Operation (Figure 3)
IMPORTANT
Fan installation must be completed, including the installation of the fan blades, before testing the remote control.
Your remote control has full control of your fan and light.
NOTE: Prior to operation of the fan and
light from the remote control, set the fan speed to HIGH (....) and turn the light ON
( 
).
1.To set the desired fan speed, press one of the four buttons (., .., ..., ....) to operate your fan from low to high speeds.
2.To turn the downlight on, press and
release the ( 
) button. The light will turn on at the light intensity previously selected.
3.To vary the intensity of the light, hold the
( 
) button down until the desired light intensity is reached, then release the button.
Note: When turning the light on, light will turn on at the light intensity previously selected.
Trouble Shooting
Fan/Light Fails to Operate
• Check that the speed switch on the fan is set to HIGH (....) speed.
•Check that the light switch is on.
•Check that the battery is good
(power indicator light should light when any button is pressed).
•Check that the receiver is wired properly.
•Check that code switches in the remote control and receiver are set in the same position.
Short Range
•If the remote control operates the fan when close to it, but does not operate it at a distance of 40 feet, try placing the antenna wire outside of the ceiling cover.
Installation of Storage
Bracket
A storage bracket is provided for holding your remote control when not in use. If you desire to use the bracket, install it on a wall that is away from excess heat or humidity.
COVER |
TO INSTALL |
|
BRACKET TO WALL: |
WALL |
SLIDE THE COVER UP |
TO EXPOSE THE |
|
BRACKET |
SCREW HOLES FOR |
SCREW |
INSTALLATION |
HOLES (2) |
|
POWER |
|
INDICATOR |
|
LIGHT |
|
FAN |
|
BUTTON |
|
HIGH TO LOW
BUTTONS
LIGHT
BUTTON
STORAGE
BRACKET
Figure 3
Air Comfort Products
DIVISION OF EMERSON COMPANY
8100 W. Florissant • St. Louis, MO 63136
CAUTION: Read all instructions carefully before installation. Save this Owner's Manual for future reference.
Model Number
SR400
• 4-Speed Hand Held
Transmitter
• Single Light
• Supplied with Receiver
•Includes Light Dimming Selection
Switch
Model Number
SR401
•4-Speed Hand Held Transmitter
•Single Light
•Use with SR400 or SW405
•Includes Light Dimming Selection Switch
Ceiling Fan/Light
Remote Control Owner's Manual
!WARNING
Safety Instructions
WARNING: To avoid fire, shock, and serious personal injury, follow all instructions carefully.
1.Read your Owner's Manual carefully before installing the remote control. Retain Owner's Manual for future reference.
2.Be careful of the fan and blades when installing the receiver in the ceiling cover. Before installing or servicing the ceiling fan or receiver, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel.
ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION
1.To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring.
2.Make certain no bare wires are exposed outside the wire connectors.
3.All wiring must conform to National and Local Electrical Codes.
4.Follow the recommended instructions for the proper method of wiring your new remote control. If you feel you do not have enough electrical wiring knowledge or experience, have your remote control installed by a licensed electrician. Any electrical work not described in this manual should be performed by a licensed electrician.
Part No. F40BP74120002 |
Form No. BP7412-2 |
Printed in U.S.A. 09/11 |
Part No. F40BP74120002 |
Form No. BP7412-2 |
Loading...