CAUTION: Read all instructions carefully before installation. Save this Owner’s Manual for future reference.
Model Nos. HD7002 1 & HD7005 0
EMERSON®
MoistAIR™ HD7002 & HD7005
Evaporative Console
Humidifier Owner’s Manual
Part No. SP6470 |
Printed in Canada |
Limited Warranty
All products covered by this Owner’s Manual are warranted against defects in workmanship and materials for one year from the date of sale except for motors, which are warranted for two years. This warranty does not apply to damage from accident, misuse or alteration nor where the connected voltage is more than 5% above the nameplate voltage, nor to equipment improperly installed or wired or maintained in violation of this Owner’s Manual. No other written or oral warranty applies. No employee, agent, dealer or other person is authorized to give any warranties on behalf of Emerson Electric.
The customer shall be responsible for all costs incurred in the removal or reinstallation and shipping of the product for repairs. Within the limitations of this warranty, inoperative units should be returned, freight prepaid to the nearest Emerson authorized service center and we will repair or replace, at our option, at no charge to you with return freight paid by Emerson. It is agreed that such repair or replacement is the exclusive remedy available from Emerson Electric Co. and that Emerson Is Not Responsible For Damages Of Any Kind, Including Incidental And Consequential Damage. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion or limitation may not apply to you.
The warranty gives you specific legal rights, and you may also have other rights which vary from state to state or province to province.
Sales receipt required as proof of purchase for warranty claims.
GENERAL SAFETY INSTRUCTIONS
Safety Signal Words
DANGER: means if the safety information is not followed, someone will be seriously injured or killed.
WARNING: means if the safety information is not followed, someone could be seriously injured or killed.
CAUTION: means if the safety information is not followed, someone may be seriously injured or killed.
1.To reduce the risk of fire or shock hazard, plug humidifier directly into a 120V, A.C. electrical outlet. Do not use extension cords.
2.Keep the electric cord out of traffic areas. To reduce the risk of fire hazard, never put the electric cord under rugs, near heat registers, radiators, stoves or heaters.
3.Always unplug the humidifier before moving it, before cleaning, or whenever the humidifier is not in service.
4.Keep the humidifier clean.
5.Do not put foreign objects inside the humidifier.
6.Never use your humidifier while any part is missing or damaged in any manner.
7.To reduce the risk of electrical hazard or damage to humidifier, do not tilt, jolt or tip humidifier while unit is running.
8.To reduce the risk of damage to humidifier, unplug humidifier, when water bottle is empty or when the humidifier is not in use.
9.To reduce the risk of accidental electrical shock, do not touch the cord or controls with wet hands.
10.Note the warning label shown.
WARNING: To reduce risk of fire, electric shock, or injury always unplug before filling, servicing or cleaning.
2
Know Your Humidifier
Fan Assembly |
Controls |
Bottle Cover
Filter Support
Assembly
|
Filters |
|
|
Replacement No. HDC-2R or |
|
|
HDC411 |
|
|
NOTE: HDC411 provides two filter |
|
|
changes. |
|
|
|
|
Description |
HD7002 & HD7005 |
|
|
|
|
Gallon Output / 24 hrs |
7 |
|
Litre Output / 24 hrs. |
26.5 |
|
Capacity of Bottle |
2.5 Gallons |
|
Capacity of Bottle |
9.4 Litres |
|
* Sq. Ft. Coverage |
1500 |
|
Fan Speeds |
3 |
|
Number of Filters |
2 |
|
Fill Light |
Yes |
|
Auto Humidistat |
Yes |
|
Auto Shut Off |
Yes |
|
Controls |
Rotary |
|
CUL Listed |
Yes |
|
Volts |
120 A.C. |
|
Hertz |
60 |
|
Amps |
1.14 |
|
Watts |
65 |
|
*Based on an area with average insulation and an 8-foot ceiling height.
3
Humidifier Operations
Your new Emerson humidifier is designed to satisfy home humidity requirements through the principle of evaporation of water into the air.
After water is added to the bottle and positioned in the humidifier, the filters begin to soak up the water and become totally saturated in approximately 30 minutes. Air is drawn in from the rear of the humidifier and through the filters by means of one circulation fan. As air passes through the filters, moisture is absorbed into the air and then released through the top of the humidifier. This moist air is released in the form of vapor. No water droplets will enter the home. All evaporation into the air takes place in the humidifier, which means that the residue left by evaporating water is not passed into the home, but remains in the filter.
.CAUTION: Use only liquid EPA
Registered Bacteriostat available from your local retail store or call (800) 654-3545 to order. Under no circumstances should you use water treatment products for Roto belt or Ultrasonic humidifiers.
Humidified Air is
Then Released
Through the Top
Dry Air Enters
Through the
Rear
CAUTION: Keep your humidifier clean. While humidifiers do not cause colds, some studies suggest that dirty humidifiers can cause cold-like symptoms in some people. To avoid this, clean your humidifier weekly with cleaners specifically recommended for evaporative humidifiers.
Assembly
Your new Emerson MoistAIR humidifier is |
Follow the instructions of this owner’s |
completely assembled for you to use. |
manual for proper usage. |
Electrical Hook-Up
Locate nearest 120V A.C. wall socket in the location desired, preferably on inside wall. Plug in the electrical cord.
WARNING: To reduce the risk of fire or shock hazard, do not use extension cords. Humidifier should be plugged directly into a 120V A.C. outlet.
To reduce the risk of electrical shock, this humidifier has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
4
Location Instructions
WARNING: For your own safety, do not use humidifier if any parts are damaged or missing.
1.Place humidifier on a flat level surface in area of house where most humidity is needed, or an area which would likely result in moist air being circulated throughout the house, such as near a cold air return. Placing the unit level is very important if the humidifier is located on carpeting.
Moist air (humidity) produced will disperse into the whole house, but area closest to the unit will have the highest humidity. If the unit is positioned close to a window, condensation may form on the window pane. If this is not acceptable, the unit should be repositioned in another location.
NOTE: Due to release of cool, moist air from humidifier, it is best to direct air away from home thermostat and hot air registers. It is best to position humidifier
Water Fill
next to an inside wall. Hot air registers and cold air from outside walls can affect the efficiencies of the controls. Unit should not be placed where warm air from a hot air register blows directly on unit.
2.The humidifier should be positioned with the back (cord exit side), at least 2 inches away from the wall. Air needs to enter through louvers in the rear panel in order for the humidifier to operate at peak efficiency.
At Least 2" From Wall
WARNING: To reduce the risk of shock, always unplug humidifier before cleaning or servicing.
WARNING: To reduce the risk of fire or shock hazard, do not pour or spill water into control or motor area. If controls get wet, let them dry completely and have unit checked by an authorized service personnel before plugging in.
This humidifier is designed for use with the water bottle located under the bottle cover to the left of the fan assembly. The unit should be positioned where it will be operating.
Bottle Cover
Water
Bottle
5
Loading...