Page 1
DO GUIDE
TSW-750
7” Touch Screen
DO Install the Touch Screen
The Crestron® TSW-750 touch screen installs easily over
a standard 2-gang or 3-gang U.S. electrical box or over a
2-gang European electrical box. It can also be attached
directly to drywall and other surfaces over the front of a
2 3/8” (60 mm) high by 3 3/8” (86 mm) wide cutout. When
installed, the touch screen protrudes just 1/2” (13 mm)
from the mounting surface and is magnetically adhered
to its mounting bracket, eliminating any visible screws for
an ultra clean appearance.
NOTE: For proper positioning of the touch screen, the
electrical box or cutout must be positioned approximately
1/4” (6 mm) to the right of the touch screen’s center and
1/10” (3 mm) above its center.
To mount the TSW-750 into an electrical box, use the
following procedure:
1. Use four of the eight included screws (four
06-32 x 3/4” or four 3 x 16 mm screws) to attach the
mounting bracket to the electrical box, as shown in
the following illustrations.
NOTE: For U.S.-style installations, use a #2 Phillips
screwdriver. For European-style installations, use a
#1 Phillips screwdriver or equivalent.
DO Check the Box
QTY PRODUCT PART NUM.
1 Cable Mount Ferrite Bead 2033216
1 Metal Mounting Bracket 4516761
4 Screws, 06-32 x 3/4" 2033247
4 Screws, 3 x 16 mm 2013788
For U.S.-style installations, use the 06-32 x 3/4” screws.
U.S. Electrical Box
Screws (4) 06-32 x 3/4”
For European-style installations, use the 3 x 16 mm screws.
European Electrical Box
2. Make connections to the TSW-750 using Crestron
power supplies for Crestron equipment. Apply
power after all connections have been made.
NOTE: The included cable mount ferrite bead,
FBTH-2, should be placed on the LAN cable in the
electrical box.
3. Carefully hold the touch screen over the mounting
bracket and gently place it in position. The magnets
on the rear of the touch screen hold it in place on the
mounting bracket.
DO Connect the Device
Connect the TSW-750 to the LAN as shown in the
following illustration.
Reset Button
Screws (4) 3 x 16 mm
LAN PoE:
10BASE-T/100BASE-TX
Ethernet to LAN
Page 2
Access the Setup Screen
4
3
2
1
DO
NOTE: The TSW-750 can take up to 120 seconds to boot.
When power is applied for the rst time, the screen shown in
the following illustration appears.
Tap the Setup button to display the TSW-750 Setup screen.
The buttons on the Setup screen enable basic conguration
prior to regular operation of the TSW-750.
NOTE: During regular operation of the touch screen, there
are two ways to activate the setup functions:
1. Place a button on the project’s main page and assign the
reserved join number (17242) that activates setup.
2. Touch the hard keys labeled below as 1, 2, 3, and 4 in
sequence twice (touch 1, 2, 3, 4, 1, 2, 3, 4) within a ve
second period.
NOTE: For details on conguring the TSW-750, refer to
Doc. 7366 at www.crestron.com/manuals.
DO Learn More
Visit the website for additional information and the
latest rmware updates.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has b een tes ted and found to comply with specication s for CE marking.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rule s. Oper ation is subjec t to the following conditions:
(1) This devic e may not cause harmful inte rfer ence an d (2) this device must accept a ny inter feren ce rece ived, including interferenc e
that may cause undesired operation.
Caution: Chang es or mod icati ons not express ly approved by the ma nufacturer responsible for complia nce could void the u ser’s
author ity to operate the equipm ent.
Note: This equipment ha s been te sted and found to co mply wit h the limits for a Class B digit al devic e, purs uant to part 15 of the
FCC Rules. These limits are desig ned to provide rea sonable protection ag ainst harmful i nterference in a resid ential installation.
This equipmen t gener ates, us es and ca n radiate radio fr equen cy energy and, if not insta lled and used in accorda nce with the
instructions, may cause harmful interfere nce to radio communications. However, there is no guarantee that interferenc e will not
occur in a parti cular install ation.
DO GUIDE
If this equipmen t does ca use har mful interfer ence to radio or tel evision reception, whi ch can be determined by tur ning the
equipment off and on, the user is encouraged to tr y to correct the interfe rence by one or mor e of the foll owing measures:
• Reorient or relocate the receiving antenna
• Increase the se paration bet ween the equipment and receiver
• Connect the e quipment into an o utlet on a circuit different fro m that to whi ch the receiver is connected
• Consult the dealer or an exper ience d radio/ TV technician for help
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
Crestr on product d evelopment s oftwa re is license d to Crest ron dealer s and Crest ron Serv ice Provid ers (CSP s) under a limit ed non-exclu sive, non-tr ansfera ble Soft ware Development Tools
License A greement. Cre stron produc t operating sys tem softwa re is licensed to C restron deale rs, CSPs, a nd end-users un der a separate En d-User Lice nse Agreement . Both of these A greements
can be found o n the Crestron web site at www.crestron.com/legal/sof tware_license_agreement.
The speci c patents that c over Crestron pro ducts are listed a t patents.crestron.com. Product w arranty can be f ound at www.crestron.com/warranty.
Crestr on and the Crest ron logo are eit her trademark s or registered t rademarks of C restron Elec tronics, Inc . in the United St ates and/or ot her countrie s. Other trade marks, regist ered trademar ks,
and trade na mes may be used in this d ocument to refer t o either the enti ties claiming the ma rks and names or the ir products. C restron discl aims any propriet ary interes t in the marks and nam es
of others . Crestron is not r esponsible for err ors in typogra phy or photography.
This docum ent was written by t he Technical Publicat ions departmen t at Crestron.
©2014 Crestron Electronics, Inc.
DOC. 772 9A (20 42637) 12.14
Specic ations subject to c hange without not ice.
Loading...