PS60-2 PS60C-2
ENGLISH
FRANÇAIS
ESPAÑOL
Please read these instructions before use. Veuillez lire ce Mode d’emploi avant utilisation. Favor de leer estas instrucciones antes del uso.
D
C H
E
G
F
A
B 
ENGLISH
Dear Customer,
Thank you for buying a Fellowes Personal Shredder. We have made many improvements in our personal shredder since its introduction in 1990 as the first of its kind on the market.
We are confident that it offers you the greatest value for your money in its product category today. We hope it meets – or even exceeds – your expectations.
To ensure years of safe, efficient use, please read these few pages about your new shredder. If this manual doesn’t answer all your questions or if you wish to comment on this product, we welcome your call or letter.
Sincerely,
James Fellowes
Chairman & CEO
Contents
Product Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Set-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
2
Product Profile
This product is built to shred paper, staples, small paper clips and credit cards. It is not built to take large paper clips, continuous forms, adhesive labels, transparencies, newspaper, cardboard or any plastic other than credit cards. Using it for these purposes is likely to cause irreparable damage.
|
Strip-cut |
Confetti-cut |
|
(PS60-2) |
(PS60C-2) |
Sheet capacity* |
12 sheets |
8 sheets |
Paper shred size |
7/32" (5.8 mm) |
5/32" x 1-3/8" (3.9 x 35 mm) |
Maximum paper width |
9" (229 mm) |
9" (229 mm) |
Recommended daily capacity |
25-50 shredding passes |
|
Maximum running time |
|
10-12 minutes |
Automatic cool-down period |
|
20 minutes |
Voltage |
120V/60H/2.5A |
120V/60H/5.0A |
*Based on 20 lb., 8-1/2" x 11" paper with shredder operating at rated voltage; heavier paper, high humidity, or other than rated voltage may reduce sheet capacity.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
While setting up shredder
•Check shredder for damage or defects; some paper particles in the basket are normal due to product testing and does not indicate a defect.
•Avoid touching exposed blades on underside of confetti-cut shredder head.
•Plug power cord in an outlet that can easily be reached.
•Do not place shredder near or over a heat or water source.
While operating shredder
• Keep hands and hanging objects (jewelry, ties, loose clothing, long hair, etc.) away from paper entry.
• Keep children and pets away from the shredder.
When not in use
•Always turn off and unplug shredder
•Unplug before emptying basket
•Do not open shredder head: Danger of electric shock.
NOTE: Do not use flammable synthetic oil, petroleum-based products or aerosols of any kind on or near product at any time.
ENGLISH
3
ENGLISH
Set-Up
For safety reasons, this model will operate only if the shredder head is in the correct position on the basket. Align slot (A) at the back of the shredder head with tab (B) on the back of the basket and place it onto the basket in this position.
Operation
For convenience, your shredder is equipped with an automatic-start sensor (C). This means that when the control switch (D) is on automatic [I] position, the shredder will start running when you put paper into it and stop a few seconds after the paper has passed through. Because the sensor cannot tell the difference between paper and other objects, this feature can also be a hazard, especially to children and pets. To avoid accidents, turn off the shredder as soon as you are finished. Unplug shredder if it will not be used for an extended period.
To shred
•Plug in shredder with control switch (D) in off [O] position
•Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds to signal readiness and green light (H) will turn on.
•Feed paper straight into entry (E), until the shredder automatically begins shredding; see Product Profile for limits on paper width, shreddable items, sheet capacity, etc.
•Shred for no more than 10-12 minutes; shredding longer will cause shredder to turn itself off for 20 minutes to cool down.
•Press control switch to off [O] position after cutting has stopped. With confetti-cut shredder, cutting continues for several seconds after paper has gone through in order to clear shredded paper from cutting cylinders.
In case of a paper jam, which may occur if the shredder is pushed beyond its specified capabilities, press the control switch to the off [O] position and empty the basket if full. Then:
1)Press and hold control switch in reverse [R] position and attempt to back paper out of shredder.
2)If shredder jams in reverse mode, press control switch to automatic [I] position and attempt to continue shredding operation.
3)If shredder jams again, alternate control switch slowly between reverse [R] and automatic [I] positions to attempt to move jammed paper completely through shredder.
If you are unable to clear the jam using this method, turn off and unplug the shredder; remove shredder head from the wastebasket and carefully remove any paper extending below the cutting cylinders; empty the wastebasket; reassemble the shredder and repeat jam clearing procedure.
4
Maintenance
Regular emptying of the basket is important to ensure the smooth operation of the cutting cylinders. If you can see paper in the basket window (F), turn off and unplug the shredder, remove the shredder head and empty the basket.
Regular oiling of the confetti-cut model (PS60C-2) is also necessary to ensure proper performance. If you are running the shredder at or near capacity, we recommend oiling it monthly. Using Fellowes Powershred Lubricant #35250 or other non-aerosol vegetablebased oil in a long-nozzle container:
•Apply oil over full width of paper entry (E) with shredder in off [O] position.
•Press control switch to automatic [I] position which will cause shredder to run for about 2 seconds.
•Press and hold control switch in reverse [R] position for 3-5 seconds.
•Repeat above automatic [I] and reverse [R] sequence three times.
REMINDER: Do not use flammable synthetic oil, petroleum-based products or aerosol lubricants of any kind in or near the shredder at any time.
Troubleshooting
If you have a problem with your shredder, check the symptoms and remedies below. If you cannot solve the problem this way, contact Fellowes Customer Service. Do not open shredder head to attempt repair: It could expose you to serious electric shock and will void your warranty.
|
Symptom |
Remedy |
|
|
|
Shredder does not start or stops while |
• |
Make sure shredder is plugged in and |
|
|
shredding. |
|
switch is in automatic [I] position. |
|
|
|
• |
If paper appears to be jammed. Follow |
|
|
|
|
instructions under Operation. |
|
|
|
• |
Check shredder head position (confetti- |
|
|
|
|
cut model only). Follow instructions |
|
|
|
|
under Set-Up. |
|
|
|
• |
Wait 25 minutes for shredder to cool |
|
|
|
|
down before trying again. |
|
|
|
|
|
|
|
Red display light (G) turns on and shredder |
• |
If paper appears to be jammed. Follow |
|
|
will not operate. |
|
instructions under Operation. |
|
|
|
• |
Check shredder head position (confetti- |
|
|
|
|
cut model only). Follow instructions |
|
|
|
|
under Set-Up. |
|
|
|
|
|
|
|
Shredder squeaks, grinds or runs below |
• Oil cutting cylinders (confetti-cut model |
|
|
|
capacity. |
|
only). Follow instructions under |
|
|
|
|
Maintenance. |
|
|
|
• Check window. If paper is visible, empty |
|
|
|
|
|
basket. Follow instructions under |
|
|
|
|
Maintenance. |
|
|
|
|
|
|
|
Shredder continues to run for a few sec- |
No action required. This is a self-cleaning |
|
|
|
onds after shredding has been completed. |
function. |
|
|
ENGLISH
5
ENGLISH
Warranty
Fellowes, Inc. (“Fellowes") warrants the cutting cylinders of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warrant period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. You may have other legal rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide, except where different limitations, restrictions or conditions may be required by local law. For more details or to obtain service under this warranty, please see below.
Fellowes offers customer service in the United States, Canada, Mexico, Australia, the United Kingdom and Continental Europe. Please refer to the back of this manual for contact information.
You may also contact your local dealer, contact us online at www.fellowes.com or write to us at:
Fellowes, Inc.
ATTN: Customer Service
1789 Norwood Avenue
Itasca, IL 60143
USA
6
Loading...