent a partial vacuum in the room. This includes gas hobs. (A partial vacuum in the room could result in too high a concentration of gas in the air).

The appliance is supplied with an approved power cable which must not be changed. If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer

or its service agent or similarly qualified person in order to avoid hazard .

M A I N T E N A N C E

Particular care must be taken with grease filters which must be periodically cleaned (at least every two months). Remove the grease filters and wash them either by hand or in the dishwasher using mild detergent. In case of Charcoal Filter, it is a disposable item and should be replaced when cleaning the rangehood. Use lukewarm water and mild detergent to clean stainless steel components. In high humidity and coastal environments, cleaning should be carried out frequently.

CAUTION: Never use abrasive or oil based liquid cleaners.

USE

Care and attention should always be taken when cooking with oils, alcohol, etc; which give off flammable vapours.

Pre-usedoil is especially dangerous in this respect. Do not use uncovered electrical grill.

To avoid possible risks of fire always comply with the maintenance instruction above.

When making the electrical connection, check that the socket has an earth connection and that the voltage values correspond to those indicated on the rating plate inside the appliance. The appliance must be positioned so that the electrial plug is accessible.

C O N T R O L P A N E L

Left Push Button

=

Light On/Off Switch

Second Push Button

=

Fan On High Speed

Third Push Button

=

Fan On Second Speed

Fourth Push Button

=

Fan On Low Speed

Fifth Push Button

=

Fan Off

I N S T A L L A T I O N O F U N I T

The unit is designed for 2.4 to 2.65 metre high ceiling. The decorative chimney cover is telescopic and is designed for 665 to 950mm adjustment.

Note: Ducting accessories are not supplied. Please refer to the optional ducting kits. The air outlet from the motor requires 150mm round ducting which requires 160mm diameter round hole in the ceiling . This hole will be covered by the decorative chimney. Care should be taken to align canopy with decorative chimney allowing sufficient clearance to accommodate the flexible ducting.

Before starting assembly, read the instructions carefully and remove the filters from canopy to allow access to wall mounting holes. To remove the filters, pull the relative catch and tilting it downwards until it disengages from the supports. Reverse these instructions when refitting the filters.

Stainless steel/iridium is very easily damaged during installation if abraided or

knocked by tools.

104385 issue H ECN: 04 036

I N S T A L L A T I O N O F T H E U N I T

DUCTING

RECIRCULATING

OPTION

 

OPTION

 

2.4 TO 2.65 METRE HIGH CEILING

 

TOP

 

GUIDE

A

200mm

700mm UNDERSIDE OF HOOD TO COOKING SURFACE

RECIRCULATING

DUCTING

WARNING: The distance between the hob and the mounting holes of the canopy to be at least 900mm to ensure that the fully installed canopy has a clearance of 7 0 0 m m ( r e c o m m e n d e d h e i g h t ) b e t w e e n t h e l o w e r pa r t o f t h e h o o d a n d t h e cooking hob. Before drilling any holes check the wall and the ceiling are clear of a n y e l e c t r i c a l c a b l e s , p i p e s e t c . F i x i n g t o a s o l i d s t u d i s r e c o m m e n d e d . A

Fix the mounting washers in position shown in diagram. 1 Check with spirit level accross the washers to ensure they are level.

INSTALLING DUCTING

NOTE: All ducting must comply with local requirements and building codes . Mark the position of decorative chimney at ceiling and wall, cut cornice moulding away if necessary to enable panels to fit flat against the wall and ceiling. 2 Mark and cut the hole in the ceiling to fit the ducting (155 to 160mm dia). 3 This is positioned centrally with the canopy and 100mm from the wall.

INSTALLING CEILING BRACKET

Using the supplied screws, fix the ceiling bracket 4 to the wall, checking that it is aligned with the hood.

FINAL ASSEMBLY

Remove protective plastic covering from all parts including filters. Now fit the canopy on the fixed mounting washers. 5 Plug in power cord at power supply. Check function of rangehood light and motor, before continuing assembly. Fix safety screw 5 connect 150mm ducting 6 to top of motor flange secure with cable tie. Assemble the telescopic ducting covers (chimney) 7 to accurately suit the dimension required, 8 fit black plastic extrusion to the base and top of the chimney and cut to length. 9 Mounting screws and plastic cover caps are applied on top and bottom of the chimney.

L a m p R e p l a c e m e n t

a)Switch off the power to the rangehood.

b)Use a small bladed screwdriver to prise off the light cover (note slot).

c)Use a cloth to remove the bulb. Do not touch the bulb with fingers.

d)Replace with a new bulb and “snap” the cover back into place.

e)Halogen bulb 12Volt/20Watt required.

BULB

P a r t s

&

S e r v i c e

FILTERS

Aluminium Filter - No. R104163 (Ducted models) Charcoal Filter No. R104165 (Recirculated models) The use of charcoal filter is recommended on recirculating model rangehoods.

DUCTED

UNIDUCT FLEXI DUCT FIT is recommended. 1569 Flexi Duct Kit (150mm)

RECIRCULATED

Use manufacturer Part No. 89504

 

NOTE: TAB ON

DETAIL 1

BOTH SIDES TO BE

BENT IN TO LOCK

 

DUCT IN PLACE

SEE DETAIL1

Rercirculating

Kit 89504

6

For other Accessories, Parts or Service, please contact your local supplier. (Refer to the Warranty Certificate)

W A R N I N G

T h i s a p p l i a n c e i s n o t i n t e n d e d f o r u s e b y y o u n g c h i l d r e n o r i n f i r m p e r s o n s

w i t h o u t s u p e r v i s i o n .

Yo u n g c h i l d r e n s h o u l d b e s u p e r v i s e d t o e n s u r e t h a t t h e y d o n o t p l a y w i t h

t h e a p p l i a n c e .

T h e r e s h a l l b e a d e q u a t e v e n t i l a t i o n o f t h e r o o m w h e n t h e r a n g e h o o d i s

 

u s e d a t t h e s a m e t i m e a s a p p l i a n c e s b u r n i n g g a s o r o t h e r f u e l s .

• Yo u m u s t r e a d t h e d e t a i l s c o n c e r n i n g t h e m e t h o d a n d f r e q u e n c y o f

c l e a n i n g .

T h e r e i s a f i r e r i s k i f c l e a n i n g i s n o t c a r r i e d o u t i n a c c o r d a n c e w i t h t h e

 

i n s t r u c t i o n s .

• D o n o t f l a m b é u n d e r t h e r a n g e h o o d .

E x h a u s t a i r m u s t n o t b e d i s c h a r g e d i n t o a n e x i s t i n g f l u e w h i c h i s u s e d

 

f o r e x h a u s t i n g f u m e s f r o m a p p l i a n c e s b u r n i n g g a s o r o t h e r f u e l s .

• T h e m i n i m u m d i s t a n c e b e t w e e n t h e h o b s u r f a c e a n d t h e l o w e s t p a r t o f

 

t h e r a n g e h o o d i s 6 0 0 m m .

T h i s d i s t a n c e s h a l l b e a t l e a s t 6 5 0 m m

( r e c o m m e n d e d 7 0 0 m m ) i f t h e r a n g e h o o d i s i n s t a l l e d o v e r a g a s h o b .

A t t e n t i o n s h o u l d b e g i v e n t o e n s u r e t h a t a n y a p p l i c a b l e r e g u l a t i o n s

c o n c e r n i n g t h e d i s c h a r g e o f e x h a u s t a i r i s f u l f i l l e d .

 

I f t h e s u p p l y c o r d o f t h i s e q u i p m e n t i s d a m a g e d , i t m u s t o n l y b e r e p l a c e d

 

b y t h e m a n u f a c t u r e r o r i t s s e r v i c e a g e n t o r s i m i l a r l y q u a l i f i e d p e r s o n i n

 

o r d e r t o a v o i d a h a z a r d .

 

 

 

 

 

 

MANUFACTURED FOR

 

 

 

 

 

Electrical Rating:

 

 

 

BY:

346W (1.44A)

 

 

ROBINHOOD LIMITED

Max. at 230-240V50Hz

 

RECOMMENDED UNIDUCT DUCTING

6 ZELANIAN DRIVE, EAST TAMAKI

 

 

AUCKLAND, NEW ZEALAND

 

 

SYSTEMS FOR RANGEHOODS

104385 issue H

 

 

ISO9001 Certified

ECN: 04 036