Dixon 501 User Manual

0 (0)
Dixon 501 User Manual

 

 

INDEX

 

 

1.

SAFETY

Pages

1 - 3

2.

WARRANTY POLICY

Page

4

 

3.

SPECIFICATIONS

Page

5

 

4.

SET UP AND SERVICE

Pages

6 - 1 1

5.

OPERATION INSTRUCTIONS

Pages

12-13

6.

CARE AND MAINTENANCE

Pages

14

-21

7.

TROUBLESHOOTING

Pages

22

-24

8.

PARTS ILLUSTRATIONS

Pages

25 - 28

9.

PARTS LIST

Pages

29 - 31

10.

ELECTRICAL SCHEMATIC

Page

 

32

IMPORTANT - READ CAREFULLY

The Dixon ZTR Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator's manual carefully, and become completely familiar with the controls.

The information in this operator's manual applies to all Dixon ZTR Model 501 Mowers. Your Dixon dealer will gladly provide a check-out ride, and answer any questions.

See your dealer for warranty service, parts and repairs.

DIXON INDUSTRIES, INC.

Box 494

Coffeyville, Kansas 67337-0494

Page 1

SAFETY

RIDING LAWNMOWERS, IF IMPROPERLY-OPERATED. CAN CAUSE SERIOUS INJURY.

The following examples are the most, common causes of Injury to the operator or bystander.

1. BLADE CONTACT: The operator or bystander inserts a hand or foot into the discharge chute or under the mower deck and into the path of the cutting blade.

Never run the mower blades when there are people nearby.

Always turn the engine off when cleaning or working around the mower deck.

2. RUN-OVER: This situation occurs when a bystander is run-over or backed over by the mower. The most frequently cited examples are with small children who wander into, or are allowed to play, in an area where the mower is being operated. Never run the mower blades when there are people nearby, especially children. Young children should be indoors and watched by an adult.

Always look behind you before backing up.

3- TIP-OVER: This occurs when the mower tips over, usually sideways or to the rear. This situation is due to operation of the mower on steep inclines or near a drop off.

Mow across the slope to slightly uphill.

Mow slopes when the grass is dry and watch for bumps, holes and other obstacles.

Test the slope with the blades off. A good rule of thumb is "Don't mow on • a slope you can't back up".

Stay clear of drop-offs, especially if they are on the down side of a slope.

4. THROWN OBJECTS: The fast spinning mower deck blade can strike stones or other objects which can be hurled into the path of a bystander. To prevent this from happening, never remove the safety discharge chute from the mower deck, or operate the mower when other people are around.

5.FIRES: Most accidents of this type occur during re-fueling of the mower or placing the mower in a storage situation. The exhaust system and related engine components operate at very high temperatures which can ignite any fuel spilled on or near them. Always allow the mower to cool before re-fueling or placing in storage.

6.OPERATION BY CHILDREN: This mower is not a toy or recreational vehicle.

Never allow children to operate the mower in any manner or to ride as a passenger.

 

 

NOTE:

The six examples are the most frequently cited injury causing situations.

 

Please review all the safety precautions outlined on the following pages

 

prior to operation of the mower. Our aim is to enhance the safe and

 

satisfactory use of this product.

SAFETY

Page 2

SAFETY REMINDERS: READ CAREFULLY BEFORE OPERATION

1.Wear appropriate, safe clothing when mowing - close fitting jeans or slacks and heavy leather or safety shoes with rough soles. Never operate this mower with bare feet or open sandals.

2.Do not operate on wet or slippery grass.

3.Always mow at the slowest speed that will cut satisfactorily.

4.Keep hands and feet away from the blade at all times.

5.Keep persons clear of the discharge chute. Do not operate mower unless deflector is in place.

6.When mowing hills or slopes, use extreme caution. Reduce speed, do not make sudden starts, stops or turns.

7.Always disengage blades before taking the mower across walks or objects that project above the surface.

8.Stay alert for holes, rocks and roots in the terrain, and other hazards. Keep away from drop-offs.

9. When the mower is not in use, turn the engine off and remove key. Never leave the engine running unattended. Your Dixon mower is equipped with a weight-sensitive switch that kills the engine when operator leaves the seat while blades are engaged.

"Test this important safety feature before each time mower is used. This may be done by starting engine, engaging blades and then rising slightly from seat. If engine does not stop, see your dealer for necessary repair."

10. Before adjusting or servicing your mower, turn off the engine and let it cool. Be sure all moving parts are stopped. Never run the 501 with the body open.

11. Never run the engine indoors; the fumes are dangerous.

,:

12.Before backing your Dixon Mower; stop, turn around and look.

13.Handle gasoline with care - it is highly flammable.

A.Use approved gasoline container.

B.Never remove the fuel cap of, or add gasoline to, a running or hot engine, or an engine that has not been allowed to cool after running. Never fill the tank indoors and always clean up spilled gasoline.

C.Never store the mower, with gasoline in the tank, inside the building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

14.Never lift lawnmower by the body; lift only by the frame.

15.Never carry passengers.

Page 3

SAFETY REMINDERS: (continued)

16.Use care when pulling loads or using heavy equipment.

A.Use only approved drawbar hitch points.

B.Limit loads to those you can safely control.

C.Do not turn sharply. Use care when backing.

17.Watch out for traffic when crossing or near roadways.

18.Keep the mower in good operating condition, and keep safety devices in place and working.

19.Keep all nuts, bolts and screws tight to be sure the mower is in safe working condition.

20.To reduce fire hazard, keep the engine free of grass, leaves or excessive grease,

21.The mower should be stopped and inspected for damage after striking a foreign object or if it starts vibrating, and any damage should be repaired before restarting and operating the mower.

22.When mowing, proceed as follows:

A.Mow only in daylight or in good artificial light.

B.Shut the engine off when removing the grass catcher or unclogging chute.

C.Check the blade mounting bolts for proper tightness at frequent intervals.

D.Never operate the machine when using medication or under the influence of alcohol or drugs.

WARRANTY POLICY

Page 4

Warranty Policy:

Each new Model 501 is warranted against manufacturing defects in material and workmanship under normal use and service for a period of (1) year or (400) hours from date of purchase and is extended to the original retail purchaser of the mower only.

Obligation:

Under this warranty policy Dixon Industries, Inc. shall be limited to the replacement to the original purchaser of any part or parts, which, within

the warranty period shall be shown to be defective due to faulty workmanship or materials at the factory.

What is NOT covered by Dixon Industries, Inc.:

1.TRANSPORTATION CHARGES: Any charges by the dealer or other parties for transportation of the mower to or from the dealers place of business, also known as pick up and delivery.

2.ENGINES: The warranty policy and procedures for any engine used on our mowers is the responsibility and obligation of the individual engine manufacturer. As such, Dixon Industries, Inc. assumes no responsibility for either the policies or procedures of said manufacturers.

3.BELTS AND BLADES: Our warranty does not apply to the blades or belts used

on our mowers due to the very nature of the function they perform and to h the elements they are exposed to.

4.ROUTINE MAINTENANCE: Adjustments or any type of oil or grease used on the mower.

5.TIRES: Warranty extended by tire manufacturer.

6.PEERLESS GEAR BOX: Warranted for a period of (90) days from date of purchase of Tecumseh Products Company.

7.NEGLIGENCE: Any failure caused by negligence, improper use or abuse on part of owner or operator.

Who is authorized to perform warranty service?

Any authorized Dixon ZTR dealer can perform repairs under warranty on our mowers. If warranty repairs" are needed, please contact the selling dealer first. If, due to circumstances beyond your control, you are unable to obtain repairs by the selling dealer, contact the customer service department of Dixon Industries, Inc. for assistance.

Product updates or improvements:

We reserve the right to make changes in design or improvements on our products without imposing any obligation upon ourselves to install the same on products heretofore manufactured.

Page 5

SPECIFICATIONS

Chassis: 11 GA - rectangular tube.

Body: Two piece - made of DR acrylic reinforced with fiberglass, color fast, scratch and impact resistant. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

Seat: Ergonomically designed for operator comfort by use of high density closed cell foam, contoured back rest and arm rests. Seat is adjustable fore and

aft.

Mower Deck: 12 GA stamped steel construction, (3) blades, 50" cut width, cut height 1" to 4" via 7 position lift handle. Self cleaning design smoothly curved front, aides discharge of grass.

Blade Drive: Warner electric clutch.

Drive System: {2} Sundstrand BDU - 10 L hydrostatic transmissions driven by a permanently lubricated peerless gear box.

Engine: 18 HP Briggs and Stratton twin cylinder 1C with cast iron sleeves and ducted air flow.

Starting System: Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Tires: Front 11 x 4.10 x 5 smooth tread. Rear 20 x 10 x 8 turf savers.

Capacities: Fuel - 4.8 gallons total (dual tanks) with fuel gauges. Hydrostat oil tank - 3 quart with inline 10 micron filter. Hydrostat oil recommendation - name brand SAE (10-W-30) motor oil.

Dimensions: Width - 60"

Height - 45"

Length - 72"

Weight - 624 lbs.

NOTE: Additional information provided in service instruction under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE........................

Page 6

SET UP AND SERVICE

1.Seat assembly instructions.

2.Upper control lever installation.

3.Mower deck installation.

4.Deck leveling procedure.

5.Final preparation.

Page 7

SEAT ASSEMBLY INSTRUCTIONS

1.Assemble seat as shown in picture. Do not fully tighten the bolts which secure left and right arm rest brackets to seat bottom until seat back and tool box are installed. This will aid alignment of all parts.

2.Place seat assembly on rear body cover, connect seat safety switch.

3.Insert the (2) rear studs of the seat slide into the rear holes of the body

cover. Firmly hold seat assembly against body cover with one hand while rear body is raised to fully open position. Continue to hold seat against body to

prevent damage to seat safety switch wiring.

4. Install (1) flat washer and (1) nylok nut on (1) of the rear studs extending through body cover and seat frame, tighten a few threads to hold seat assembly in place.

5. Position seat on front holes and install all remaining washers and nylok nuts. Tighten all nuts fully.

Page 8

UPPER CONTROL LEVER INSTALLATION

1.Raise rear body cover to fully open position.

2.Insert left upper control lever on swivel plate.

3. Install fiber washer and jam nut.

;

4. Proper tightness or tension on jam nut is achieved when swing out movement of upper control levers requires some pressure. Levers should not fall to the side or be sloppy in movement.

5. Repeat procedure on right side.

Loading...
+ 24 hidden pages