Dell ™ E1911 monitor User's Guide
About Your Monitor
Setting Up Your Monitor
Operating Your Monitor
Troubleshooting
Appendix
Notes,Cautions,Warnings
NOTE: A NOTE indicates important information that helps you make better use of your computer.
CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed.
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
Information in this document is subject to change without notice.
© 2010 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc; Microsoft and Windows are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries; Adobe is a trademark of Adobe Systems Incorporated, which may be registered in certain jurisdictions. ENERGY STAR is a registered trademark of the U.S. Environmental Protection Agency. As an ENERGY STAR partner, Dell Inc. has determined that this product meets the ENERGY STAR guidelines for energy efficiency.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
Model E1911f/E1911c
August 2010 Rev. A00
Back to Contents Page
About Your Monitor
Dell™ E1911 monitor User's Guide
Package Contents
Product Features
Identifying Parts and Controls
Monitor Specifications
Plug and Play Capability
LCD Monitor Quality and Pixel Policy
Maintenance Guidelines
Package Contents
Your monitor ships with the components shown below. Ensure that you have received all the components and contact Dell if something is missing.
NOTE: Some items may be optional and may not ship with your Monitor. Some features or media may not be available in certain countries.
• Monitor
• Stand base
• Power Cable
• VGA Cable
• DVI Cable
•Drivers and Documentation media
•Quick Setup Guide
•Safety Information
Product Features
The Dell™ E1911 display has an active matrix, thin-film transistor (TFT), liquid crystal display (LCD). The monitor features include:
■48.26 cm (19 inches) viewable area display.
■1440x900 resolution, plus full-screen support for lower resolutions.
■Wide viewing angle to allow viewing from a sitting or standing position, or while moving from side-to-side.
■Tilt adjustment capabilities.
■Removable pedestal and Video Electronics Standards Association (VESA®) 100 mm mounting holes for flexible mounting solutions.
■Plug and play capability if supported by your system.
■On-Screen Display (OSD) adjustments for ease of set-up and screen optimization.
■Software and documentation media which includes an information file (INF), Image Color Matching file (ICM), and product documentation.
■Energy Saver feature for Energy Star® compliance.
■Security lock slot.
■EPEAT™ GOLD compliant.
■Halogen reduced.
■Asset Management Capability.
■PowerNap Software included (comes in the CD attached with the monitor).
Identifying Parts and Controls
Front View
Front View |
Front Panel Controls |
|
|
|
|
Label Description
1.
Function buttons (For more information, see
Operating the Monitor)
2.Power On/Off button (with LED indicator)
Back View
|
|
Back View |
Back View with Monitor Stand |
||
|
|
|
|
|
|
Label |
Description |
|
Use |
|
|
|
|
|
|
|
|
1 |
Barcode serial number label |
|
To contact Dell for technical support. |
|
|
|
|
|
|
|
|
2 |
Security lock slot |
|
To help secure your monitor. |
|
|
|
|
|
|
|
|
3 |
Dell Soundbar mounting brackets |
|
To attach the optional Dell Soundbar. |
|
|
|
|
|
|
|
|
4 |
Regulatory rating label |
|
Lists the regulatory approvals. |
|
|
5 |
VESA mounting holes (100mm) |
|
To mount the monitor. |
|
|
(Behind attached base plate) |
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
Side View
Left View
Bottom View
Bottom View
Label Description
1AC power cord connector
2DVI connector
3VGA connector
Monitor Specifications
Flat Panel Specifications
Model |
Dell E1911 monitor |
|
|
|
|
Screen type |
Active matrix - TFT LCD |
|
|
|
|
Panel type |
TN |
|
|
|
|
Screen dimensions |
19 inches (19-inch viewable image size) |
|
|
|
|
Preset display area |
408.24 (H) X 255.15 (V) |
|
|
|
|
Horizontal |
408.24 mm (16.08 inches) |
|
|
|
|
Vertical |
255.15 mm (10.05 inches) |
|
|
|
|
Pixel pitch |
0.2835 mm |
|
|
|
|
Viewing angle |
160° (vertical) typical, 160° (horizontal) |
|
typical |
||
|
||
|
|
|
Luminance output |
250 cd/m² (typical) |
|
|
|
|
Contrast ratio |
1000 to 1 (typical) |
|
|
|
|
Faceplate coating |
Antiglare with hard-coating 3H |
|
|
|
|
Backlight |
CCFL (2) edgelight system |
|
|
|
|
Response Time |
5 ms typical |
|
|
|
|
Color depth |
16.7 millions colors |
|
|
|
|
Color Gamut |
80% CIE1976 (typical)* |
|
|
|
*[E1911] color gamut (typical) is based on CIE1976 (80%) and CIE1931 (72%) test standards.
Resolution Specifications
Model |
Dell E1911 monitor |
|
|
|
|
Horizontal scan range |
30 kHz to 83 kHz (automatic) |
|
|
|
|
Vertical scan range |
56 Hz to 75 Hz (automatic) |
|
|
|
|
Maximum preset resolution |
1440 X 900 at 60 Hz |
|
|
|
|
|
|
|
Supported Video Modes
Video display capabilities (DVI
480i/480p/576i/576p/720p/1080i/1080P (Supports
playback)
HDCP)
Preset Display Modes
Display Mode |
Horizontal Frequency |
Vertical Frequency |
Pixel Clock (MHz) |
Sync Polarity |
|
|
(kHz) |
(Hz) |
|
(Horizontal/Vertical) |
|
VESA, 720 x 400 |
31.5 |
70.1 |
28.3 |
-/+ |
|
VESA, 640 x 480 |
31.5 |
59.9 |
25.2 |
-/- |
|
VESA, 640 x 480 |
37.5 |
75.0 |
31.5 |
-/- |
|
VESA, 800 x 600 |
37.9 |
60.3 |
40.0 |
+/+ |
|
VESA, 800 x 600 |
46.9 |
75.0 |
49.5 |
+/+ |
|
VESA, 1024 x 768 |
48.4 |
60.0 |
65.0 |
-/- |
|
VESA, 1024 x 768 |
60.0 |
75.0 |
78.8 |
+/+ |
|
VESA, 1152 x 864 |
67.5 |
75.0 |
108.0 |
+/+ |
|
VESA, 1280 x 800 |
49.7 |
59.8 |
83.5 |
-/+ |
|
VESA, 1280 x 1024 |
64.0 |
60.0 |
108.0 |
+/+ |
|
VESA, 1280 x 1024 |
80.0 |
75.0 |
135.0 |
+/+ |
|
|
|
|
|
|
VESA, 1440 x 900 - Analog |
55.9 |
59.9 |
106.5 |
-/+ |
VESA, 1440 x 900 (CTV-R) - Digital |
55.5 |
59.9 |
88.8 |
+/- |
|
|
|
|
|
Electrical Specifications
Analog RGB, 0.7 Volts +/- 5%, positive polarity at 75 ohm input impedance
Video input signals Digital DVI-D TMDS, 600mV for each differential line, positive polarity at 50 ohm input impedance
Synchronization input signals
Separate horizontal and vertical synchronizations, polarity-free TTL level, SOG (Composite SYNC on green)
AC input
100 to 240 VAC/50 or 60 Hz + 3 Hz/1.5A (Max.)
voltage/frequency/current
120 V: 30 A (Max.)
Inrush current
240 V: 60 A (Max.)
Physical Characteristics
Model |
Dell E1911 monitor |
|
|
Connector type
15-pin D-subminiature, blue connector; DVI- D, white connector
Digital: Detachable, DVI-D, Solid pins, shipped detached from the monitor
Signal cable type
Analog: Detachable, D-Sub, 15pins, shipped attached to the monitor
Dimensions (with stand)
Height |
363.75 mm (14.32 inches) |
|
|
Width |
442.95 mm (17.44 inches) |
|
|
Depth |
155.75 mm (6.13 inches) |
|
|
Dimensions (without stand) |
|
|
|
Height |
289.45 mm (11.40 inches) |
|
|
Width |
442.95 mm (17.44 inches) |
|
|
Depth |
59.00 mm (2.32 inches) |
|
|
Stand dimensions |
|
|
|
Height |
125.3 mm (4.93 inches) |
|
|
Width |
249.86 mm (9.84 inches) |
|
|
|
|
Depth |
155.75 mm (6.13 inches) |
Weight |
|
|
|
Weight with packaging |
5.52 kg (12.17 lbs) |
|
Weight with stand assembly and
4.59 kg (10.12 lbs)
cables
Weight without stand assembly
(For wall mount or VESA mount 3.45 kg (7.60 lbs) considerations - no cables)
Weight of stand assembly |
0.70 kg (1.54 lbs) |
Environmental Characteristics
Temperature |
|
|
|
|
|
Operating |
0° to 50 °C (32° to 122 °F) |
|
|
|
|
Non-operating |
Storage: -20° to 60°C (-4° to 140°F) |
|
Shipping: -20° to 60°C (-4° to 140°F) |
||
|
||
|
|
|
Humidity |
|
|
|
|
|
Operating |
10% to 80% (non-condensing) |
|
|
|
|
Non-operating |
Storage: 5% to 90% (non-condensing) |
|
Shipping: 5% to 90% (non-condensing) |
||
|
||
|
|
|
Altitude |
|
|
|
|
|
Operating |
4,850 m (15,913 ft) max |
|
|
|
|
Non-operating |
12,192 m (40,000 ft) max |
|
|
|
|
|
85.3 BTU/hour (maximum) |
|
Thermal dissipation |
|
|
|
58.0 BTU/hour (typical) |
|
|
|
Power Management Modes
If you have VESA's DPM™ compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. referred to as Power Save Mode*. If the computer detects input from keyboard, mouse, or other input devices, the monitor automatically resumes functioning. Th following table shows the power consumption and signaling of this automatic power saving feature:
VESA Modes |
Horizontal Sync |
Vertical Sync |
Video |
Power Indicator |
Power Consumption |
Normal operation |
Active |
Active |
Active |
Blue |
25 W (maximum) |
Normal operation |
Active |
Active |
Active |
Blue |
17 W (typical) |
Back to Contents Page
Appendix
Dell™ E1911 monitor User's Guide
Safety Instructions
FCC Notice (U.S. Only) and Other Regulatory Information
Contacting Dell
WARNING: Safety Instructions
WARNING: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards, and/or mechanical hazards.
For information on safety instructions, see the Product Information Guide.
FCC Notices (U.S. Only) and Other Regulatory Information
For FCC notices and other regulatory information, see the regulatory compliance website located at www.dell.com\regulatory_compliance.
Contacting Dell
For customers in the United States, call 800-WWW-DELL (800-999-3355).
NOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill, or Dell product catalog.
Dell provides several online and telephone-based support and service options. Availability varies by country and product, and some services may not be available in your area. To contact Dell for sales, technical support, or customer service issues:
1.Visit support.dell.com.
2.Verify your country or region in the Choose A Country/Region drop-down menu at the bottom of the page.
3.Click Contact Us on the left side of the page.
4.Select the appropriate service or support link based on your need.
5.Choose the method of contacting Dell that is convenient for you.
Back to Contents Page
Back to Contents Page
Help on PowerNap Installation
To install PowerNap succesfully, follow these steps:-
1. |
Check Operating System Requirements |
Windows XP, Windows Vista®, Windows® 7 |
2. |
Install Entech API |
Install |
3. Install PowerNap Software |
Install |
|
|
|
|
Back to Contents Page
Loading...