Danby DPC042D1BSSPR Manual

0 (0)
OWNER’S USE AND CARE GUIDE
GUIDE D’UTILISATION ET SOIN DE PROPRI-
ÈTAIRE
DPC042D1BSSPR
CAUTION
Read and follow all safety rules and operating instructions before first use of this product.
Veuillez lire attentivement les consignes de sécurité et les instructions d’utilisation avant l’utilisation initiale de ce produit.
Danby Products Limited, Guelph, Ontario Canada N1H 6Z9
Danby Products Inc., Findlay, Ohio USA 45840
1-844-455-6097
s.01.
09.07.14
CONTENTS
TABLE DES MATIÈRES
PARTY CENTER
Owner’s Use and Care Guide...........................................................1-11
• Safety Instructions
• Installation Instructions
• Operating Instructions
Care and Maintenance
• Troubleshooting
• Warranty
LE CENTRE DU FÊTE
Guide d’utiliser et soin propriètaire..............................................12-22
Consignes de sécurité
• Consignes d’installation
• Consignes d’utilisation
Soins et entretien
• Dépannage
• Garantie
CAUTION:
Read and follow all safety rules and operating instructions before fi rst use of this product.
AVERTISSEMENT :
Veuillez lire attentivement les consignes de sécurité et les instructions d’utilisation avant l’utilisation initiale de ce produit.
Model • Modèle
DPC042D1BSSPR
Important Safety Information READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT WARNING
An empty party center is a very dangerous attraction to children. Remove either the gasket or lid from unused appliances, or take some other action that will guarantee it harmless.
DANGER: Risk of child entrapment. Before you throw away your old party center:
Take off doors.
Leave the shelves in place so that children may not easily climb in.
DON’T WAIT! DO IT NOW!
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the electrical current.
ELECTRICAL REQUIREMENTS
WARNING
ELECTRICAL RATING: The serial rating plate indicates the voltage and frequency the appliance is designed for.
Please ensure that component parts shall be replaced with like components and that servicing shall be done by factory authorized service personnel, so as to minimize the risk of possible ignition due to incorrect parts or improper service.
To avoid installation / operation diffi culties, read these instructions thoroughly.
This appliance must be grounded. Connect only to a properly grounded outlet. See “Grounding Instructions” section.
Do not operate this appliance if it has a damaged power cord or plug, if it is not working properly, or if the appliance has been damaged or dropped.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with fl ammable fl uids. The fumes can create a fi re hazard or explosion.
Do not store or use gasoline or any other fl ammable vapors or liquids in the vicinity of this or any other appliance. The fumes can create a fi re hazard or explosion.
Do not splice the power cord that is equipped with this appliance.
Keep power cord away from heated surfaces.
Do not immerse power cord, plug or the appliance itself in water.
Do not use this product near water for example, in a wet basement, near a swimming pool or near a sink.
Do not use corrosive chemicals or vapors in this appliance.
Use this appliance only for its intended use, as described in this manual.
Do not store perishable food items such as (but not limited to) meats and dairy products in your party center.
Store beverages in sealed containers only.
See door surface cleaning instructions in the Care and Maintenance section of this manual.
Do not cover or block any openings on the appliance.
This appliance is intended for household use only. Do not attempt to operate or store this appliance outdoors.
This appliance should be serviced only by qualifi ed service personnel. Contact the nearest authorized service facility for examination, repair or adjustment.
1
Important Safety Information READ AND FOLLOW ALL SAFETY INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current.
WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualifi ed electrician or service agent if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
If the outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.
For best operation, plug this appliance into its own electrical outlet to prevent fl ickering of lights, blowing of fuse or trip- ping of circuit breaker
DO NOT USE AN EXTENSION CORD Use an exclusive 115V wall outlet. Do not connect your unit to extension cords or together with an other appliance in the same wall outlet. Do not splice the cord. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Do not use and adapter plug with this appliance.
SAVE THESE INSTRUCTIONS!
Installation Instructions
FOR YOUR SAFETY
While performing installlations described in this section, gloves and goggles or safety glasses should be worn.
Remove interior and exterior packaging prior to installation.
Before connecting the appliance to a power source, let it stand upright for approximately 2 hours; this will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Place your party center on a fl oor that is strong enough to support it when it is fully loaded. To level your party center, adjust the front leveling leg at the bottom of the party center.
Locate the party center away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit to perform improperly.
Avoid locating the unit in moist areas.
Plug the party center into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certifi ed electrician or an authorized service centre.
Do not cover shelves with aluminum foil or any other material which may prevent air circulation.
2
Installation Instructions
LOCATION
The party center should be placed where the ambient temperature is between 4ºC-32°C (39°F-90°F). If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fl uctuate. The internal temperature range of 4°C-18°C (39°F-64°F) may not be reached.
NOTE: This unit is front breathing. Do not block the front air vent. Blockage of the vent will result in high operating temperatures and system failure. (Fig. B)
Fig.B
PREPARING THE ENCLOSURE
Tools you will need:
While performing installations described in this section, gloves and safety glasses or goggles should be worn.
Electrical Requirements:
The appliance must be connected to an individual, prop­erly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.
It is recommended that you do not install the party center into a corner (i.e. directly beside a wall). This is to allow the door to have a greater than 90° opening swing. A limited door swing may lead to damaging the door gasket.
The rough cabinet opening must be on a level fl oor area and at least 23 13/16” deep by 24” wide. The opening should also have a height of at least 34 3/4”.
The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig. A).
If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2” diameter hole to admit the pow­er cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.
Safety goggles
Gloves
Fig A
343/4” from
underside
of
countertop
to floor
Electric drill with hole bit
11/2”diam. hole
* If electrical out-
let is in adjacent
cabinetry.
Tape measure
Carpenter square
Flashlight
Level
23 13/16”
Cabinets
square
and
plumb
3
Operating Instructions
FEATURES
1. Twin Door Design: Divided compartments
allow for separate storage of different types of beverages. Soild stainless steel doors.
2. Dual Electronic Controls: For individually regulating the temperature for both compart­ments of the party center.
3. Magnetic Door Gaskets: Tight-fi tting seals retain all of the cooling power and humidity levels.
4. Wine and Beverage Shelves: Partially slide out for easy access to your beverages.
5. Ice Box
6. Ice Box Control Panel: Hidden behind a
stainless steel mock facing (not shown).
7. Front Mounted Exhaust: Allows for inte­grated applications.
8. Leveling Legs
9. Interior Lights (not shown): Illuminate the
compartment when the door is opened.
8
CONTROL PANEL
LEFT ZONE: • Wine Cellar Compartment
• Ice Maker Compartment
To operate the Ice maker compartment (lower left zone)
Button: Turns on the ice maker.
Button: Turns off the ice maker.
Indicator light: Shows the state of the ice maker, when the light is on, the ice maker is functional, and when the light is off the ice maker has ceased.
To operate the Wine storage control area to control wine temperature (upper left zone)
Button: Used to raise (warm) the temperatrue in 1° increments.
Button: Used to lower (cool) the temperature in 1° increments.
Display: Displays actual temperature / setting tem­perature for wine storage compartment.
RIGHT ZONE: • Beverage Compartment
Indicator light illuminates to signify the cooling mode is currently in operation.
Button: Used to raise (warm) the temperature in 1° increments.
Button: Used to lower (cool) the temperature in 1° increments.
Display: Displays the actual temperatrue / setting temperature for beverage zone.
4
Operating Instructions
SETTING THE TEMPERATURE
Each cooling compartment of your party center (left and right) is independently controlled. To set the temperature:
1. Connect the power cord to a properly grounded outlet. In the event of a power interruption, all previous temperature settings are automatically erased and each compartment will default to a preset temperature setting of:
7°C (45°F)- Wine storage zone (upper left) Not Working- Ice maker zone (lower left) 7°C (45°F)- Beverage zone (right)
Temperature set range: 4°C-18°C (39°F-64°F)- Wine storage zone (upper left) ON/OFF- Ice maker zone (lower left) 2°C-18°C (36°F-64°F)- Beverage zone (right)
2. When you set the temperature for wine storage zone (upper left) and beverage zone (right), push the UP and DOWN buttons to adjust setting temperature. Push UP or DOWN button one time, and the temperature will increase or re­duce by 1°.
3. When you start/shut off ice maker function, push the / button; the ice maker will commence operation upon pushing the ON button, when the light adjacent to the / buttons is illuminated, this indicates that the ice maker is operational. To turn the ice maker off, press the / button again and the light adjacent to the ON/OFF button will cease to illuminate-upon shutting off the ice maker.
4. To view the “cabinet temperature” at any time, press and hold the corresponding button for approximately 5 seconds; the “cabinet temperature” will temporarily fl ash in the LED display for 5 seconds:
Flashing LED= Cabinet temperature Steady LED= Set temperature.
FUNCTION INSTRUCTION
NOTE: If too many bottles / cans are put in at once or the door has not been closed tightly, the unit will display the “HI” signal in the display panel. This is normal, please wait 5 minutes after you close the door and “HI” should disappear.
It is normal that the cabinet shows “HI” or “LO” from time to time, if this occurs frequently or lasts for a long time, you can restart the unit by unplugging it. If the problem occurs once again after restart, please contact customer service.
Door Ajar Alarm Function
If the door is not closed completely the alarm will sound after 5 minutes. Please close the door completely to avoid the
loss of cold energy.
T emperature Alarm Function
If the inner temperature is higher than 23°C (73°F), “HI” is shown in the display panel, or the alarm will sound after
one hour. If the inner temperature is lower than -2°C (28°F) in the beverage compartment and 0°C (32°F) in the wine compartment, “LO” is shown in the display panel and the alarm will sound. Refer to the troubleshooting guide for more information.
5
Operating Instructions
SHELF INSTRUCTIONS
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 of the way out of the rail com­partment.
• To fi t or remove the shelf, tilt the shelf as per Fig. B, and simply pull out, or push in the shelf until it sits on the support brackets securely.
Fig. B
ICE MAKER INSTRUCTIONS
Pull out the ice maker box in order to remove ice easily.
NOTE:
If the unit is unplugged, power lost or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart this before the time delay, the party center will not start.
When you use the party center for the fi rst time or restart the party center after having been shut off for a long peri- od of time, there could be a few degrees variance between the temperature you select and the one indicated on the LED display. This is normal and it is due to the length of the activation time. Once the party center is running for a few hours everything will return to normal.
If the ice maker fails to produce ice, please check to see if ice cubes are stuck in the ice maker or check whether there is enough water going to the ice maker.
CONNECTING ICE MAKER TO WATER SUPPLY
WARNING
To avoid electric shock, which can cause death or serious injury, disconnect the party center from power before con­necting a water supply line to your party center.
CAUTION: To avoid property damage:
Copper tubing is recommended for the water supply line. Water supply tubing made of 1/4” plastic is not recommend­ed since it greatly increases the potential for water leaks. Manufacturer will not be responsible for any damage if plastic tubing is used for supply line.
• DO NOT install water supply tubing in areas where temperatures will fall below freezing.
Connect the ice maker to a water source that is not tied into a water softening system. Chemicals from the softener may damage the ice maker, causing it to malfunction.
IMPORTANT: Ensure that your water supply line connections comply with all local plumbing codes.
6
Loading...
+ 17 hidden pages