Page 1
JC95FFS
JERRY CANTRELL FIREFLY CRY BABY® WAH
Page 2
EXTERNAL CONTROLS
1
1 FINE TUNE knob adjusts tone of toe-down rocker position
JC95FFS JERRY CANTRELL FIREFLY CRY BABY® WAH 2
Page 3
BASIC OPERATION
POWER
The Jerry Cantrell Cry Baby® Wah is powered by one 9-volt battery
(accessed via underside of pedal), the Dunlop ECB003 9-volt
®
adapter, or an MXR
OPERATION
Brick™ Series power supply.
1. Run a cable from your guitar to JCB95FFS’ INSTRUMENT jack
and run another cable from the JC95FFS’ AMPLIFIER jack to your
amplifier.
2. Push the toe of the pedal down until you feel a “click” to turn
the pedal on/off.
3. Rotate the FINE TUNE knob clockwise for a brighter toe-down
response or counterclockwise for a darker toe-down response.
4. Rock your foot back and forth on the pedal to hear the vocal,
expressive tones that the Cry Baby Wah is famous for.
JC95FFS JERRY CANTRELL FIREFLY CRY BABY® WAH 3
Page 4
SPECIFICATIONS
IMPEDANCE
Input Impedance 1MΩ
Output Impedance 10KΩ
FILTER CENTER FREQUENCY
Heel Down 310 Hz ~ 410 Hz
Toe Down Fine Tune Max 1700 Hz to 2070 Hz
Toe Down Fine Tune Min 1050 kHz to 1270 Hz
MAXIMUM LEVEL
Input -11.5 dBV
Output +6 dBV
MAXIMUM GAIN AT CENTER FREQUENCY
Heel Down +18 dBV
Toe Down +20 dBV
NOISE FLOOR
Heel Down >97 dB
Toe Down >89 dB
Bypass Hardwire
Current Draw 1 mA
Power Supply DC 9 volts
*
* VREF=1VRMS, A-weighted
JC95FFS JERRY CANTRELL FIREFLY CRY BABY® WAH 4
Loading...