Elite Screens ezCinema User Manual

ezCinema Series

Portable Floor Pull-Up Screen

USER’S GUIDE

Precautions:

Warning! Screen damage can result from product mishandling if the following
precautions are not followed.

In accordance with practicing home fire safety and to avoid screen damage, do not place the
screen near or beside a fireplace or high temperature appliances such as a gas stove, BBQ or

heater. (Fig. 1)

Fig.1 Fig.2

Place the screen beyond the reach of children. (Fig.2)

Rev101912-JA www.elitescreens.com 1

PARTS IDENTIFICATION:

Diagonal Size

QTY (Base foot)

QTY (Short Foot Cup)

QTY (Long Foot Cup)

100"

1 pcs

2 pcs

2 pcs

120"

1 pcs

2 pcs

2 pcs

135"

3 pcs

6 pcs

0 pcs

150"

2 pcs

4 pcs

0 pcs

Lock

Back

Note: Second telescoping

rod available on 150”

models only.

Box Cover

Big support rod

Locking sleeve

Small support rod

Bracket Hook

Upper scroll bar

Pull hook

Adjustable
up to 1"

Base foot (available on
models 100" above only)

Adjustment screw for leveling

Front

Black Masking Border Edge

Long Foot Cup

Box

Bottom Black Masking

White projection surface

Short Foot Cup

For models 100”, 120”, 135” and 150”

Refer to the table below for information regarding quantity of the base feet and cup

Attention:

- Please install the two telescoping support rods simultaneously when pulling up and retracting

the screen material.

- Do not use the screen in a very strong windy environment

- Do not use on uneven surfaces

New Functions and features of F100 and above models:

1. Base foot allows screen to be adjusted up to 1 inch to level the screen to the ground

2. 40” bottom black border of F120 and above models for better viewing for people in the back

Rev101912-JA www.elitescreens.com 2

Setting up the screen

Long foot cup

Short cup

Installation:

The ezCinema screen is designed to be used as an easy to operate portable screen for a variety of
presentation environments. Its design enables it to be versatile for use in either classroom,
conference room, home or patio presentations. When packed, the unit carries with ease and opens up
for projection presentations within seconds. As a general rule, portable projector screens should be
installed in an area free from wind and heat or open flame sources such as a heater, BBQ grill or
fireworks display.

Extend the base feet:

For sizes below 100”

Locate the base feet on the bottom of the box cover at each end and rotate the base foot until it forms
a right angle between the footboard and the cover box.

For sizes 100” – 150”

All models including 100” utilize the short and long feet cups. Locate each screw hole on the bottom

of the case of the screen and screw in a short foot cup on the base feet and the long foot cup on the
ends. Short cups included only in the 135” and 150” models.

Open the box cover:

Unlatch the buckles on both ends of the box and open the box cover. Next, secure the box with one
hand while removing the telescopic support rod with your other hand.

Rev101912-JA www.elitescreens.com 3