The thermopile sensor consists of a series of 116 thermoelements, forming a sensitive region
size of 545μm (diameter). The sensor is hermetically sealed into a TO-5 metal housing, with an
optical filter. This standard filter allows measurements to be made in the spectral range above 5
m wavelength. The thermosensor exhibits an almost white noise, comparable to an ohmic
resistance. It has a constant signal versus frequency up to its frequency limit, and is directly
proportional to incident radiation. The thermopile sensors are featured with an additional
temperature reference resistor on the same chip. The standard version of temperature reference
resistor is housing connected to ground.
▓
Applications
* Ear thermometers; clinic thermometers
* Infrared thermometers
* Consumer applications: hair dryer, micro-wave oven, air conditioner, refrigerator
describes the resistance vs. temperature, where R25 is
the resistance at ambient temperature 25℃ and T, T25 are the ambient temperatures in unit of kelvin
degrees.
Transmission of optical filter is measured by FTIR from 2μm
Type : TP337A
▓
Package
The sensor is hermetically sealed into a TO-5 metal housing, with an optical filter. This standard
filter allows measurements to be made in the spectral range above 5μm wavelength. The
dimensions of header and cap are shown below.