Liebert® IS-WEBRT3 Card™
Quick Start Guide
INSTALL
•Locate the Liebert IntelliSlot bay on your Liebert equipment. You might need to remove a plastic cover.
•Insert the Liebert IS-WEBRT3 Card into the bay.
•Secure the card with the supplied screws.
•Connect the card to your network with a CAT5 Ethernet cable.
SET LIEBERT IS-WEBRT3 CARD
PASSWORD
•Insert the Liebert PSI-RT3 Software CD and install Liebert DeskPro-Net Utility on your computer.
•Start Liebert DeskPro-Net Utility by clicking on
Start>Programs>NetAgent>DeskPro-Net Utility. The software will automatically find and list available Liebert IS-WEBRT3 cards.
•Double-click on a card in the list to launch it.
•Enter an Account (login name) and Password—Record the login and password and save them in a safe place.
Control functions
Liebert IS-WEBRT3 cards found
CONFIGURE LIEBERT IS-WEBRT3 CARD
•Highlight the card in the list and click Configure to change the card’s IP address, subnet mask, and gateway settings (see your network administrator for the settings).
TheLiebert IS-WEBRT3 card can be used with DHCP or BOOTP, where the system assigns an address, but this makes troubleshooting difficult.
•Liebert MultiLink™ will communicate with the Liebert IS-WEBRT3 card. The software can be configured to shut down a computer system in response to utility power failure and the UPS’ battery backup time.