Crestron MP-B20, MP-B10 User Manual

4.3 (3)

Crestron MP-B10/20

Media Presentation Button Panel

Operations & Installation Guide

This document was prepared and written by the Technical Documentation department at:

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

1-888-CRESTRON

Regulatory Compliance

This product is Listed to applicable UL Standards and requirements by Underwriters Laboratories Inc.

As of the date of manufacture, the MP-B10/20 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling.

Federal Communications Commission (FCC) Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:

(1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help

Industry Canada (IC) Compliance Statement

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

All brand names, product names and trademarks are the property of their respective owners. ©2010 Crestron Electronics, Inc.

Crestron MP-B10/20

Media Presentation Button Panel

Contents

Media Presentation Button Panel: MP-B10/20

1

Introduction ...............................................................................................................................

1

Features and Functions................................................................................................

2

Applications.................................................................................................................

2

Specifications ..............................................................................................................

3

Physical Description....................................................................................................

5

Setup ........................................................................................................................................

10

Network Wiring.........................................................................................................

10

Identity Code .............................................................................................................

10

Supplied Hardware ....................................................................................................

11

Installation.................................................................................................................

11

Hardware Hookup .....................................................................................................

15

Programming Software............................................................................................................

16

Earliest Version Software Requirements for the PC .................................................

16

Programming with Crestron SystemBuilder..............................................................

16

Programming with SIMPL Windows ........................................................................

16

Pushbutton Programming ..........................................................................................

20

Example Program ......................................................................................................

20

Uploading and Upgrading........................................................................................................

21

Establishing Communication.....................................................................................

21

Programs and Firmware ............................................................................................

22

Program Checks ........................................................................................................

23

Problem Solving ......................................................................................................................

24

Troubleshooting.........................................................................................................

24

Check Network Wiring..............................................................................................

25

Reference Documents................................................................................................

26

Further Inquiries ........................................................................................................

26

Future Updates ..........................................................................................................

26

Return and Warranty Policies ..................................................................................................

27

Merchandise Returns / Repair Service ......................................................................

27

CRESTRON Limited Warranty.................................................................................

27

Operations & Installation Guide – DOC. 6702C

Contents i

Crestron MP-B10/20

Media Presentation Button Panel

Media Presentation Button Panel:

MP-B10/20

Introduction

The MP-B10 and MP-B20 are enhanced pushbutton control panels designed for installation in a wall or podium. For simplicity within this guide, these control panels are referred to as MP-B10/20 except where noted.

The MP-B10/20 is ideal for expanding a Crestron® MPC Media Presentation Controller™ or as a cost effective user interface for an MPS Multimedia Presentation System or any other Crestron system. Available in white or black, the MP-B10/20 is constructed to handle the rigors of everyday use in a typical classroom, meeting room, lecture hall or training facility.

Its “hard key” buttons (10 on the MP-B10, 15 on the MP-B20) can be freely programmed for any function such as system power, input source selection, transport control and lighting presets. Custom backlit labeling of the buttons is facilitated using an assortment of pre-printed labels or Crestron Engraver software. The 5-way directional navigation pad (MP-B20 only) enables full control of DVD players, displays and other devices that utilize an onscreen menu. Adjusting audio volume and other parameters is enabled using the continuous turn control knob and LED bar graph.

A built-in IR receiver provides a gateway for Crestron IR wireless touchpanels and handheld remotes. A light sensor is also included, programmable for controlling the MP-B10/20’s backlight intensity or for providing ambient light level data to the control system for other applications. The MP-B10/20 may be powered through the network wiring using either Cresnet® or PoE (Power over Ethernet), requiring just one wire for operation.

Operations & Installation Guide – DOC. 6702C

Media Presentation Button Panel: MP-B10/20 1

Crestron MP-B20, MP-B10 User Manual

Media Presentation Button Panel

Crestron MP-B10/20

Features and Functions

Wall mount pushbutton control panel

Programmable buttons with LED feedback (10 on MP-B10, 15 on MP-B20)

Customizable backlit button labels

5-way navigation pad (MP-B20 only)

Volume control knob and LED bar graph

Built-in IR receiver and light sensor

Cresnet® and 10/100 Ethernet

802.3af Power over Ethernet compatible

Rugged construction

3-gang wall mountable

Applications

The following diagram shows a MP-B10/20 in a lecture hall application.

MP-B10/20 in a Lecture Hall Application (MP-B10 Shown)

2 Media Presentation Button Panel: MP-B10/20

Operations & Installation Guide – DOC. 6702C

Crestron MP-B10/20

Media Presentation Button Panel

Specifications

Specifications for the MP-B10/20 are listed in the following table.

MP-B10/20 Specifications

SPECIFICATION

DETAILS

 

 

Ethernet

IR Receiver

Reception Frequency

Formats

Range

Power Requirements Cresnet Power Usage Power over Ethernet1

Default Net ID

Minimum 2-Series Control

System Update File2, 3

Environmental

Temperature

Humidity

Heat Dissipation

Enclosure

Faceplate

Chassis

Mounting

Dimensions

Height

Width

Depth

Weight

MP-B10

MP-B20

Available Models

MP-B10-B-T

MP-B10-W-T

10BASE-T/100BASE-TX, static IP or DHCP, DNS, full duplex, auto-switching, auto-negotiating, auto-discovery, TCP/IP, UPD/IP, CIP, IEEE 802.3u and 802.3af compliant

36 to 38 kHz IR Crestron format, RC5

Up to 50 feet (15 meters) line of sight (typical), dependent upon angle, obstructions, IR interference and IR remote signal strength

4 W (0.17 A @ 24 VDC)

IEEE 802.3af Class 2 PoE powered device

03

Version 4.000.0251 or later

32º to 104º F (0º to 40º C)

10% to 90% RH (non-condensing)

14 BTU/Hr

High impact plastic, black or white with polycarbonate label overlay

Injection molded plastic with steel mounting plate

Requires 3-gang plaster ring or electrical box, ≥ 2 in (51 mm) deep recommended

4.50 in (115 mm)

6.70 in (171 mm)

2.23 in (57 mm)

17 oz (475 g)

17 oz (467 g)

Media Presentation Button Panel B10, black textured (with 10 buttons)

Media Presentation Button Panel B10, white textured (with 10 buttons)

(Continued on following page)

Operations & Installation Guide – DOC. 6702C

Media Presentation Button Panel: MP-B10/20 3

Media Presentation Button Panel

Crestron MP-B10/20

 

 

MP-B10/20 Specifications (Continued)

 

 

 

 

 

 

 

SPECIFICATION

DETAILS

 

 

 

 

 

 

Available Models (Continued)

 

 

 

MP-B20-B-T

Media Presentation Button Panel B20,

 

 

 

black textured (with 15 buttons and

 

 

 

5-way navigation pad)

 

 

MP-B20-W-T

Media Presentation Button Panel B20,

 

 

 

white textured (with 15 buttons and

 

 

 

5-way navigation pad)

 

 

Available Accessories

 

 

 

MP/MPC/IPAC_FRONT-LABEL-

Set of custom engravable backlit labels,

 

 

(BLANK, ENGRAVED)-B-T

white on black

 

 

MP/MPC/IPAC_FRONT-LABEL-

Set of custom engravable backlit labels,

 

 

(BLANK, ENGRAVED)-W-T

black on white

 

1.If both PoE and Cresnet power are connected, power will be drawn from Cresnet.

2.The latest software versions can be obtained from the Crestron website. Refer to the NOTE following these footnotes.

3.Crestron 2-Series control systems include the AV2 and PRO2. Consult the latest Crestron Product Catalog for a complete list of 2-Series control systems.

NOTE: Crestron software and any files on the website are for authorized Crestron dealers and Crestron Authorized Independent Programmers (CAIP) only. New users may be required to register to obtain access to certain areas of the site (including the FTP site).

4 Media Presentation Button Panel: MP-B10/20

Operations & Installation Guide – DOC. 6702C

Crestron MP-B10/20

Media Presentation Button Panel

Physical Description

This section provides information on the connections, controls and indicators available on your MP-B10/20.

MP-B10 Physical View (Front)

MP-B10 Physical View (Rear)

Operations & Installation Guide – DOC. 6702C

Media Presentation Button Panel: MP-B10/20 5

Media Presentation Button Panel

Crestron MP-B10/20

MP-B20 Physical View (Front)

 

MP-B20 Physical View (Rear)

6 Media Presentation Button Panel: MP-B10/20

Operations & Installation Guide – DOC. 6702C

Loading...
+ 22 hidden pages