WPD Series Wallplates • Installation Guide
The Extron WPD Series (WPD 110 A, WPD 120 A, WPD 130 A and WPD 140 A) are single gang pass-through wallplates with HDMI, DisplayPort, DVI or VGA front connectors and pigtail mounted rear connectors. All models can be installed in single gang junction boxes, and include a Decora®-style trim plate. The models are as follows:
|
DVI |
DISPLAYPORT |
COMPUTER |
|
|
A |
|
|
B |
A B C |
A B C |
C |
A B C |
e |
e |
e |
e |
WPD 110 A |
WPD 120 A |
WPD 130 A |
|
WPD 140 A |
Side View |
|
|
zz WPD 110 A — HDMI, stereo audio, and control
оо HDMI female to HDMI female connector on a pigtail
оо 3.5 mm stereo audio jack with 3-pole captive screw connector
оо 3-pole captive screw connector (for pass-through signals such as IR and RS-232)
zz WPD 120 A — DisplayPort, stereo audio, and control
оо DisplayPort female to DisplayPort female connector on a pigtail оо 3.5 mm stereo audio jack with 3-pole captive screw connector
оо 3-pole captive screw connector (for pass-through signals such as IR and RS-232)
zz WPD 130 A — DVI, stereo audio, and control
оо DVI-I female to DVI-I female connector on a pigtail
оо 3.5 mm stereo audio jack with 3-pole captive screw connector
оо 3-pole captive screw connector (for pass-through signals such as IR and RS-232)
zz WPD 140 A — VGA, stereo audio, and control оо 15-pin VGA female connector on a pigtail
оо 3.5 mm stereo audio jack with 3-pole captive screw connector
оо 3-pole captive screw connector (for pass-through signals such as IR and RS-232)
Install the wallplate directly into the wall using the supplied mud ring or a UL-listed 1-gang junction box (not supplied). Follow the steps in the “Installation” section on page 2.
Planning — Check the Proposed Installation Location
Before starting the installation it is important that you do the following:
CAUTION: Risk of Personal Injury. Failure to check the items listed below may result in personal injury.
ATTENTION: Failure to check the items listed below may result in property damage.
cEnsure there are no utility cables or pipes at the intended location that might be damaged or cause injury when you are installing the device.
cCheck that the installation meets the local and state regulatory requirements, including building, electrical, and safety codes, and UL and ADA accessibility requirements.
CONTINUED ON PAGE 2
Loading...