BP7311 48 56" Heat Fans 1/16/08 10:52 AM Page 1
READ AND SAVE THESE INSTRUCTIONS
48” & 56” |
|
|
|
|
10' MIN. |
|
|
|
|
|
TO FLOOR |
||
|
|
|
|
|
|
|
Industrial Heat Fans |
SPECIFICATIONS |
|
|
|
||
Owner's Manual |
Model No. |
Power |
Amps Watts RPM |
|||
|
|
|||||
Model Numbers |
HF948BS 1 |
120V/60Hz |
0.62 |
72 |
300 |
|
HF948BS 1 |
HF956BK 1 |
HF948W 1 |
|
|
|
|
HF956BK 1 |
|
|
|
|
||
HF948W 1 |
HF956BS 1 |
HF956BS 1 |
120V/60Hz |
0.82 |
98 |
280 |
|
HF956W 1 |
HF956W 1 |
|
|
|
|
|
|
|
|
|
|
|
HF948 Net Weight: 18.7 Lbs. |
HF956 Net Weight: 22.2 |
Lbs. |
||||
LIMITED WARRANTY
What The Warranty Covers:
This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered.
What The Period Of Coverage Is:
As it applies to the motor, this warranty will last for two years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, MADE WITH RESPECT TO COMPONENTS AND ACCESSORIES IS ALSO LIMITED TO ONE YEAR.
What Will Emerson Electric Co. Do To Correct Problems:
Emerson Electric Co. will replace a defective Emerson Air Comfort Ceiling Fan motor, blade, component or other accessory at no charge to you. If repair of the motor or blades is not practical or possible within a reasonable time and no replacement can be provided, Emerson Electric Co. will refund the actual purchase price of your fan. We will ship the repaired product or replacement to you at no charge, but you are responsible for all costs or removal, reinstallation and shipping of the product to Emerson Electric Co.
How Can You Get Service:
YOU MUST HAVE PROOF OF YOUR PURCHASE OF THE CEILING FAN TO OBTAIN LIMITED WARRANTY SERVICE. KEEP YOUR RECEIPT OR OTHER PROOF OF PURCHASE. You can return the product to our factory or to your nearest authorized service center.
•To return the product to the factory, obtain a return authorization and service identification tag by writing to Air Comfort Products, Division of Emerson Electric Co., 8100 W. Florissant Ave., St. Louis, MO 63136. Include all model numbers shown on the product with your request.
•To return the product to an authorized service center, call 1-800-654-3545 for the address of the nearest authorized service center.
You will be responsible for all insurance, freight or other transportation charges to our factory or authorized service center. Your Emerson Air Comfort Ceiling Fan should be properly packed to avoid damage in transit since we will not be responsible for any such damage.
What Is Not Covered:
The glass globes and light bulbs of your ceiling fan are not covered by this warranty. This warranty also does not cover any defects, malfunctions or failures caused by:
•Repairs by persons not authorized by Emerson Electric Co.,
•Use of parts or accessories not authorized by Emerson Electric Co.,
•Mishandling, improper installation, modifications or damage to your ceiling fan while in your possession, or
•Unreasonable use, misuse, abuse, including failing to do reasonable and necessary maintenance, and normal wear and tear. Additionally, this warranty and any implied warranty of merchantability or fitness for a particular purpose are voided when:
•The original purchaser or user ceases to own the product, or
•The fan is moved from its original point of installation.
This warranty is only valid within the 50 states of the United States and the District of Columbia. No other written or oral warranties apply, and no employee, agent, dealer or other person is authorized to give any warranties on behalf of Emerson Electric Co.
REPAIR, REPLACEMENT OR A REFUND ARE THE EXCLUSIVE REMEDIES AVAILABLE UNDER THIS WARRANTY AND EMERSON IS NOT RESPONSIBLE FOR DAMAGES OF ANY KIND, INCLUDING INCIDENTAL AND CONSEQUENTIAL DAMAGES. Incidental damages include but are not limited to such damages as loss of time and loss of use. Consequential damages include but are not limited to the cost of repairing or replacing other property which was damaged if this product does not work properly.
How State Law Relates To The Warranty:
Some states do not allow the exclusion or limitation of incidental or consequential damages so the above exclusion or limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Part No. F40BP73110001 |
Form No. BP7311-1 |
|
U.L. Model No.: HF948, HF956 |
BP7311 48 56" Heat Fans 1/16/08 10:52 AM Page 2
! WARNING
WARNING:To avoid fire, shock, and serious personal injury, follow these instructions.
Safety Instructions
1.Read your owner’s manual carefully and keep it for future reference.
2.Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel.
3.Be careful of the fan and blades when cleaning, painting, or working near the fan. Always turn off the power to the ceiling fan before servicing.
4.Suitable for use with solid-state speed controls.
5.Do not bend the blade flanges when installing the blades, balancing the blades, or cleaning the fan. Do not insert foreign objects in between the rotating blades.
Additional Safety Instructions for Installation
1.To avoid possible shock, be sure electricity is turned off at the fuse box before wiring, and do not operate fan without blades.
2.All wiring must satisfy National and Local Electrical Codes. Use the National Electrical Code if Local Codes do not exist. The ceiling fan must be grounded as a precaution against possible electrical shock. Electrical installation should be made or approved by a licensed electrician.
3.The outlet box and joist must be securely mounted and capable of reliably supporting at least 50 pounds. Use only U.L. outlet boxes listed as “Acceptable for Fan Support of 50 lbs or less”, and use the mounting screws provided with the outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
4.The fan must be mounted with the fan blades at least 10 feet from the floor to prevent accidental contact with the fan blades.
5.Suitable for use with solid-state speed controls.
6.Always properly connect the retention cable included with this fan (follow the “Installation Instructions” section carefully).
7.The support beam or joist must be secure and capable of supporting at least 50 pounds.
8.Follow the recommended instructions for the proper method of wiring your ceiling fan. If you do not know enough about electrical wiring, have your fan installed by a licensed electrician.
WARNING: To avoid fire, shock or injury, do not use an Emerson or any other brand of control not specifically approved for this fan.
WARNING: This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.
WARNING: To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
WARNING:To reduce the risk of electric shock, this fan must be installed with an isolating wall control/switch.
DATE CODE:
The date code of this fan may be found on the box, stamped in ink on a white label. You should record this data above and keep it in a safe place for future use.
2 |
U.L. Model No.: HF948, HF956 |
BP7311 48 56" Heat Fans 1/16/08 10:52 AM Page 3
Checking Contents of |
Electrical Requirements |
|||
Package |
Your new ceiling fan will require a |
|||
Before discarding packaging material, |
grounded electrical supply line of 120 volts |
|||
AC, 60 Hz, 15 amp circuit. |
|
|||
be certain all parts have been removed. |
|
|||
The outlet box must be securely anchored |
||||
1. Unpack the items carefully to avoid |
||||
and capable of withstanding a load of at |
||||
damage to any of the components. |
least 50 pounds. |
|
||
2. Make certain you receive the following |
|
|
|
|
parts: |
! |
WARNING |
||
a. Motor subassembly |
|
|
|
|
Turning off wall switch is not sufficient. |
||||
b. Blades (3 each) |
||||
c. Upper canopy |
To avoid possible electrical shock, be |
|||
d. Lower canopy |
sure electricity is turned off at the main |
|||
e. J-hook bag assembly containing: |
fuse box before wiring. All wiring must be |
|||
in accordance with National |
and Local |
|||
1. J-hook (2 each) |
||||
codes and |
the ceiling fan |
must be |
||
2. Flat washers (2 each) |
||||
properly grounded as a precaution |
||||
3. Lock washers (2 each) |
||||
against possible electrical shock. |
||||
4. Hex nuts (2 each) |
|
|
|
|
|
|
|
||
f. 24" Hanger pipe assembly |
|
|
|
|
g. 8” Hanger pipe(HF948 Only) |
|
|
|
|
h. Bag of parts containing: |
Fan Assembly |
||
1. Wire connectors (3 each) |
Instructions |
||
2. Cable clamps (2 each) |
1. Put the upper canopy and lower |
||
3. M6 x 1/2" Hex head screws |
|||
(6 each) |
canopy on the hanger pipe assembly, |
||
4. M6 Spring washers (6 each) |
facing in the proper direction. (See |
||
5. Blade gaskets (3 each) |
Figure 1.) |
|
|
6. Clevis pin |
NOTE: For HF948 Only. If you are going |
||
7. Hairpin clip |
to use the 8” pipe, first remove the |
||
8. 5/16-18 x 1/4” Setscrews (2 each) |
hanger assembly from the 22” pipe and |
||
9. Allen wrench |
install it on the 8” pipe. Be sure that the |
||
NOTE: Intermixing blades between |
nut is securely tightened and the |
||
fans can cause excessive wobble. |
hairpin clip properly installed. |
||
Keep blades in original sets of three. |
|
|
|
|
|
|
|
! WARNING |
|
HANGER |
|
Do not install or use fan if any part is |
|
ASSEMBLY |
|
|
UPPER |
||
damaged or missing. Call Toll-Free: |
|
CANOPY |
|
1-800-654-3545 |
HANGER PIPE |
LOWER |
|
CANOPY |
|||
|
|
||
|
ASSEMBLY |
|
|
|
|
||
Figure 1
! |
WARNING |
|
||||
|
This product |
is designed |
to use only |
|
2. |
Pass the motor wires and retention |
|
|
|||||
|
|
|
cable through the hanger pipe |
|||
|
those parts supplied with |
this product |
|
|
assembly and seat the hanger pipe in |
|
|
and/or any |
accessories |
designated |
|
|
|
|
|
|
the motor yoke. (See Figure 2.) |
|||
|
specifically for use with this product by |
|
|
|||
|
|
|
|
|||
|
Emerson Electric Co. Substitution of |
|
|
|
||
|
parts or accessories not designated for |
|
|
|
||
|
use with this product by Emerson Electric |
|
|
|
||
|
Co. could result in personal injury or |
|
|
|
||
|
property damage. |
|
|
|
|
|
|
|
|
|
|
|
|
3 |
U.L. Model No.: HF948, HF956 |
Loading...