Important Setup Information
Network Connection (Wireless or Wired)
1.If you’re connecting to a network, use the Ethernet cable that came with your product.
IMPORTANT:
Connect the cable for wireless or wired networks. For a wireless connection, you’ll remove the cable later.
2.Set up your product using the Start Here sheet. DO NOT follow the software installation steps under “USB connection.”
3.Install your software using the Network Installation Guide.
For a variety of network setup information, go to: www.epson.com/support/wireless
Direct Connection (USB)
1.If you are NOT installing your product on a network, connect it using a USB cable (not included).
You can purchase a USB cable at most electronics stores.
2.Set up your product and install your software as described on the Start Here sheet.
Ethernet network cable (included)
USB cable (not included)
CPD-26557 Printed in/Pays d’impression : Indonesia
Loading...