TABLE-TOP ELECTRONIC WINE COOLER
I
OWNER’S MANUAL
Visit our web site at “www. emersonradio.com”
UNAUTHORIZED MODIFICATIONS TO THIS DEVICE COULD VOID THE USER’S AUTHORITY TO OPERATE IT
READ AND SAVE THESE IMPORTANT SAFETY
INSTRUCTIONS BEFORE USING THIS APPLIANCE:
When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
1.Use this appliance only as described in this manual. Other uses not recommended may cause fire, electric shock or personal injury.
2.This product is intended for household use ONLY and not for commercial, industrial or outdoor use.
3.To protect against electric shock, do not immerse unit, plug or cord in water or spray with liquids.
4.Close supervision is necessary when any appliance is used by or near children.
5.Unplug the appliance from the outlet when not in use & when moving from one location to another and before cleaning.
6.To disconnect the appliance, grip the plug and pull it from the wall outlet. Never pull by the cord.
7.Do not operate the appliance in the presence of explosive and/or flammable fumes.
8.Do not place the appliance or any of its parts near an open flame, cooking or other heating appliance.
9.Do not operate the appliance with a damaged cord or plug, if the product malfunctions, or if it is dropped or damaged in any manner.
10.The use of attachments not recommended by the manufacturer may be hazardous.
11.Place the unit on a dry level surface.
12.Do not operate if the housing is removed or damaged.
13.A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
14.This appliance is designed to be free standing only, and should not be recessed or builtin (fully recessed).
15.Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight will affect / alter the outside color of the appliance.
WARNING: To reduce the risk of fire, electric shock or personal injury, unplug or disconnect the appliance from the power supply before servicing.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Save time and money. Before you call for service, check the Troubleshooting Guide at the back of this manual. It lists causes of minor operating problems that you can correct yourself.
Product Overview:
1. |
Light Switch* |
2.LCD Display* |
3. |
Temperature Adjustment |
|
4. |
|
5. |
|
6. |
Buttons* |
Light Cover |
Interior Lights |
Chrome Shelve |
|||
7. |
Feet |
8. |
Magnetic Seal |
9. |
Door |
* See Control Panel Overview section below for more detailed information
Control Panel Overview:
▲ - Increase temperature in increments of 1°F (Fahrenheit) ▼ - Decrease temperature in increments of 1°F (Fahrenheit) ☼ - Turn interior lamp on/off.
Unpacking the unit:
1.Remove the exterior and interior packing.
2.Check to be sure you have all the following parts:
a.One (1) wine cellar
b.One (1) owner’s manual
c.Two (2) chrome bottle racks
Finding a good spot for your wine cellar:
•Place your wine cellar on a flat surface that is strong enough to support it when fully loaded.
•Allow 15 cm (5”) of space on the rear and both sides of the wine cellar to allow proper ventilation.
•This wine cellar is designed to be free standing only, and should not be recessed or builtin (fully recessed).
•Do not place heavy objects on top of the unit.
•Do not locate the unit in a moist place.
•Do not locate the wine cellar in direct sunlight.
•The unit’s cooling system operates efficiently with an ambient temperature of 77°F (25°C) or less.*
*Please note that the interior temperature can be set to between 44°F and 66°F on the control panel. Due to technological limitations, the wine cellar has the ability to maintain a temperature that is 66°F cooler compared to the ambient temperature. Therefore, if the ambient temperature is higher than 97°F, the wine cellar might not be able to reach an interior temperature of 44°F to 66°F as per the control panel settings.
ALWAYS REMOVE ALL BOTTLES BEFORE MOVING THE WINE CELLAR
Installation instructions:
1.Gently place/slide the racks in the wine cellar.
2.Slide the Air Inlet Filter into the guides on the back of the wine cellar
3.Unpack the power cord from the back of the wine cellar
4.Plug the power plug into an exclusive standard 110/120V outlet.
Loading...