Epson Stylus® NX300/305 Series
Start Here
Read these instructions before using your product.
Power cord |
USB cable |
Caution: Do not open the ink cartridge package until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press theOn button.
*411852500*
*411852500*
Stop/
Clear Settings
B&W
Fax
Color
1Pressorto select your language, then press OK.
2Press or to select your country or region, then press
OK.
3Press or to select Summer if your region uses Daylight Saving Time and it’s currently in effect. (DST is effective from spring through summer.) Otherwise select Winter to turn off the setting.
4Press OK.
5Pressorto select the date format, then press OK.
6Use the numeric keypad to change the date, then press OK.
7Press or to select a 12-hour or 24-hour time format, then press OK.
8Use the numeric keypad to set the time.
If you chose a 12-hour time format, press or to select
AM or PM.
9Press OK.
1 Lift up the scanner.
2 Open the cartridge cover.
3 Shake the ink cartridges, then unpack them.
4Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
5Insert the cartridges in the holder for each color.
6 Press each cartridge down until it clicks.
7Close the ink cartridge cover and press it down until it clicks.
8Lower the scanner.
9Press the OK button to charge the ink. Charging takes about 2 minutes.
Note: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is charging or you’ll waste ink.
1 Open the paper support and pull up the extensions.
2Open the output tray, pull out the extension, and raise the paper stopper.
3 Pinch the edge guide and slide it to the left.
4Load paper against the right edge guide and behind the tab, with the printable side face up.
8½ x 11
4 x 6
Note: Don’t load the paper sideways; always load it short edge first.
5 Slide the edge guide over.