Electrolux Stainless Steel Gas Grill User Manual

0 (0)
1
Welcome & Congratulations
lease read this Use & Care Manual very carefully. It contains valuable information on how to
P
roperly maintain your new grill.
p
We know you’ll enjoy your new grill and thank you for choosing our product. We hope you consider us for future purchases.
PLEASE READ AND SAVE THESE INSTRUCTIONS
This Use & Care Manual provides specific operating instructions for your model. Use your grill only as instructed in this manual. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating and maintaining any appliance.
Please record your model and serial numbers below for future reference. This information is found on the serial plate located on the back of the built-in grill or on the inside of the cart door for complete grill & cart model.
Questions?
1-800-320-0859
www.electroluxusa.com
Please record grill information for future reference and service work:
Model #: ________________________________________________________
Serial #: ________________________________________________________
Date of Purchase: ________________________________________________
Gas Type: ______________________________________________________
TABLE OF CONTENTS
Welcome/Product Registration ......................................................................1
General Safety Instructions ..........................................................................2
Grill Features & Components ......................................................................3-4
Grill Assembly/Built-In Instructions ............................................................5-9
Gas Requirements/Leak Testing ................................................................10-12
Lighting the Grill ............................................................................................13
Using the Grill (Rotisserie/Side Burner Usage)........................................14-16
Care & Maintenance ......................................................................................17
Troubleshooting Your Grill ........................................................................18-19
Warranty..........................................................................................................21
Please retain this manual for future reference
© 2004 Electrolux Home Products, Inc All rights reserved
General Safety Instructions
IMPORTANT SAFETY INFORMATION
- Read this manual carefully before using your grill to reduce the risk
of fire, burn hazard or other injury.
- Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.
- This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to come in contact with grate, burner or hot surfaces.
- Use only outdoors and provide good ventilation to avoid carbon monoxide build-up which could result in injury or death.
- Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified service technician should conduct all other service.
- Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service technician.
- Locate the main gas supply valve so that you know how to shut the gas off to your grill.
- If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified technician.
- When lighting a burner, always pay close attention to what you are doing and be certain you are pushing the igniter that lights the burner you intend on using.
- Always keep your face and body as far away as from the grill as possible when lighting to reduce the risk of burn.
- Extinguish all flames and do not smoke while engaging gas and igniting the grill.
2
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open grill hood.
4. If odor continues, immediately call your gas supplier
CALIFORNIA PROPOSITION 65 - W ARNING:
The burning of gas cooking fuels generates some by products which are on the list of substances which are known by the State of California to cause cancer or reproductive harm. California law requires busi nesses to warn customers of potential exposure to such substances. To minimize exposure to these substances, always operate this unit according to the use and care manual, provide good ventilation when
cooking with gas.
.
This appliance is not intended to be
installed in or on recreational
vehicles or boats.
TESTED IN ACCORDANCE WITH ANSI Z21.58b-2002/CGA 1.6b-M02 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY.
Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. Z223.1-2002 and the National Electrical Code ANSI/NFPA
No. 70-1990
FOR YOUR SAFETY
-
DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
LP cylinder not connected for use shall not be stored in
An
the vicinity of this or any other appliance.
WARNING
DO NOT
try lighting this appliance without reading
the “LIGHTING INSTRUCTIONS” section of
this manual.
FOR OUTDOOR USE ONLY
3
Grill Features: E57
1
2
3
16
4
5
6
12
7
8
9
13
10
14
15
11
1. Roll top grill hood
2. Grilling/cooking surface
3. Side shelf
4. Control knob: back infrared burner
5. Control knobs: main burners
6. Warming drawer
7. Hood handle
8. Warming shelf
9. Infrared back burner
NOTE: Cart, side burner and side shelf are not included with the head only units.
10. Electronic igniter: bottom infrared and side burner
11. Cart with doors and drawers
12. Drip pans
13. Dual side burners
14. Control knobs:side burner
15. Control knob: bottom infrared burner
16. Electronic igniter: main burners and back infrared
5
Grill Assembly
IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling.
IGNITER ATTACHMENT
1. Remove the igniter cap, spring assembly, battery and lock nut from Igniter. (See Fig. 1)
2. Insert the threaded section of the igniter into the U-shaped cut out of the igniter mounting bracket. (See Fig. 2)
3. Insert the threaded section of the igniter through the hole in the shelf and secure to shelf using the lock nut.
determine which igniter goes with which shelf.) Tighten securely. (See Fig. 3)
4. Re-insert the battery, positive side first, and spring assembly and attach the igniter cap. (See Fig. 4)
(Use the igniter assembly diagrams to
ap
C
Spring
Assembly
attery
B
ocking
L
Nut
Cylinder
Fig. 1
Mounting
Bracket
Fig. 2
5. Repeat above steps for second igniter on the other shelf.
E57 IGNITER ASSEMBLY
Fig. 3
Fig. 4
Keyhole
Right shelf (three wire)
Left shelf (three wire)
Side Shelf/Side Burner Assembly
SIDE SHELVES ATTACHMENT
1. Loosen the bolts on the side of the grill and attach the shelf by allowing the bolt heads to fall through the large opening in the bottom of the keyhole slots. Then slide the shelves downward until the bolts are resting against the top of the key hole slots. Tighten all of the shelf bolts. (See Fig. 5-6)
2. Attach the wires coming out from the sides of the grill to the Igniter terminals. (See Fig. 7)
3. Repeat for second side shelf
Fig. 5
6
Note: It does not matter which wire goes to which terminal on the three wire igniters.
INST
ALLING SIDE BURNER PLATES
1. There are two (2) black burners and caps that need to be installed for the side burner to operate correctly.
2. Place the burner and cap on top of the one burner. (repeat step for second burner Fig. 8-10)
3. Replace grate on top of the dual burners. (See Fig. 11)
.) (See
Fig. 10
Fig. 6
Fig. 7
Fig. 8
Fig. 11
Fig. 9
7
Interior Parts Installation
INTERIOR PARTS INSTALLATION
1. Install the bottom flavor grids in the lower cutouts and around the igniters. (See Fig. 12)
2. Insert the top row of flavor grids with the 90 degree angled heat shield (bottom side of fla­vor grid) facing the rear of the unit into cutouts with triangle ridges facing up. (See Fig. 13-14)
Note: The right side of one flavor grid is extended. This goes on the far right main burner, next to the bottom infrared burner.
3. Install cooking grates on the ledges provided on the grill to create your cooking surface. (See. Fig. 15)
4. Place warming shelf on support brackets by setting it flat across brackets allowing the two holes to line up with the holes on each bracket. (See Fig. 15)
Faces the back of
the grill
ottom flavor grids
B in between burners
Fig. 12
Fig. 13
Fig. 14
arming Shelf
W
Cooking Grates
Fig. 15
Loading...
+ 14 hidden pages