Elite Screens Electric125XH, Electric106NX User manual

Spectrum Series

Electric/Motorized Projection Screen

Important Safety & Warning Precautions

Make sure to read this user’s guide and follow the procedure below.

Caution: The screen’s Black Top Drop is already set to its maximum drop distance. There is NO extra Black

Top Drop in the roller. Please be aware of

changes or modifications (except for cu

prohibited and will void your warranty. For more information, please contact our Technical Support

1211 Ext. 604.

Please retain this user’s guide for future reference

To avoid damaging the unit, do not use with any unauthorized accessories not recommended by the

Handle the unit carefully during transportation to avoid any damages.

To ensure safe and reliable operation, direct connection to a properly gr

The power outlet supplying power to the unit should be close to the unit and easily accessible.

Do not install the unit on uneven or inclined surfaces.

Do not put heavy objects on the power cord and position it properly to

Never overload the power cord to prevent an electric shock or fire due to a loose contact or a short circuit.

There are not user serviceable parts in this unit. Do not attempt to disassemble this unit by yourself. No one

ept authorized technicians can open and make repairs to this unit.

Make sure the power source this unit is connected to has a continuous power flow.

If there is need to use an extension cord, make sure the cord has an equal rating as the appliance to avoid

Do not handle the power plug when your hands are wet or your feet are in contact with water.

Do not use this unit under the following circumstances.

Disconnect the power cord under the conditions of heavy rain, wind, thunder or lightning.

d direct Sunshine, rain shower and moisture.

Keep away from fire sources and high temperature to prevent this device from overheating.

Cut off the power supply first before transportation or maintenance.

Fully disconnect from the power supply when the unit

with any other electric household appliance.

To avoid possible injury and/or an electric shock, do not attempt to use the screen if there is obvious damage

or if there are any evident broken parts

as it will void your warranty with Elite Screens. Unapproved

tting the power cord for hardwire installations) to this unit are

ounded power source is advised.

avoid creating a trip obstacle.

is not in use for a long period of time, as should be done

User Guide

this,

Department at (877) 511-




manufacturer.









exc




overheat.




 Avoi






Rev. 071516-MZ

.

www.elitescreens.com

.

1

Installation Warning

Individual modifications to this product are prohibited and will void the warranty with the manufacturer. Please

contact Elite Screens Customer Service for any questions.

This equipment has been tested and found to

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates and can radiate radi

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that the interference will not occur on a particular installation. If this equip

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures.

ceiving antenna of the device which may be casing the interference.

Increase the separation between the screen and the device’s receiver.

Connect the equipment into a different power outlet other than the device

Always handle the screen in a leveled position on a clean surface.

In order to protect the screen from exposure to stains, keep the screen out of contact with foreign particles such

as dust, sawdust, and/or liquids.

way wall

switch x 1

comply with the limits for a Class B digital device, pursuant to Part 15 of

o frequency energy and, if not installed and used in accordance with the

NOTE:

the FCC Rules.

 Reorient or relocate the re



Pre-Installation

1. Carefully unpack the screen.

2.

3.

ment causes

Accessories List

A. IR remote x 1 B. 3-

C. 12-volt trigger

cable x 1

D. Bubble level x 1

E. AAA batteries x 2

Rev. 071516-MZ

www.elitescreens.com

2