TS55
TS SERIES
INSTALLATION/OWNER'S MANUAL
Car Audio Speakers
TS69
TS65
TS55
TS45
TS5768
TS SERIES PREPARATION
Getting Started
Thank you for purchasing the TS Series car speakers. Although Dual has attempted
to make sure all of the information contained within this manual is accurate, please be
aware that any part of it is subject to change without notice.
Safety
This symbol is intended to alert the user to the presence of
important instructions. Failure to heed these instructions
can result in injury or unit damage.
To prevent injury and damage to the unit, please read and follow
the instructions in this manual.
If you feel unsure about installing this system yourself, have it
installed by a qualified audio technician.
Before installation, disconnect the battery negative (-) terminal to
prevent damage to the unit, fire and/or possible injury.
Do not connect Amplifier or any audio source to illuminite inputs.
Inputs are designed for 12 volt power source only.
2
TS SERIES INSTALLATION
Installation
The following installation instructions are very basic. If you feel
unsure about personally installing this speaker system, Dual
recommends acquiring the services of a professional car audio
installation center.
Before installation, please follow these guidelines:
1. Be sure to carefully read and understand the instructions before attempting to install
this product.
2. For safety, disconnect the negative terminal from the battery prior to beginning the
installation.
3. For easier assembly: If additional wiring is required, we recommend running all wires
prior to mounting your speaker in place.
4. Use the highest quality connectors for a reliable installation and to minimize signal or
power loss.
5. Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel
lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any
vehicle.
6. Never run speaker wires underneath your vehicle. Running speaker wires inside the
vehicle provides the best protection from exhaust heat and environmental elements.
7. Avoid running wires over, near, or through sharp edged surfaces. We suggest you
also use rubber grommets to protect any wires routed through metal, especially the
firewall.
8. Do not connect audio outputs from your amp or receiver to the illuminite inputs of the
speakers. This WILL DAMAGE the LEDs and WILL void your warranty.
3
Loading...