Dymo M1011 User Manual

6.67 Mb
Loading...

User Guide

Guide D’Utilisation

Bedienungsanleitung

Guida per l’utente

Guía del usuario

Guia do Usuário

Rhino M1011

www.dymo.com

 

 

 

 

 

 

I

 

 

 

 

 

 

D

 

 

 

 

 

K

 

 

 

 

 

 

F

A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

C

 

 

M

 

 

 

 

 

 

 

 

 

 

 

 

 

G

 

 

 

 

 

 

 

 

 

 

 

 

 

L

 

H

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

B

 

 

 

 

 

 

 

 

 

 

 

 

N

 

 

 

 

 

 

E

 

J

A

Tape cassette door

H

Character selection window

B

Tape rollers

 

 

I

Cutting handle

 

 

 

C

Tape advance knob

J

Embossing adjustment screw

D

Start line

 

 

K

Cable tie slot entrance

 

 

E

Tape pawl

 

 

L

Hole punch entrance

 

 

F

Embossing handle

M

Tape exit

 

 

 

G

Embossing wheel

N

Trailer length guide

 

 

2

About Your New Label Maker

With your new DYMO M1011 label maker, you can create metal labels. The label maker uses DYMO 12 mm (1/2") tape.

Metal tapes are available as follows:

Aluminium with adhesive (35800)

Aluminium without adhesive (31000)

Stainless Steel (32500)

You can also use a Reverse Image Wheel with the DYMO M1011 label maker. This wheel allows you to print mirror script labels that meet special requirements in the industry. Mirror labels are used on moulds or casts for metal or rubber injection, silicon casting, fiber glass applications, and so on.

Visit www.dymo.com for information on obtaining tapes for your label maker.

3

A

B

F

Loading the Tape

The DYMO M1011 is set to emboss non-adhesive aluminium tape.

To load the tape roll

1.Hold the label maker in your left hand.

2.Open tape cassette door (A).

3.Insert roll of tape allowing the end to extend about 5 cm (2") through the label slot.

4.Close the tape cassette door.

5.Feed the tape between the two rollers (B).

6.Squeeze the embossing handle (F) half-way (one click) several times to ensure the tape is visible at the tape exit.

4

I

M

Cutting the Label

To cut the label

1.Squeeze the embossing handle half-way, several times until the tape extends from the front of the tape exit (M) by at least 2,5 cm (1").

!Before cutting the tape, make sure the end of the tape extends beyond the edge of the cutting assembly so you can easily pull the

label out. Otherwise, a tape jam may occur.

2.Lift the cutting handle (I) gently until it is vertical to cut the label.

5

+ 11 hidden pages