4405 FR FTN
Owners Manual
Freeze Resistant Wall Mounted Tubular Fountain
Installer |
|
4405FR Fountains are among the easiest to install Fountains on the market today. To assure you install |
|
these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING |
|
THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, |
|
AND OTHER APPLICABLE CODES. After installation, leave these instructions with the Fountain for future |
|
reference. This Freeze Resistant Fountain is shipped in two separate cartons. The second carton(s) |
|
contains the Freeze Resistant Package(s) HTFRB1 that are installed on an interior |
heated wall. The |
interior space must maintain a minimum temperature of 50° F (10° C). Refer to the |
Freeze Resistant |
Package for the rough-in dimensions for installation. |
|
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON.
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE WATER. THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN FITTINGS PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.
PAGE 1 |
97732C (Rev. J - 7/06) |
7/06) - J .(Rev 97732C
2 PAGE
FIG. 1 |
4405 FREEZE RESISTANT FOUNTAIN |
|
MOUNTING BOLT AND ACCESS HOLE LAYOUT |
FTN FR 4405
LEGEND
A = MOUNTING BOLT LOCATIONS (4)(1/2" DIA. NOT PROVIDED).
B = 7/8" DIA. (22mm) HOLE FOR WATER SUPPLY TUBE.
C = 7/8" DIA. (22mm) HOLE FOR OPERATING CABLE.
D = 2" DIA. (51mm) HOLE FOR WASTE LINE.
Loading...