CLEAR SET-UP AND CONFIGURATION
Select amplifier type and activate through "drag and drop."
Each amplifier is displayed showing address, operation mode, input level, and network mode (on-line/off-line). Double-click on one amplifier link to the individual control panel for more detail.
Amplifiers and channels may be assigned to control groups on customized group control panels with dedicated control parameters.
ADVANCED REMOTE CONTROL AND SUPERVISION
Amplifier Type: P900RL, P1200RL,
P3000RL, P900RT or P1200RT
Impedance Load Monitoring
Green = O.K.
Display red = Hi or Low
Threshold of DSP compressor (yellow) and limiter (blue).
Temperature control
green = perfect, yellow = limit red = too warm
Hi resolution input metering
Solo button: mutes all other channels
MUTE button
Address number of amplifier
POWER On/Off and operation mode display
Name of amplifier (position, use, loudspeaker group...)
Channel name (loudspeaker, component, ...)
Display for protect mode
Display for dynamic limiter of amplifier
Hi resolution output metering in realtime. The yellow LED indicates 0dB for maximum output power.
Level (attenuation) control of the amplifier (infinity to 0dB).
Set-Up Button: accesses detailed control of amplifier, including all DSP functions (filter, delay, dynamics)
Monitor LED for stand-by mode
STATE-OF-THE-ART SIGNAL PROCESSING WITH 24 FILTERS, 5 DELAYS , 2 COMPRESSORS AND 2 LIMITERS
Menu control for selection of DSP parameters, speaker assign, impedance monitoring or protocol.
Each block of DSP functions shows the amount of active parameters.
Filter response, delay times and dynamic settings are displayed as a thumbnail.
The DSP functions are:
Master-EQ with five filters, each selectable as Low or Hi-Shelf,
Low or Hi-Pass, or PEQ.
Input-Delay for channel A, B and A+B, up to 1,000 ms.
Input-Routing (A, B, or A+B).
Channel-EQ with five filters as master EQ and additional all-pass filter.
Crossover with Hi and Lo-Pass Filter
First to fourth order (Bessel, Butterworth, Linkwitz-Riley) compressor and limiter per channel.
CLEAR OVERVIEW ON ALL DSP PARAMETERS AND FUNCTIONS
Channel-EQ with five filters.
Display of the filters and their acoustical impact on the loudspeaker system.
Master EQ with five filters. Display of the filter response and the acoustical impact of each filter on the loudspeaker system.
Crossover with each Hi and Lo-Pass per channel. Impact of all DSP parameters (filters, delay, level) to acoustical delivery of the system can be displayed.
Input-Delay for A, B, or sum A+B. Maximum delay time 1,000 ms. Units: µs, ms, s, cm, meters, inches, or feet.
Compressor and limiter per output. Threshold assignable in volts or dBu.
Supervision for each connected loudspeaker with individual upper and lower thresholds for impedance values. An out- of-limit device will show up immediately.
Loading...