Honda CBR-954
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the ins taller may be required to
set up components and to route lines in the ?best way pos s ible?, which may not always be lis ted on this ?Bike
Specific? ins tallation sheet. In any case, the ins tallation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without dam aging any part of the motorcycle
Important Installation Considerations
Positions are limited due to fairing restrictions.
Special Kit Re quirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Cyclops Clamps - Flipping the clamps upside down from what is in the
instruction book, may offer more convertibility and better fitment.
Restrictions
1. Fairing side pieces or intake ducts interfere with the riser when rotating the
Cyclops Clamps. Raising the handlebar so the riser is above the fairing side
pieces before rotating the Cyclops clamps will solve this restriction. Trimming
the fairing side pieces could also increase convertibility.
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and re place ment lines
1. Honda CBR954 (all years) Stock+50mm length Clutch Line (Part Number 07-
0800. Order from ConvertiBARS
2. Honda CBR954 (all years) Stock+75mm length Throttle Lines(Part Number 071018, 07-1019. Order from ConvertiBARS
3. Hydraulic Brake Line Top Fitting - 90 degree face to the side
4. Hydraulic Brake Line = Stock + 3"
5. Horn wire extension
Loading...