EBAA Iron 1606TD Installation Manual

Tru-Dual

Series 1606TD

Bell Restraint Harness for Ductile Iron & C900 PVC Pipe

Split Serrated Restraint Ring, Split Non-Serrated Bell Ring

Installation Instructions

1. The Series 1600TD is designed for restraining ductile iron pipe and
C900 PVC at push-on bell joints. It has a split, serrated restraint ring
with heat treated inserts on the spigot and a split non-serrated ring
behind the bell.

2. Assemble the push-on joint per the pipe manufacturer’s instructions.

3. Install both halves of the non-serrated bell ring around the pipe behind
the bell. Install the side bolts and tighten each to 60 ft-lbs (110 ftlbs on
8 inch, 10 inch and 12 inch).

4. Slide the bell ring toward the bell so that it ts snugly behind the bell.

5. Remove the side bolts from the serrated restraint ring. Use the tie
bolts to determine the proper location of the restraint ring on the spig­ot. Allow enough room on the tie bolt to fully engage the nuts.

6. Install both halves of the restraint ring at the proper location, tapping
each half into place. Make sure that the complete ID of the ring is
touching the pipe before installing the side bolts. Tighten the side bolts
evenly to 60 ft-lbs torque (110 ft-lbs on 8 inch, 10 inch and 12 inch).

®

CONTENTS

Qty. Description

1 6 in. Size 1500TD Restraint

Ring

1 6 in. Size 1600 Split Bell

Ring

2 Low Alloy Steel Tie Rods w/

Nuts

Restraints Made in The USA

7. Place nuts on the tie bolts and tighten until they are snug. Allow
enough room on the tie bolt to fully engage the nut with several
threads showing. Do not tighten these bolts enough to force the spigot
further into the bell of the joint.

0408-D

APPROXIMATE SHIPPING WEIGHT: 20.5 lbs.

Series 1606TD

Bell Restraint Harness for Ductile Iron & C900 PVC Pipe
Split Serrated Restraint Ring, Split Non-Serrated Bell Ring

1606TD00

For use on water or wastewater pipelines subject
to hydrostatic pressure and tested in accordance

with either AWWA C600 or ASTM D2774

Copyright 2018 © EBAA IRON, Inc. All Rights Reserved

EBAA IRON SALES, Inc.

P.O. Box 857, Eastland, TX 76448

Tel: [phone]

Fax: [phone]

Toll: [phone]

[e-mail]

www.ebaa.com

Made in the USA